Table of Contents
What can you do with a Ditch Witch?
The Ditch Witch was designed to dig small trenches. There have been machines such as steam shovels and wheel trenchers available for more than a century to dig big trenches, but such machines are unsuitable for small trenches such as the ones used to carry water, power and telephone lines.
How long does it take to dig a ditch with a Ditch Witch?
Good conditions and a straight line 2-3 hours with our ditch witch.
Do you push or pull a Ditch Witch?
Remember to always pull the trencher towards you rather than pushing it forward. Use both hands on the trencher’s handles to guide it. Be safe. Since you’re walking backwards, make sure to look behind you every so often to make sure your path is clear of obstacles.
What type of fuel does a Ditch Witch use?
The 410sx is powered by a liquid-cooled 49.6 hp (37.0 kW) four-cylinder Kubota® gasoline engine. The unit is designed for operation in temperatures typically experienced in excavation and construction work environments. Provisions may be required to operate in extreme temperatures. Contact your Ditch Witch® dealer.
How do ditches work?
A ditch is a small to moderate divot created to channel water. A ditch can be used for drainage, to drain water from low-lying areas, alongside roadways or fields, or to channel water from a more distant source for plant irrigation.
How deep can you dig with a Ditch Witch?
When it comes to digging, a trencher can dig a trench that’s 4 feet wide and up to 36 inches deep.
How long does it take to dig a 100 foot trench?
It takes about 12 hours to dig 100 linear feet of trench. Measure the number of linear feet you need to dig and multiply that by 0.12 for an approximate labor period.
Can trenchers go through roots?
Although a trencher can be used to cut through roots, it was designed for creating trenches in soil and may not be able to handle large roots.
How much trench Can you dig in a day?
Trencher Production “That’s one trench with one operator, opening up 10,000 feet of trench per day, whereas one excavator can open up 1,000 to 1,500 feet per day.
How much is it to rent a Ditch Witch?
On average, most Ditch Witch trencher machines can be rented for $130 to $300 for the day, depending upon the exact model and where you rent it. If you wanted to rent it for the week, the costs could drop by the day and could cost $400 to $600 per seven days.
How do you dig a trench fast?
What is the Fastest Way to Dig a Trench by Hand? Water the soil for 1 hour the day before excavation. Use a trenching shovel to quickly excavate the trench. Use a pick mattock to dig up rocks and break through tough soil.
How wide of a trench does a Ditch Witch make?
You can commonly dig a trench from 12 to 48 inches deep and 3 to 16 inches wide using a rented walk-behind trencher. Most compact ride-on trenchers let you dig trenches about 48 inches deep and up to 12 inches wide, but some heavy-duty trenchers allow you to dig trenches as deep as 6 feet and as wide as 16 inches.
How much does a Ditch Witch rt40 weigh?
Height-86 in. Width-64 in. Weight-4,200 lbs.
How much does a walk behind Ditch Witch weigh?
It has a direct-coupled, high-torque digging chain motor that provides a maximum chain speed of 460 fpm. Operating weight is 5,375 pounds.
How do you check hydraulic fluid in a Ditch Witch?
Step 1: Checking the Sight Glass On the left side, there will be a small sight glass with a little red ball inside. The red ball floats in the hydraulic oil. If the ball is at the bottom of the sight glass, it means that the Ditch Witch mini skid steer is low on hydraulic oil.
Can ditches be natural?
A ditch can be a man-made trench, usually long and narrow, dug into the earth, or a natural ditch made by flowing water.
Where does ditch water go?
The water then flows into perforated pipes at the bottom of the trench. From there it is eventually discharged to an outlet, such as a swale, storm sewer, irrigation cistern, or sump. The entire system has to be designed to accommodate the natural flow of water from higher ground to the lowest point.
How do roadside ditches work?
Ditches generally follow natural land contours. In flat areas, there may not be enough fall; the result may be standing water, or the ditch may fill with sediment and cease to function. Or the contour may have too much fall, which allows water to generate speed, causing erosion of the side slopes.
What is a Ditch Witch trencher?
Ditch Witch Introduces Heavy-Duty Trencher with Purpose-Built Design Features for Superior ROI. And a hydrostatic trencher-chain drive with an infinitely variable displacement motor allows operators to easily match chain speeds to soil conditions.
How deep should a drainage ditch be?
A drainage trench should be at least 18 inches deep. This allows you to install a gravel bed, as well as an adequately-sized pipe to carry away water. It also allows you to cover the pipe to protect it and make your drainage trench an attractive lawn feature.
How big of a trencher do I need?
A good rule of thumb: A walk-behind trencher will work best up to a depth of 48 inches and a width of 8 inches. Weighing these factors can save you time and money on the job.
Can you trench with a chainsaw?
Re: Can I use chainsaw to dig shallow trench? Yes, you could trench with a chainsaw, for a while at least. And YES it is dangerous as hell !!!!! Don’t attempt it – if you hit a rock and break the chain you could be severely injured.
How much should I charge for excavation?
Excavation Costs A typical residential excavation job runs between $1,447 and $5,294 with an average of $3,280. Though most companies charge anywhere from $40 to $150 an hour, residential jobs receive project bids. Project bids reflect cubic yards of dirt moved, anywhere from $50 to $200 per cubic yard.
