Table of Contents
Can I turn off my pilot light?
Often, turning off the pilot light is as simple as turning a knob to “off.” For other systems, you may have to push a small lever out of the way in order to turn the knob. Whatever you do, don’t force the knob. If you have trouble switching it of, leave the light alone or call a qualified technician for assistance.
Should you turn off the pilot light on a gas furnace?
Most modern mid to high efficiency gas furnaces no longer have a pilot light. It’s been replaced by an electronic ignition. As a result, the furnace will not need to continuously burn gas in order to keep a pilot light going, making it unnecessary to turn off your furnace for the summer.
Is furnace pilot light always on?
If you have an older gas furnace, your heating unit relies on a little blue flame known as a pilot light to ensure ignition of the burners. Water heaters, gas fireplaces and old gas stoves also often have similar pilot lights. Since the pilot light needs to remain active, your furnace is always consuming some gas.
How do I shut off the gas to my house?
There is a shut-off valve running parallel with the pipe, usually located about 6 to 8 inches above the ground. Take a 12-inch or larger adjustable wrench, and turn the valve 1/4 turn in either direction, until the valve is crosswise to the pipe.
Is it bad to turn your furnace off?
When the thermostat detects a decrease in temperature, it switches on the heat circuit and the furnace control board begins the ignition process. But turning off the furnace in the winter—especially when you’re away for long periods of time—runs the risk of frozen pipes that could easily burst when they thaw.
Why doesn’t my furnace shut off?
If your furnace won’t turn off, the easiest issue to fix is your thermostat. A furnace that is working hard to keep a high temperature, especially when it’s extra cold outside, can seem to run continuously. The second common thermostat problem is the fan switch. Your fan can be adjusted manually from your thermostat.
How much does it cost to keep a pilot light on?
Running a pilot light for 1 hour costs about 1 cent (0.62 cent/hour for natural gas and 1.64 cent/hour for propane). Monthly costs of running a pilot light range from $4.49/month (natural gas) to $11.34/month (propane).
What makes pilot lights go out?
Some of the possible serious reasons for pilot lights to go out include loose or broken gas valves, thermocouples or heat exchangers, faulty venting, low gas pressure, or high winds. If you believe there is a serious problem, don’t hesitate to contact a professional.
How do you reset an automatic pilot light?
Press the gas control knob down all the way and hold it in the depressed position. If you have no igniter, move the match or barbecue lighter flame to the end of the pilot tube; the pilot flame should light immediately.
Can you turn furnace off and on?
Turning off your furnace may not make a massive impact but it’s a small contribution that you can make. Once the furnace is turned off, there is no way that your home can be heated inadvertently until it’s turned back on again.
How do I turn off my furnace fan?
Your fan limit switch is located inside the furnace panel cover, usually near the upper right corner. The fan limit switch is responsible for turning the blower on and off at the appropriate times.
Can you unplug a furnace?
In order to ensure safety while working on the furnace, you can shut off the power to the furnace’s circuit at either the circuit breaker or the disconnect, or both. The disconnect switch not only adds convenience, it’s also an additional safety feature.
Is it safe to turn off gas furnace?
If it’s a natural gas furnace that uses a standing pilot light to ignite the burners, then we recommend you shut it all the way off by turning off the gas to it. If you don’t do this, the pilot light will continue to burn throughout the summer, which is a waste of gas.
Where is the gas shut off valve?
Your main shut off valve is located just before the gas meter. This is called your “street side valve”. On the inside of your house, where the pipe enters your house, you can find your “house side valve.” This ball valve is attached to a black iron pipe.
How do I turn my gas back on after disconnecting?
You are going to need a wrench or gas shut off tool to do this. Very slowly, turn the meter back into the on position. The lever should be in line with the pipe after making a ninety-degree turn. Finally, you can re-light any of the pilot lights in your appliances.
How do I cancel my gas supply?
3 Ways To Terminate Your SP Services Account Terminate Via The SP Utilities App. Fill Up The Online Termination Form And Mail it In. You will also have to close your City Gas gas supply account with a termination fee of $32.10 which will be billed to you separately. For more information click here.
