Table of Contents
The secondary air injection pump is usually located on the engine or at least in the engine bay. It can sometimes be hidden deep into the engine bay, but mostly you will find it installed pretty visible on the engine.
What are the symptoms of a bad secondary air pump?
5 Symptoms of a Bad Secondary Air Injection Pump Check Engine Light. Failed Emissions Test. Weak Acceleration. Engine Stalling. Low Idle.
How do you fix a secondary air injection?
How to Fix Replace both the air pumps and the one-way check valve. Try and clean the air pump and test it. The one-way air check valve must be replaced as well. Replace the inlet hose of the air pump. Replace the fuse of the air pump (you can find it under the hood).
Can you drive without secondary air pump?
You will be fine driving to work in the morning. You will get or already have a CEL for hose being disconnected. The pump only runs for a minute or so on cold start to help burn exhaust gases and heat up the O2 sensor. The reason for the brown color is most likely due to rust from condensation in the pump.
How do I know if my secondary air pump is working?
The secondary air pump has to start audibly after a cold start of the engine. Start vehicle engine. If the power supply of the secondary air pump is fine, but the secondary air pump runs with a scraping, whistling or scratching noise or not at all, the secondary air pump is to be replaced.
Can you drive with a bad air pump check valve?
You will not notice anything significant in the way of vehicle performance, and you can continue to drive with a bad air pump check valve.
Can a bad secondary air pump cause a misfire?
A faulty MAF sensor will cause your secondary air pump not to switch on. this can cause a rich condition, which can cause misfires, etcMay 26, 2006.
What does a bad air pump sound like?
A bad air pump can make a howling noise. You should hear a faint vacuum-cleaner sound for about 30 seconds as your air pump operates. The lack of this noise can indicate that the pump is not working.
What causes a secondary air injection system malfunction?
CAUSES OF A FAILURE: CAUSE OF FAILURE Faulty ground and voltage supply can also cause the pump to fail. Blocked or leaking lines can also cause the failure or malfunction of the control or combination valve, resulting in the failure of the secondary air system.
How do you test a secondary air injection?
The secondary air valve can be quickly inspected in an easy way: Loosen the connecting hose on the secondary air non-return valve leading to the secondary air pump. If there are deposits on this side of the valve (finger test, see Fig. Inspect the secondary air pump and replace it if necessary.
How do you test a smog pump?
You just take the outlet hose off the rail and check if it is pumping air. If the pump is off the truck, you just spin the pulley and see if air comes out the outlet.
What does secondary air injection check valve do?
The secondary air injection system is an emissions system equipped on many road going vehicles. The air pump check valve is the valve that allows air supplied from the air pump to be pumped into the exhaust stream to reduce hydrocarbon and carbon monoxide tailpipe emissions.
What does a secondary air injection valve do?
Secondary-air valves are fitted between the secondary-air pump and the exhaust manifold. Use is made of different versions. The secondary-air non-return valve stops exhaust gas, condensate or pressure peaks in the exhaust system (e.g. misfiring) causing damage to the secondary-air pump.
Will a car run without a smog pump?
So, the law says you need a secondary air injection system. Which begs the question: Does a car need a secondary air injection system to run? Strictly speaking, no, it doesn’t.
Can I drive my car with a P0410 code?
You may drive your vehicle with a P0410 however keep in mind your vehicle will not pass a smog inspection. Problems with the air injection system will not cause any driveability symptoms. The check engine light or malfunction indicator lamp will be illuminated as long as a P0410 is recorded in the ECC.
How much is a smog pump?
New smog pumps might cost you somewhere between $150-300, but there’s good news. Try saving money on these parts by going with a high-quality refurbished or rebuilt option. If you go this route, you might expect to pay as little as half the price of a new part.
How do I know if I have a bad check valve?
Symptoms of a Failing Check Valve For example, failing check valves will start to vibrate and even lose some internal parts when problems begin to arise. Other symptoms of check valve failure include reverse flow and excessive component wear and damage. Check valves will also emit noises as they start to break down.
What does a Mercedes secondary air pump do?
The system works by using an air pump to inject fresh air into the cylinders to lean out the rich fuel mixture that occurs during engine startup. This increases combustion temperatures, which in turn decreases catalyst warm up time, thus ensuring cleaner emissions during a cold start.
What does P0411 code mean?
Trouble code P0411 is a generic OBD-II DTC (digital trouble code) which indicates a problem with your vehicle’s secondary air injection system. DTC P0411 indicates the engine control unit (ECU) has detected an air flow problem within the secondary air injection system.
Can you remove a smog pump?
Also the pump can make noise after time and they just look plain ugly and take up a lot of room. So for many people the best solution is to just remove it. If you decide to go this route there is one important thing you need to consider.
Why air pump is used in aquarium?
To maintain the right oxygen supply in your fish tank, it is important to install a good aquarium pump underwater that will regulate the flow of air. You can even cover these pumps with decorative pieces to make your aquarium look beautiful.