Table of Contents
Your Mower Won’t Start: Other possible causes include: Loose, Dirty or Disconnected Spark Plug in Your Lawn Mower: Check it out, clean off debris, re-connect and tighten. Dirty Air Filter: Clean or replace. Fuel Not Reaching the Engine: Tap the side of the carburetor to help the flow of gas.
What do you do when your lawn mower won’t start?
If you run into problems getting your lawnmower ready for spring, try the following: Use fresh gas. Old gasoline can cause starting difficulties. Check the spark plug. Use the choke. Prime the mower. Check the air filter. Check the cables. Check for water in the fuel tank. Clear the starter cord of blockages.
What would cause a riding lawn mower not to start?
There are many reasons a riding lawn mower won’t start—everything from stale gas to ignition switch problems. If you constantly have to charge the battery, a bad battery or failed alternator could be causing the problem. Lawn mower ignition switch problems can prevent the starter from getting current.
Why is it so hard to start my lawn mower?
The fuel filter might be clogged. A clogged fuel filter is most commonly caused by leaving old fuel in the lawn mower. Over time, some of the ingredients in the fuel may evaporate, leaving behind a thicker, stickier substance. This sticky fuel can clog up the fuel filter and make the engine hard to start.
How do you start a lawn mower when its cold?
How to Start a Cold Lawn Mower Brush the tip of the spark plug with the wire brush to remove any carbon and oil debris. Spray the tip with starter fluid. Press the primer button near the air filter cover three times with you thumb. Take your thumb off and allow the primer button to raise back out. Start your lawn mower.
How do you start a choke lawn mower?
Open the choke all the way if you notice that it has been closed. If it has been open, the carburetor may be flooded. Close the choke, and pull the starting cord a few times. When you get the engine to sputter, open the choke, and try starting the mower.
Can a dirty air filter cause a lawn mower not to start?
Your lawn mower’s air filter guards the carburetor and engine from debris like grass clippings and dirt. When the air filter becomes clogged or too dirty, it can prevent the engine from starting.
Can you jump a lawnmower with a car?
You can jump the mower with the battery in your car or with a portable jump-starter, but you can only use your car battery if your mower has a 12-volt battery. If your mower has a 6-volt battery, and you don’t have a 6-volt jump-starter, your options are to trickle-charge the battery or to buy a new one.
Will a bad spark plug cause a lawn mower not to start?
A dirty or fouled spark plug can cause your lawn mower to not start. It can also work itself loose, causing issues. If the spark plug appears to be seated correctly but the engine doesn’t start, a new one may be in order. For a few dollars, this easy fix can get your small engine working again.
Why does my lawn mower start but not stay running?
A full gas tank and oil reservoir are the essential first steps when checking why the lawn mower won’t stay running, but the problem could also be a dirty filter, clogged carburetor, improper fuel mixture, or a dirty spark plug. However, you may need a lawn mower specialist to get you back to trimming your grass.
How do you prime a lawn mower?
How to Prime a Lawnmower Carburetor Remove the cap from the lawnmower fuel tank. Fill the tank with gasoline and replace the cap. Locate the primer bulb on the side of the lawnmower engine. Press and release the primer bulb three times with your finger to prime the lawnmower carburetor.
How do you prime a lawn mower without a primer bulb?
In order to start your mower without a primer, squirt starter fluid directly into the carburetor via the air intake. Simply remove the air filter cover, take out the air filter, and squirt starting fluid into the air intake nozzle. Quickly replace the air filter, and start your mower. It should start straight away.
How do you start a lawn mower with old gas?
You need to run a siphon hose from the gas tank to another container in which you are going to keep the gas. Then, you just have to pump it a few times and let the gas travel from the tank to the container.
Where do you spray starter fluid in a lawn mower?
Spray a light dose of starter fluid directly into the carburetor chamber of your mower. Set the engine speed to the midpoint, if the idle is adjustable, by hand. Set the engine choke to full choke, if equipped.
How do you clean a lawn mower carburetor without removing it?
How To Clean A Carburetor On A Lawn Mower Without Removing It 5.1 Step 1: Turn off the lawnmower. 5.2 Step 2: Do an initial check-up. 5.3 Step 3: Remove air filter then clean it. 5.4 Step 4: Closely look at the insides with a flashlight or a headlamp. 5.5 Step 5: Look at the connecting wires in the carburetor.
Why won’t my mower start when its cold?
Keeping your mower clean will also go a long way toward helping your mower start in cold weather. Clean the spark plug with a brush to remove any carbon or oil debris. If your lawn mower won’t start and the gas inside is from last fall, try changing the gas. Finally, another handy tip is to warm up the carburetor.
