Table of Contents
One of the hardest-working parts of your home’s furnace is the blower motor. In a gas forced air furnace, it’s located in a box at the base of the furnace next to the air filter, where it draws return air through the filter.
How do I know if my furnace blower motor is bad?
Signs of an Overheating Blower Motor A “hot” or burning smell from vents in the home. This symptom is often coupled with the furnace shutting off completely. Loud humming and other unusual noises. We have many homeowners call us mentioning humming and other odd sounds. Furnace cycles off and refuses to restart.
Is the blower motor in the furnace?
The blower motor is the component in a central HVAC system that consumes the most energy. If you already have a variable speed blower motor in your furnace, and the motor is not clogged with debris, the motor may be wearing down and approaching end of life.
How much does it cost to replace a furnace blower motor?
An HVAC blower motor replacement costs an average of $450 but anywhere from $150 to $2,000 to replace. It doesn’t matter if you have a gas furnace, electric or heat pump, they all use an air handler blower motor to push the air throughout your home’s ducts.
How do I test my furnace blower motor?
How To Check your Furnace Blower Motor (7 Steps) Step 1: Turn off all power to the furnace. Step 2: Remove the Furnace Access Panels. Step 3: Use your voltage tester to ensure no electricity is flowing through the furnace. Step 4: Feel the area near the blower motor to determine if it’s hot.
What happens when blower motor goes out?
You might also hear ongoing whirring noises, or noises that change or get louder if you increase the fan speed. These are all signs of problems with the blower motor. In some cases, you may even notice smoke or smells of burning while driving, in which case you should pull over immediately.
Do all furnace blower motors have a reset button?
All furnaces are equipped with a reset button. They are generally red or yellow and are located inside the blower compartment. The reset button is a safety feature that will shut down the furnace when a problem is detected, often a hot or overheating furnace, before it trips the circuit breaker.
How do you reset a furnace blower motor?
How to Find and Reset your Furnace Motor Blower Step 1: Turn off the power to the furnace. Step 2: Remove the blower compartment cover. Step 3: Make sure the blower is completely cooled off. Step 4: Locate the reset button. Step 5: Press the button in (assuming that this is your issue and that the button has popped).
Is it hard to replace a blower motor?
If you don’t want to sweat or shiver, then find a good mechanic. The replacement of the blower motor is common and straightforward, so most shops will perform the repair — many on the same day.
Why is my furnace not blowing hot air?
First, check to make sure the thermostat is set correctly. You will want to make sure that the fan control is set to auto, and not ‘on’. If the thermostat appears set correctly, turn off your heater at the thermostat and check the filter. If the filter is dirty, replace it.
Where is the blower fan?
The blower fan is located inside a horizontal air conditioning unit in many home air conditioning systems, especially when the air handler is located in an attic or crawl area.
How long does it take to change a blower motor?
It takes between 45 to 90 minutes for a HVAC specialist to: replace the blower motor, adjust it, clean the fan, test it and assemble the furnace back together. The biggest challenge if you’re doing it yourself is getting the assembly out.
How long does a furnace blower motor last?
The blower motor in your home or office should last anywhere from 10 to 20 years. Modern sealed bearings and sealed bushings can push the lifespan to its maximum of 20 years. Proper cleaning and maintenance can also extend your unit’s lifespan.
Can a furnace blower motor be repaired?
Standard blower motors operate at a single speed and cost around $450 to replace, including parts and labor, while variable-speed motors cost $600 and up. However, if your HVAC blower motor isn’t too badly damaged, the technician may be able to clean and repair it so you won’t have to incur the cost of a replacement.
What does blower motor reset button look like?
If you use central heat and air, the button is likely located in the air handler’s compartment on the blower motor, and it will be either red or yellow. It usually lays flush with the surface of the blower motor until triggered by the internal overload protection circuit.
What does a reset button look like on a furnace?
All furnaces are equipped with a reset button. They are generally red or yellow and are located inside the blower compartment. The reset button is a safety feature that will shut down the furnace when a problem is detected, often a hot or overheating furnace, before it trips the circuit breaker.
Where is the reset button?
Alternatively referred to as the reset switch, the reset button allows devices that utilize it, such as a computer or peripheral to be rebooted. Usually, the button is on the front of the device, next to or near the power button.
Can I replace a blower motor myself?
With our furnace blower replacement guide, you can do it yourself and save. The typical service call for a hvac technician to do this would cost several hundred dollars but you can save most of that money by doing it yourself.
