Table of Contents
Can I snake my bathtub drain?
Luckily, it’s not difficult to snake a tub drain. To clear a clogged bathtub drain, you’ll need a plumbing snake, some work gloves and some basic cleaning supplies. Be sure to put the screws where they won’t fall into the tub drain, then pull the stopper from the drain, which should be connected to the overflow plate.
What is the best tool to unclog a tub drain?
Removing hair collected around a pop-up stopper or strainer clears one common clog in the bathroom. A drain stick is effective at clearing clogs in a P-trap or S-trap caused by hair. A plunger can clear a clog if the blockage isn’t too far into the pipes.
How do you hand snake a bathtub drain?
Insert the tip of the snake into the hole usually covered by the overflow plate. Crank the handle and extend about 30 inches of snake cable into the pipe. Continue to crank the handle, and press the snake forward and down into the drain. Crank and press until you feel the snake meet the obstruction.
How do I clear a clogged bathtub drain?
All you need to do is pour a pot of boiling water down the bathtub drain. Then pour a mixture of one cup baking soda and one cup vinegar into the drain. Insert the drain plug, or close the filter, and wait 5–10 minutes. Finally, flush the drain with another pot of boiling water.
How do you snake a bathtub drain without a snake?
Put in your drain stopper, turn on the hot water and let it pool in the sink. Add one cup of baking soda and two cups of vinegar to the water and remove the stopper. The hot water, baking soda, and vinegar will flow down the pipes and help eliminate minor clogs.
Can’t get the snake down the drain?
Too much force – When you’re trying to dislodge a blockage, it can be tempting to try and force a snake cable through the drain too fast. If you force it, sometimes the cable can bend back on itself or kink. Instead of forcing the cable, extend the snake cable a few inches at a time until you reach the clog.
What will dissolve hair in a drain?
Combining baking soda and vinegar is a natural way to dissolve hair clogs, without resorting to harsh chemicals. Pour a cup of baking soda down the clogged drain first, and then after a few minutes add a cup of vinegar.
What breaks down hair in a drain?
Use Baking Soda & Vinegar Before Plunging It Out: Baking soda and vinegar can be an extremely effective way of dispatching many clogs, and hair clogs are no exception. For best results, start by squirting a little dish soap into your drain, followed by a cup of vinegar and a cup of baking soda.
What home remedy can I use to unclog my bathtub?
Baking Soda and Vinegar Drain Unplug Remedy Take one cup of baking soda, one cup of vinegar and one of salt, if you want some extra power, and make sure there’s no water in the tub. Dump the baking soda into the drain, followed by the salt, and finally the vinegar.
How do you get a snake past the tub P trap?
The proper way to use a snake is to insert the head into the drain and push very slowly without cranking. If you try to force it, it can bend back on itself and actually come out of the drain. Push gently and slowly, and if the auger is the right one for the job, it should slide smoothly through the pipe.
How do you get a snake out of the shower drain?
Insert the Drain Snake Wearing rubber gloves, run the cable on a small drain snake down into the drain opening until it meets resistance. Tighten the cable clamp, then begin to rotate the handle slowly to spin the cable in the drain opening. The cable should begin to auger itself down further into the drain.
Why is my tub not draining?
You Have Clogged Drain Pipes Of course, the most common reason why a bathtub won’t drain is due to clogged pipes. Over time, nearly all bathtub drains will develop clogs. These are most commonly caused by a combination of: Soap residue.
Why does my tub drain when I take a bath?
If your bathtub doesn’t hold water, the culprit might be a faulty bathtub drain stopper. It also drains the tub when not in use. In most cases, an issue with the bathtub drain stopper is usually because it has disconnected from the spring or plug that connects it to the linkage.
Does Drano work on bathtubs?
You can use Drano® Clog Removers to unclog a kitchen sink, bathroom sink, shower or clogged bathtub, but DO NOT use them in toilets. For clogged or slow-running drains, apply the product and let it work 15 minutes, then flush with hot water.
How do you unclog a bathtub drain when Drano doesn’t work?
Baking soda and vinegar may unclog your drain better than Drano ever could. Start by getting rid of the standing water in your drain. If it will go down slowly, just wait until it’s gone. If it isn’t moving, use a cup or a spoon to get it out of there.
