Table of Contents
In Alabama there are 4 types of professionally licensed persons that are legally allowed to conduct a percolation test: engineers, land surveyors, professional soil classifiers, and professional geologists.
Who does perc test in Mobile Alabama?
Though it can vary by jurisdiction, typically the test is performed during a meeting between a representative from the county health department and the property owner and/or someone who is a licensed excavator and is able to dig the hole and test the soil’s drainage rate.
How do I make my own perc test?
Soil Percolation Test Step 1: Dig Hole. Dig a hole at least 12” in diameter by 12” deep, with straight sides. Step 2: Fill Hole with Water. Fill the hole with water, and let it sit overnight. Step 3: Refill Hole with Water. Step 4: Measure Water Level. Step 5: Measure Drainage Every Hour.
How do you find a PERC?
A perc test tests the rate at which water drains through the soil. A perc test is conducted by drilling or digging a hole (or multiple holes) in the ground, pouring water into the hole, and then observing the rate at which water percolates, or is absorbed in the soil.
How much does a perk test cost in Alabama?
Perc testing typically costs $750 to $1,850 or $1,300 on average. On the high end, you might pay as much as $3,000 depending on local regulation and the size of the leach field or infiltration basin needed. A basic assessment costs $150 to $300 for a hand dug hole without specialized equipment.
Can I do my own perc test in Alabama?
In Alabama there are 4 types of professionally licensed persons that are legally allowed to conduct a percolation test: engineers, land surveyors, professional soil classifiers, and professional geologists. When soils do not percolate quickly or fully, then landowners must have an engineered system.
How do you perk a property?
In most jurisdictions, a perc test is performed when an official from the county health department meets with the owner of the property and/or a licensed excavator to dig a hole and test the drainage rate of the soil on-site (they literally pour water in a hole and time how long it takes to drain through).
How do I test my soil for drainage?
To determine your soil drainage, dig a hole about 12 inches deep and 8 to 12 inches wide. Fill the hole with water. Allow it to drain, refill it 12 hours later, and time how long it takes for the water to drain. If the soil drains well, all the water should be gone in 2 to 3 hours.
What is a good perc rate?
A good perc rate for a septic system is between 1 and 30 minutes per inch. Between 30 and 60 minutes per inch might require hydraulic analysis for installing a septic system. Anything under 1 minute per inch or over 60 minutes per inch is not an ideal perc rate.
How much does a septic system cost?
On average, the cost of installing a new septic tank system is $3,900. The price ranges from $1,500 to $5,000 for a typical 1,250-gallon tank, which is an ideal size for a three- or four-bedroom home. This cost is inclusive of the tank itself, which costs $600 to $2,100 or more, depending on the type.
What does it mean if land doesn’t perk?
NO PERC, NO HOUSE On rural sites without municipal sewage systems, a failed perc test means that no house can be built – which is why you should make any offer to purchase land contingent on the site passing the soil and perc tests.
Can I install my own septic tank in Alabama?
Alabama state law requires home- owners to get a permit from the local health department before putting in a new system or before repairing an existing system. Alabama state law requires septic tank installers and pumpers to be licensed by the Alabama Onsite Wastewater Board.
How much does it cost to pump a septic tank in Alabama?
It will cost between $350 and $550 to have your septic tank pumped.
What is the purpose of a perc test?
Perc tests determine the right and wrong locations for a septic system, and they’re often required by local jurisdictions before a new one can be built or an old one replaced. That’s because septic tanks work by holding wastewater long enough to naturally separate liquids and solids.
Are septic tank locations public record?
Contact your local health department for public records. These permits should come with a diagram of the location where the septic system is buried. Depending on the age of your septic system, you may be able to find information regarding the location of your septic system by making a public records request.
What happens if you fail a percolation test?
Failing the percolation test If you still fail after that, you’d either have to discharge very well treated water to a watercourse (only an option in NI) or avail of a ‘zero discharge’ system (constructed wetlands that do not require emptying).
How does a septic tank work?
The septic tank is a buried, water-tight container usually made of concrete, fiberglass, or polyethylene. Its job is to hold the wastewater long enough to allow solids to settle down to the bottom forming sludge, while the oil and grease floats to the top as scum.
How long is a perc test good for in Georgia?
Test results are usually good for two to five years, and in some cases can be renewed. However, with all things perc, rules vary greatly from town to town so don’t make any assumptions. Always check with the town health department before proceeding.
