Table of Contents
Where is the best place to put a water softener?
In most cases, water softeners are placed in a home’s basement or garage, away from your living space. For homes without a basement, the next best place is near the water heater—again, not exactly a main focus of the home.
Where does a water softener need to drain?
Most water softeners require two drain tubes. One of the drain tubes connects to the control valve and is used to void the backwash water during the regeneration cycle. The other drain tube connects to the brine tank and serves as an overflow drain.
Can I install water softener in garage?
For homes without basements or crawl spaces, a garage is another great option for water softener installation. Typically, a garage provides plenty of space and storing softener salt is more convenient than hauling it in the basement.
Can a water softener be placed outside?
While most water softeners and filters are able to be installed outside, the combination of sun, wind and rain is not conducive to longevity. We recommend that if you are installing a water softener or other treatment product, that you protect it from the elements as much as possible.
Can water softener be installed in attic?
If you live in an area with hard water, you need a water softener. A water softener is typically installed next to your water heater, which is usually in your garage or attic. A water softener can be installed outside, preferably in a covered area.
Is it OK to drink softened water?
Softened water is considered safe to drink in the majority of cases. In softened water, the sodium level increases. Sodium is not the same as salt (sodium chloride). The Drinking Water Inspectorate (DWI) says that water with a sodium content of up to 200ppm is safe to drink.
Can I install a water softener without a drain?
Generally as long as you have any type of drain close by (sink, etc) you can install a typical water softener. HOWEVER there is a new type of water softener that does not require salt or regeneration — and thus should not need a drain at all!.
Can water softener drain into septic?
These studies conclusively show that water softener waste effluents cause no problems for septic tanks. the volume of waste from a water softener that is added to the septic tank is not of sufficient volume to cause any deleterious hydraulic load problems.
How much water is wasted with a water softener?
Waste: The average salt water softener wastes approximately 150 gallons of water every week, amounting to nearly 8,000 gallons per year.
Does a water softener ruin a water heater?
When a water softener system is installed, it removes the “hard” minerals and replaces them with “softer” ones such as sodium. Soft water can actually corrode the water heater anode faster. So if left alone, a water softener system can actually shorten the lifespan of a water heater.
How far can brine tank be from softener?
Location of softener drain and brine tank: Place the softener close to a clean working drain and connect according to local plumbing codes. The brine tank should be located within 20 feet of the water softener. The drain cannot be elevated more than 36 inches or exceed 20 feet in length.
Does a water softener go before or after the pressure tank?
Water softeners should always sit after the pressure tank. A water softener will fail to ensure a proper water flow because of small inlet pipes. It can also get clogged and fail to backwash. On the contrary, installing it after the pressure tank lets the pressure tank work properly.
How do I protect my outside water softener?
You can use a space heater to heat the area around the water softener and check on the area’s temperature during the coldest times. For extra protection, you can also insulate (winterize) your pipes and equipment with a specialized wrap.
Can GE water softener be installed outside?
Final Answer. To the question, “Can a water softener be installed outside,” the answer is yes. But understanding the strict requirements that come along with an outdoor installation is important. This is why these types of installations should be left entirely to a water treatment installation professional.
How do you drain an outside water softener?
How Can You Drain Your Water Softener Outside? The easiest way to drain your water softener backwash is to simply run it onto the ground, however, as there is a lot of salt in the backwash it can be very harmful to the ecosystem and the local water treatment facilities.
Can I fit a water softener in the loft?
Very often (but not always) this main is in the kitchen or utility room. Sometimes the main rises in a downstairs cloakroom, under the stairs, or in the garage. In most cases the softener can be sited in any of these locations as well as outside (with a suitable frost protection cabinet) or even in the loft space.
