Table of Contents
Gather Tools and Materials. Turn Off the Water Supply and Open the Faucet. Remove the Handle Cap, Handle and Faceplate. Remove the Locking Clip. Remove and Replace the Cartridge. Replace Other Parts and Test. Remove the Metal Stem in a Shower Faucet with Two Handles. Replace the Metal Stem if Needed.
Why is my shower faucet dripping?
When water drips or drizzles from a shower head, there is a problem with the shower faucet (valve). In most cases, inner seals are worn, or parts have become corroded or clogged with hard water deposits. And the rubber O-rings and gaskets that seal connections between moving metal parts wear down with time and use.
Why does my shower faucet drip after I turn it off?
If your shower keeps dripping long after you’ve shut off the water, you’ve probably got a bad valve. It’s an easy repair you can do yourself in less than an hour.
Why won’t my shower faucet stop dripping?
A leaky shower is usually due to an issue with the faucet valve stem and/or valve cartridge. Your shower head is likely fine. Replacing a faucet valve stem and/or valve cartridge can be difficult. There may be a shut-off valve in the bathroom, or you may need to shut off the main water for the whole house.
Where is the O-ring in a shower head?
The O-ring, a circular rubber part of the fixture, is inside the showerhead. It attaches to the various threads when the head has been unscrewed. When this part of the showerhead breaks, it can cause leaks and may need to be replaced.
Why does my shower head randomly drip?
If the cartridge becomes worn or cracked, water can seep through—even when the handle is in the “off” position. This can cause water to drip or trickle from the shower head. If replacing the cartridge doesn’t solve your leaking shower head, the valve body itself is likely damaged.
How do I stop my hand held shower head from leaking?
How to Fix a Leaky Hand-held Showerhead Step 1: Remove the Flexible Hose. Step 2: Clean and Check the Threads. Step 3: Inspect the Rubber Gasket. Step 4: Soak Off Mineral Deposits. Step 5: Tape the Threads. Step 6: Reconnect the Flexible Hose. Step 7: Install New Rubber Washers. Step 8: Install a New Rubber Gasket.
Where is the water shut off valve for a shower?
This supply valve is usually near the bottom left side of the toilet tank. For showers/tubs, look around the tub or shower for an access panel. It may be on the other side of the wall from the tub or shower.
Why does my shower head and faucet run at the same time?
Why does water come out of my shower head and the spout at the same time? Most likely you are experiencing “shower-rise,” where the water can’t get out of the spout as fast as it flows through the valve. This causes the water to back up and come out the shower head. The valve could be upside down.
How do I change the O-rings in my shower faucet?
Replacing the O-ring is simple. Just pull the valve stem out and remove the old O-ring. Put a small amount of petroleum jelly or silicone on the new O-ring and slide it on the stem. Before you reattach the escutcheon, you can apply a little bathtub caulk.
How do I change the O-rings in my shower?
How to Replace Shower Valve O Rings Find the shut-off valve that controls the shower and turn it off. Remove the handle. Remove the clip holding the cartridge in place with needle-nose pliers. Grasp the faucet stem with pliers after removing the clip or nut, and pull the cartridge toward you.
Can I turn off the water to just my shower?
There usually is not a shutoff valve for just the shower. The toilet has it’s own shutoff, and sinks have their own shutoffs under the sink. But tub and showers typically do not have their own shutoffs. You’ll usually see a copper line come off the hot water heater and run off towards the kitchen and baths.
How do I fix a leaky shower?
Gather Tools and Materials. Turn Off the Water Supply and Open the Faucet. Remove the Handle Cap, Handle and Faceplate. Remove the Locking Clip. Remove and Replace the Cartridge. Replace Other Parts and Test. Remove the Metal Stem in a Shower Faucet with Two Handles. Replace the Metal Stem if Needed.
What is a shower diverter kit?
A shower diverter, also known as a diverter valve, is a valve that diverts the flow of water from the bathtub faucet to the shower head. Thus, a diverter valve allows you to have a shower and a bathtub in the same space.
What is a shower diverter?
If you have a shower-tub combination in your bathroom, the shower diverter valve is what allows you to divert the water back and forth between the tub faucet and the showerhead. Though they are typically very simple devices, shower diverters may malfunction and need replacing once in a while.
Why does shower head leak after tub?
The most common reason why your shower head leaks while you fill the bathtub is likely because of the issue with the diverter valve which main purpose is to divert water from the bathtub faucet to the showerhead and vice versa.
