Table of Contents
How do you turn on a Kohler jet tub?
To use: Fill your whirlpool bath to a water level 2” to 3” above the highest jet. Press the air actuator control. The whirlpool will operate until you press the air actuator button again. WARNING: Risk of injury or property damage.
Why will my Jacuzzi tub not turn on?
If your home has experienced a recent power surge or power outage, you may need to head to the breaker box and check to see if the control for your jetted tub is turned to the “off” position. If so, simply turn it back to the “on” position. The fix may be as simple as cleaning or replacing the tub’s filters.
How do you turn on a hot tub jet?
How to Turn Jets on in the Hot Tub Locate the control panel of the hot tub. This is typically near the hot tub entryway. Turn on the jets. You will see a speed (low, medium, high) that allows you to adjust the force of the hot tub jets. Turn on the timer as well.
How do you turn off a Jacuzzi tub?
If you have massage jets running with therapy pumps and the standard circulation jets you might have a button that says: Jets 1, Jets 2, and Jets 3. To toggle the pumps on and off, simply press the jets you would like turned off.
What are the knobs on my Jacuzzi tub?
Water Control Generally, in the form of manual knobs, there are electric versions, but the idea is that the water knobs control the speed and pressure of the jets. Some of these are tied and linked to your electric water pump.
Do spa jets turn off automatically?
Why do the jets turn off by themselves? The water jets on almost all systems (Balboa, Gecko, Smart Touch, etc.) will only run for a fixed time, usually 15 or 20 minutes, and then will automatically switch off.
Why is my bath stopper not working?
Hold a large enough jam or other jar lid over the drain upside down. Turn the water on to fill the tub. Once enough water fills the tub, the suction from beneath the drain and the weight of the water should keep the lid against the drain enough to keep water in the tub when the stopper doesn’t work.
How do pop up tub drains work?
Pop-Up. The drain part of this type of tub stopper looks very much like a bathroom sink pop-up. When the lever moves, the connecting rod linkage in the overflow drainpipe moves also and pivots a rocker arm that connects to the pop-up stopper.
How do you close a Kohler bathtub drain?
Like the push-and-pull drain stopper, the lift-and-turn stopper is equipped with a small knob at the top. To open, turn it clockwise and pull up a bit on the knob. To close, turn it counterclockwise and push down.
Where is the reset button on a Jacuzzi?
You will find a reset button typically on the heater unit. Usually there is a pilot light. When you’re ready to reset, push the button. Some spa units have a high limit switch which will turn off the spa heater if the thermometer fails.
Why is my Jacuzzi bath not working?
Check for and repair broken wires or loose or corroded terminals. If necessary, have the pump switch control tested and serviced professionally. If the jets do not work, clear a blocked water intake of hair and other particles (see below) or replace a broken jet (see below).
How does a Jacuzzi air switch work?
An air switch consists of a pneumatic air button located at spa-side and a pneumatic-activated electrical, air switch located with the spa electronics. The only connection between the two is a small air hose. Turn the power off to the hot tub. Turn the power off to the hot tub. Turn the power off to the hot tub.
Why won’t my Jacuzzi jets turn off?
First, check your water level. Then, look for clogs in your circulation system, and wash or change your filter. If the high limit switch shut your heater off because your water got too hot or you have air trapped in your lines, resetting the heater will get it going again.
Does a hot tub have to be on all the time?
One question we sometimes get asked is should I leave my hot tub on all the time? The answer is yes! Hot tubs are designed to be left on permanently and this is how they work best. Of course, they’ll need to be drained regularly but for the most part, they are left on 24/7.
How do you turn off the air induction valve on a jetted tub?
Turn off the air induction valves by turning them fully clockwise. This forces the water to circulate only in the internal plumbing of the tub to concentrate the flow and clean deeper. Leave them open if the manufacturer of your tub states to do so in the owner’s manual.
Is jetted tub same as Jacuzzi?
The first whirlpool tub was patented by Jacuzzi. The company’s products have since become synonymous with in-home spa tubs and, while Jacuzzi is a brand name, it is often used interchangeably with “whirlpool” or simply any jetted tub. Whirlpool is the generic term for any tub with water jets installed.
