Table of Contents
Steps for Winterizing Your Sprinkler System Step 1: Shut Off the Water. It will come as no surprise that the first step is turning off the water to the system with a main valve that’s usually found near your water meter. Step 2: Turn Off the Timer. Step 3: Drain the Water. Step 4: Insulate Above-Ground Components.
How do I winterize my sprinkler system without a blowout?
Not all systems need to have the water blown out of them. You can winterize a sprinkler system without an air compressor if all of your irrigation lines are buried at a slight downhill slope. Simply shut off the main water supply to your system and open the drain valves at the end of each zone.
Do I need to winterize my irrigation system?
So, if you have a lawn sprinkler, you need to winterize it before the temperatures plunge to the freezing mark. If you forget to winterize your sprinklers, you run the risk that water will freeze in the irrigation valves, pipes and sprinkler heads.
When should you winterize your sprinkler system?
A good rule of thumb is to have your sprinkler system winterized in early fall, but we recommend keeping an eye on the weather, and ensure that your watering system is drained and blown out at least one week prior to the seasons first freeze.
How much psi do I need to winterize my sprinkler system?
Air pressure must not exceed 50 pounds per square inch (psi) during the blow out procedure. A pressure-regulating valve must be used to avoid over pressurization of the system. Air volume should be high and air pressure low.
How much does sprinkler blowout cost?
Typical costs: Hiring a landscaping or sprinkler company to winterize/blow out a sprinkler system can cost $30-$160 or more, and typically costs about $55-$85 for an average home, depending on the number of irrigation zones in the system, the local cost of living and the month the work is done.
How do I protect my sprinklers when freezing?
The main shut off valve for your irrigation system needs to be protected against freezing. Make sure it is wrapped with insulation (foam insulation tape and a plastic bag) to protect it from harsh winter temperatures and prevent it from freezing.
How cold does it have to be for underground sprinklers to freeze?
While you may be eager to get your lawn back to its pristine green state, it is important to remember that temperatures of 32 degrees Fahrenheit or lower put your sprinkler system at risk of freezing.
How many CFM do I need to winterize my irrigation system?
The minimum volume an air compressor must be able to provide to properly blowout an irrigation system is 20 cubic feet per meter (CFM). Still, many professionals recommend up to 50 CFM at under 50 PSI for optimal performance, assuming the water lines are less than an inch in diameter.
How do you winterize underground sprinklers?
Steps for Winterizing Your Sprinkler System Step 1: Shut Off the Water. It will come as no surprise that the first step is turning off the water to the system with a main valve that’s usually found near your water meter. Step 2: Turn Off the Timer. Step 3: Drain the Water. Step 4: Insulate Above-Ground Components.
Should you leave sprinkler valves open in winter?
Manual valves should be left in the open position throughout winter to prevent repressurization. Some sprinkler heads have both side and bottom pipe inlets. If you use the side inlet, install a drain valve on the bottom inlet to prevent the case from freezing.
How big of an air compressor do I need to winterize sprinklers?
You need a compressor that has either enough volume or large enough motor to fill your system with pressurized air. A compressor size of 4-6 gallons should be enough.
How much does it cost to winterize pipes?
It costs $200 to $250 on average to winterize a home, but appliance repairs or replacements could increase your budget significantly. For savvy DIY homeowners, your entire winterization budget could be less than $65.
How many sprinkler heads can be on one zone?
At different pressures, the sprinkler head and nozzle will consume different amounts of water. For example, at 35 pounds per square inch (PSI) the 5000 Series Rotor using the 3.0 nozzle will use 3.11 gallons per minute (GPM). If your home’s water capacity was 10 GPM, you could place 3 heads per zone.
How do you drain a sprinkler system before freezing?
To automatically drain your system, turn off the main water supply and wait. Water will begin to drain automatically as the pressure inside the irrigation system drops. Next, open the drain cap located between your main valve and backflow device to drain any water potentially trapped inside.
What temperature is too cold to water grass?
When the temperature is below 40℉ (4℃), it is too cold to water grass. Grasses enter dormancy as temperatures dip closer to freezing, requiring much less water.
What is considered a hard freeze?
Hard freeze occurs when the temperature reaches 28°-or-lower for at least a few hours. It usually means that many types of plants and most seasonal vegetation will be destroyed.
How do I stop my sprinkler pipes from freezing?
To keep the water inside the pipes of a wet fire sprinkler system from freezing in areas where the temperature may drop below 50 degrees, an antifreeze loop is added. By adding antifreeze to the water in the fire sprinkler pipes, the freezing point is much lower, reducing the risk of the pipes freezing.
