Table of Contents
How to Reset an Airbag Light Put the key into the ignition and turn the switch to the “on” position. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds. Repeat Steps 1 and 2 two more times.
How do I turn my airbag light off?
How to Turn Off the Airbag Light Turn on the ignition switch with your car key. Wait for the airbag warning light to turn off. Turn the ignition switch of your car back off for a little longer than three seconds. Repeat steps 1 through 3 twice to make three times total.
Can you reset airbag light without tool?
In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Spray the connector plugs with an electronic cleaner and restart your car.
Will disconnecting the battery reset the airbag light?
No, this information is stored in non volatile memory. The airbag light is usually on if there’s a problem with the system. Even if you could clear the code which is reporting that, if the problem isn’t fixed then it will just be detected again, and the light will come back on.
What does it mean when the airbag light stays on?
5. Your Airbags May Not Deploy In The Event Of A Crash. The airbag light is an indicator that there is a problem with the vehicle’s Supplemental Restraint System. When this light comes on, it indicates that a problem has been detected in the system, and one or more airbags may not inflate in the event of a collision.
How much does it cost to reset the airbag light?
Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
Can I drive with airbag warning light on?
When the airbag light illuminates, it means that there is a problem with the system. Most likely, the airbag will not deploy in an accident because of this fault. Therefore, it is not recommended that you drive the vehicle until you have the system repaired.
Where is the airbag sensor?
Usually, you have two airbag sensors located in the front of your vehicle behind the bumper. There is often also one airbag sensor installed inside of each door of your car.
What can cause the airbag light to come on?
What causes the airbag light to come on? The airbag needs resetting. Corroded sensors. Depleted battery. Dislodged wiring. Faulty seat belt. Your airbag clock spring may need replacing.
How do I check my airbag light code?
The airbag codes are double digit numbers. To read the codes, count the number of times the light flashes, wait for the pause and count the flashes again. For example, two flashes, a pause and four flashes mean that your airbag system’s problem is a code 24.
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.
How do I reset my car without disconnecting the battery?
How To Reset Car Computer Without Disconnecting Battery 3.1 Step 1: Open the hood and disconnect the battery. 3.2 Step 2: Locate the car’s fuse box and remove the fuse. 3.3 Step 3: Reinstall the fuse and reconnect the battery terminal. 3.4 Step 4: Start the vehicle and perform a test run.
What happens if I remove the airbag fuse?
If it has a fuse, will removing it disable the airbag? In most cases, removing an airbag fuse does not disable the airbag. This especially happens if the airbag deploys even when the power that drives it is cut off. You may have to figure out another way to disable the airbag.
Is airbag light a MOT failure?
During your MOT your vehicle’s airbags will be checked. If your car’s airbag warning light is on during your MOT, you will need to schedule a second visit. In fact, this indicator light is considered a major reason to fail your MOT, since it directly impacts your safety.
How much is a new airbag?
Replacing a single air bag usually costs $1,000 to $2,000, but some cases may be much more expensive. After a significant accident, expect the total cost of replacing your air bags to range from $1,000 to $6,000, with most bills averaging $3,000 to $5,000.
Can low battery cause airbag light?
When this light is on, that means your airbags are deactivated. It means they will not deploy properly if you get into an accident. If your car’s battery has drained recently, it may have also depleted the backup battery that powers the airbags.
What scanner will reset airbag light?
Autel AutoLink AL619 OBD2 Scanner, ABS, SRS Airbag Scan Tool, Turn Off ABS, Airbag Warning Lights, Ready Test, Advanced Version of ML619.
