Table of Contents
It’s located inside the dash, often on the opposite side of the steering wheel or inside the engine compartment on the firewall. A blower motor resistor or a blower motor control module is the part that controls the speed of the blower motor.
How do I change the blower motor resistor?
How to Replace a Blower Motor Resistor Step 1: Remove the glove box door, if necessary. Step 2: Disconnect the wiring harness and remove screws. Step 3: Remove and replace the blower motor resistor. Step 4: Tighten screws and reattach wiring harness. Step 5: Reinstall the glove box door.
Where is the heater blower fan resistor?
The heater blower motor resistor is often found beneath the dashboard. It is located in the heater and air conditioning compartment. It’s connected to the air conditioning system, where it can adjust the speed of the blower motor fan. It can also be found behind the glove box of some vehicles.
Where is the blower motor resistance?
It’s usually found inside the dash, on the opposite side of the steering wheel, or on the firewall inside the engine compartment. A blower motor resistor, also known as a blower motor control module, is the component that regulates the speed of the blower motor.
Can you drive without a blower motor resistor?
except blower motor resistors don’t “wear out”; they stop working altogether, suddenly, when the resistance wire inside burns through. Even then, it’s safe to drive the car provided that it has no exhaust leaks which might permit carbon monoxide or oxides of nitrogen to enter the passenger compartment.
What causes blower motor resistor failure?
In most cases, a blower motor resistor fails due to corrosion or overheating. Sometimes, the mechanical resistance to the motor rotation causes an excessive electric current that can overheat and prematurely damage the blower motor resistor.
How do you test a blower motor resistor?
Place one lead of the Ohmmeter on terminal 1 of the resistor. Place the other lead on terminal 2 and check against specifications. If this circuit is open, showing infinity on the Ohmmeter, the blower resistor must be replaced. Move the lead from terminal 2 to terminal 3 and check this reading against specifications.
What happens when blower motor resistor goes bad?
If the resistor shorts or fails, it may cause the blower motor to remain stuck on one fan speed. The heating and air conditioning systems may still function at one speed, however the resistor will have to be replaced in order for full functionality to be restored.
Why does my blower motor resistor keeps melting?
Trent, one of the biggest reasons for blower motor resistors to have shorten life is actually because of faulty blower motor drawing too many amps, some times melting wires/plugs, heating up resistors shortening their life. Many Dodge forums tell of this problem.
What is blower resistor?
The blower motor resistor is responsible for controlling the blower motor speed. The change in resistance controls the current through the blower motor, which in turn limits the speed that the blower motor spins at.
How are the resistors connected in a blower motor circuit?
The blower resistor is connected in series with the blower fan. This means that the current running through the blower motor, and thus its speed, is controlled by the resistor value. The user chooses a suitable fan speed by using a selector to connect one of the resistors in the blower resistor pack.
How much does it cost to replace a motor blower?
Replacing a blower motor costs $450 on average with a typical range of $250 to $800. With a warranty, you might pay as little as $150 for labor alone. For high-end models, like those with large motors or access issues, you might pay as much as $2,000.
Can a car run without a blower motor?
Your car’s blower motor is not only necessary for the operation of your air conditioner. Without a functioning blower motor your engine runs the risk of overheating. Start car and see if blower motor works. If fuse blows again, check for loose circuits.
How long does a blower motor last in a car?
For the most part, the heater blower motor on your car is supposed to last as long as the actual vehicle does. Due to the harsh conditions that this blower motor has to operate in, it will usually end up having repair issues. There are a variety of problems that the blower motor may have that will render it useless.
How can I tell if my blower motor resistor is bad?
If the airflow from the vents is weak… If you try to increase the air pressure and you feel no difference in the pressure blowing, then your blower motor resistor may be failing. A damaged blower motor resistor will work on one fan speed which may not be enough to keep the inside of your car cool or warm enough.
Is there a fuse for the blower motor?
Many vehicles have two fuses for the blower motor, one in the interior fuse block and the other under the hood. The blower motor is usually under the dashboard on the passenger side.
How do I know if I need a blower motor or a resistor?
Typically, if the fan will work on some speeds but not on others, the resistor is suspect. Okay, let’s say there’s no melting going on, but your fan doesn’t work on all speeds. Typically, if the fan will work on some speeds but not on others, the resistor is suspect.
Is there a fuse for the heater blower?
The blower motor is powered by a fuse-like device called a relay. If your heater or air conditioner does not blow air through the vents, this could indicate that the blower motor fuse has probably blown. While replacement is easy, the exact location of your blower motor fuse may vary from vehicle to vehicle.
