Table of Contents
Starting the Vehicle Rev the engine to about 3,500-4,000ish RPM. Engage clutch, shift into First gear (First Low for tractors/semis) Let the clutch come slowly while giving a little bit gas. Shift into Second Gear as soon as you can after the car is moving successfully in First.
What are the controls for my summer car?
Car controls Steer left – Steers the vehicle left. Steer right – Steers the vehicle right. Throttle – Opens the throttle. Brake – Increases the hydraulic brake pressure. Clutch – Depresses the clutch. Handbrake – Increases the hand brake pressure. Shift up – Shifts the gears up by one.
Where do you put the drive gear in a summer car?
The drive gear It is attached to the gearbox with 7x6mm bolts.
How do you start off a summer car?
Go to the blue van parked outside. Get in to drive mode and pull off the parking break. Then while holding ignition pump the gas like morse code (short short long, short short long etc) and it will start after a while.
How do you swear in a summer car?
Just press the “swear” key !! :: My Summer Car General Discussions (Owners)Nov 4, 2016.
Where do you put a fuel strainer in a summer car?
The fuel strainer It is attached inside the engine bay with 1x8mm bolt.
Where do I put my starter in my summer car?
It is attached to the engine plate with 2x7mm bolts. Wiring the starter to the positive terminal of the battery makes a new 5mm nut appear which must also be secured. To wire the starter to the negative terminal, 7mm bolt farthest from the engine must be untightened first.
How do you change gears in a summer car?
after you start rolling release the clutch and give more gas. to change the gear release the gas and press the clutch fully shift the gear and release the clutch again after this give gas again. Shift into Second Gear as soon as you can after the car is moving successfully in First.
How can I save in my summer car?
In My Summer Car, there is no pause function, nor the ability to save the game at any time. The only place you can save the game is the toilets. Move your mouse over the toilet until you see SAVE and QUIT to MENU. After saving, you will be taken to the main menu.
How do I get my engine to hoist my summer car?
The hoist can be lowered by pressing RMB , and raised by pressing LMB . A clicking sound can be heard when the engine is at a suitable position and a bolt will appear at the end of both chains to be tightened. It can only be connected once the headers are attached to the block. The engine on the motor hoist.
How do I open the console in my summer car?
The console is accessed by opening the options menu with F1 or ESC . Commands can be entered by typing on the keyboard while having the console open and pressing ⏎ .
Can you use a steering wheel for my summer car?
The stock steering wheel is a car part which can be found inside the garage at home. It is attached to the steering column with 1x10mm bolt. Both the stock version and the GT version have a horn which can be used by left clicking the centre of the wheel. It’s also the only wheel you can put wheel covers onto.
Can you use a wheel on my summer car?
Wheels cannot currently be attached to the spare wheel compartment at the back of the car. The car can only pass the inspection with the standard or Gommer Gobra tires; no other type of tire will work (including the beater tires, assuming they’re over 50% wear).
Does my summer car have force feedback?
My Logitech G920’s force feedback is very strong. It takes two hands to turn the wheel now. I know experimental has many glitches and bugs, but I really enjoy playing on experimental because it allows you to test things early and without my wheel working properly, it just ruins the experience. Jul 1, 2019.
Is Fleetari open on Saturday?
The address of the shop is Loppentie 8, and the owner, who is also the mechanic, goes by the name Fleetari. The car repair shop is open from 08:00 to 16:00, Monday to Friday.
Where does the half shaft go in my summer car?
They are attached to the gearbox with 3x9mm bolts each, and 1x14mm bolt each. The 14mm bolts are shared with the disc brakes. Remember to check the halfshafts after unbolting the engine, when doing so, the halfshafts will fall off and your car will not be able to move!.
What does the fuel strainer do?
There is a strainer that filters the fuel and keeps particles out prior to it entering the fuel line. It is usualy a woven plastic fabric in the shape of a tube with the ends heat-sealed shut. It slides over the fuel pick-up tube.
How do you tune a summer car distributor?
Tuning distributor adjusts ignition timing, advancing or retarding it. To adjust, loosen distributor hold-down screw with flat-head screwdriver and, using the scroll wheel in hand mode, rotate distributor clockwise or counterclockwise. Rotating distributor clockwise (scrolling down) advances timing.
How do you put spark plugs in a summer car?
The spark plugs are car parts which can be bought from Teimo’s shop for 99 mk per spark plug box, each box contains four spark plugs, the amount needed for the Satsuma. They are attached to the cylinder head with the spark plug wrench/socket.
How do you change a flywheel in a summer car?
Possibly the quickest method of installing the flywheel is as follows: Remove the inspection cover via 4x7mm bolts. Remove the Drive Gear with 7x6mm bolts. Remove the clutch cover (with attached disc and pressure plate) via the 6x6mm bolts (you can rotate clutch cover by hand) Remove the old flywheel with 6x7mm bolts.
What is the Satsuma based on?
Design and inspiration. The Satsuma AMP is based on the Datsun 100A, a very popular car in Europe in the 1970s and 1980s. Its age is further reinforced through the intro of the game, which shows the player’s mother giving birth to the player in the back seat of the car in 1976.
Where does the inspection cover go MSC?
The inspection cover is placed on the gearbox. It enables the player to inspect the clutch without taking the engine out. It is bolted to the gearbox using 4x7mm bolts and cannot be painted.
