Table of Contents
Positioning your niche at chest to eye-level is a good standard. This translates to a height of about 48 to 60 inches. Ideally, you’ll want to position your niche to fit between the studs which are usually located 16 inches apart.
How high should a shower niche be from the floor?
The standard shower niche height is between 36″ and 40″ off the shower floor (to the base of the niche). The typical or standard shower niche height for tub/ showers is between 25″ and 30″ (to accommodate bathers).
What is the standard size of a shower niche?
Assuming that you are considering installing a prefab tile ready foam board shower niche, the most popular standard shower niche size is 12″ wide x 28″ high x 3-1/2″ deep.
How high should a shaving niche be?
Realistically, most people will want a shower niche to be between 36 to 60 inches (91 to 152cm) from the floor, which makes it a comfortable height to reach for a bottle of shampoo or a bar of soap.
How thick does a wall need to be for a shower niche?
Before we decide on which side to locate the niche, we need to check how thick the wall is. Any wall that is more than 8 inches wide will be able to have a niche in it. The standard depth can be anywhere ranging between 4 to 5 inches inside the wall.
Should a shower niche be centered?
For those who are symmetry conscious, the shower niche can be centered horizontally on the back wall adjacent to the shower head. Another option is to position two niches side by side, or even one below the other.
How do you waterproof a shower niche?
Waterproof Shower Niche To waterproof a tiled niche, apply waterproof backerboard to the inside surfaces of the niche. Next, apply waterproof membrane, bedding it in unmodified thinset. With the waterproofing complete, install the tile starting with the bottom of the niche, which should have a slight pitch for drainage.
How small is too small for a shower?
In general, a shower should measures at least 36 inches square. However, if your bath space is especially petite, 30 inches square is the absolute minimum space requirement for a shower.
What is shower niche?
A shower niche is an open storage space, like a cubbyhole, that is installed within the wall of your shower or tub area and is used to keep all your bathroom items nicely organized. Niches aren’t just for showers – they can also be installed in bathtub surrounds.
Where is the best place to put a shower niche?
For this reason, the wall opposite the shower head is the most popular place for shower niches. Regarding shower niche height – if it’s a regular stand up shower, a placement height above the waist (approximately 3 feet from the shower pan/base) would be most convenient for reach.
How deep should a shower ledge be?
Got upcoming visitors? Style your shower ledges with boutique bathroom products and a small pot plant for freshness. We recommend having your shower niche built at a height of 1100-1200mm high and a depth of 70-90mm. This should give you enough space for any required shower products.
What is a bathroom niche?
A shower niche is a built-in shelf that’s recessed into the wall of the shower to provide storage space for bathroom products. It allows you to keep your shower looking clean and organized, and provides a more luxurious appearance.
Do I need to waterproof shower walls before tiling?
Contrary to popular belief, ceramic tile and grout, by themselves are not waterproof. Water can penetrate through cement-based grout and work its way through the substrate. To prevent water damage, you must install a waterproof membrane just below the tile bonding mortar as close to the tile as possible.
Do I need to waterproof a shower niche?
Don’t Skip the Waterproofing This is an assumption made far too often when shower niches are framed into the shower wall. No matter how tight the joints may look in a newly constructed niche, they will not keep water from penetrating and running into the stud cavity if it is not properly waterproofed.
How much does it cost for a shower niche?
Prefabricated Tile Ready Shower Niche A very rough labor estimate of this service would be $250 – $350 (depending on type of tile and size of niche). Ad: The image above is an affiliate link. This is one of the most popular prefabricated / tile ready shower niche products available.
What is the smallest size for a walk in shower?
The smallest size for a walk in shower is recommended to be 36 inches by 36 inches, inclusive of a bench attached to a wall within the space. By sticking to the suggested minimum sizing of 36 by 36 inches, you’ll create a walk-in shower area that offers adequate room for comfortable, easy showering.
What is the smallest space for a shower room?
What’s the minimum size for a room with just a shower? The smallest tray size is around 700mm x 700mm, so your shower room will need to be at least just over 700mm wide. You need to allow room for the shower door to open, plus room for getting in and out. A workable minimum length would be around 1,500mm.
Is a 36 inch corner shower big enough?
Is a 36 Inch Corner Shower Big Enough? According to the ADA, the minimum size of a shower should be 36 by 36 inches. This site can allow a bench that is attached to one wall of the shower for sitting. Even if you forgo the bench, the size is still ideal for having a convenient and relaxing shower experience.
How do I choose a shower niche?
Positioning your niche at chest to eye-level is a good standard. This translates to a height of about 48 to 60 inches. Ideally, you’ll want to position your niche to fit between the studs which are usually located 16 inches apart. But many contractors can help you with planning the space for a more custom look.
How do shower niches work?
You may not even be sure exactly what a shower niche is. Put simply, it is a term used to describe a storage space that is installed within the wall of your bath or shower. It’s generally used to hold things like soap, shampoo, conditioner, etc. It can be a recessed rack or it can be finished and waterproof.
