Table of Contents
The job of the freezer compressor is to take cold gas that is emitted from the freezer area of the larger unit and place it under pressure until the gas raises in temperature, after which it can be recycled through the refrigeration system to keep the unit cold inside.
What is the compressor side of an upright freezer?
When you get to the new location, set your freezer upright and allow it to sit for an equal amount of time as it did when it was on its side, though up to 24 hours is fine. The compressor, which is responsible for the freezing cycle, is normally found at the bottom of the chest freezer in the back.
What side of the fridge is the compressor on?
In the domestic refrigerator, you will find your compressor at the back of the appliance. The condenser cools the vaporized refrigerant turning it back to liquid. 3. Evaporator: The evaporator is the cooling component of the refrigeration system.
Can you lie a freezer down to transport it?
Keep the freezer in the upright position. If transporting it in an upright position is not possible, lay it down on the compressor side of the unit. Be careful to secure the door to prevent it from opening.
Which is the low side of a refrigerator compressor?
The suction side is also called as the low side as the suction pressure is lower than the discharge pressure. This basic understanding of how the refrigeration process works on your appliance will allow you to identify the suction side of the compressor.
What happens if you lay a freezer on its side?
You should never lay your fridge freezer down. When on its back or side, oil will flow into the cooling tubes, and it may not drain from them when the fridge moves back to an upright position. As a consequence, your fridge may stop cooling properly or break down completely.
Why should you not lay a freezer on its side?
When laid sideways, the oil can run off from the compressor to the cooling coils. Since the oil is thick and viscous, it can easily clog up the coils. This prevents the refrigerant gas from flowing through them and thus your refrigerator won’t cool.
Which is the suction side of a compressor?
The low side, or suction line, will be the line connected to the compressor from the top or higher position. It will be cold to the touch and may be wrapped with insulation. This is where freon enters the compressor as a gas.
What does a compressor do on a freezer?
The first freezer component it enters is the compressor (usually found in the lower back of the freezer). The compressor squeezes the vapor’s particles, which heats it up and converts it into a high-pressure state.
Where is the compressor on a chest freezer?
The compressor is one of the most essential working elements of a freezer. The compressor motor is responsible for creating the cold air that freezes your food. Located outside the freezer, the compressor is a football-sized case that sits behind the unit, toward the bottom.
Can fridges be transported on their side?
Refrigerators travel best standing up. Though not preferable, you can move your refrigerator laying on its side. Remember, your fridge needs to stand still for hours after the move. If transported on its side, this wait time goes up to twice the time that the appliance has laid on its side.
How long after moving a freezer can I turn it on?
If it was transported upright, give it at least an hour before you plug it in. If it was transported on its side, turn it the right way up and leave it for at least four hours.
Where is the suction side of a refrigerator compressor?
Locating the Refrigerator Compressor The valve between the condenser and the compressor is the outgoing valve. Once you know which valve is the outgoing valve, locate the other valve on the compressor. This is the suction valve, which should be attached to the evaporator.
Is the condenser on the high side?
HIGH SIDE – Same as head pressure; side of system which includes vapor into condenser and liquid to expansion valve. (Also see Low Side.).
How can I tell if my freezer is working?
Leave a thermometer in the freezer for 24 hours, then check the temperature reading on the thermometer and compare it to the temperature setting on your freezer. When it is not close to the same temperature, your freezer may not be working properly.
Is it OK to tip a chest freezer on its side?
When moving the freezer, do not tilt it more than a 45-degree angle. If tilted, it should be stood upright for an equal amount of time as it was tilted before plugging it in. If on its side for more than a day, leave standing for 24 hours before running.
How do you transport a deep freezer?
Moving Large Appliances: How To Move A Deep Freezer Step one: have a safe plan for the food you will be removing from the deep freezer. Step two: unplug, defrost and clean the deep freezer before moving day. Step three: tie it up and pad it. Step four: when moving a freezer, keep it upright if you can.
Why do you have to wait 24 hours to plug in a fridge?
Its because the compressor lubrication oil could get into the cylinder of the compressor and if not given plenty of time to drain back into the oil sump at the bottom of the compressor, could cause major compressor valve damage on start up. 2 or more hours is a good rule to observe.
Which is the suction line on a refrigerator?
The suction line is the part of the piping system of a ac/ref unit. After the refrigerant evaporates into a gas in the evaporator coil the section of piping from this coil to the condenser coil is called the suction line.
Where is the suction line located?
The suction line is to return gas to the compressor. It is between the evaporator and compressor on a standard cooling system and between the reversing valve and the compressor on a heat pump.
Which line is the suction line on a refrigerator?
The larger line typically carries a cool gas and is insulated. This is commonly referred to as the suction line, but it is also called the return line or vapor line. The smaller uninsulated line typically carries a warm liquid.
