Table of Contents
To reset an airbag on a silverado just put the key into the ignition and turn the switch to the on. Watch for the airbag light to turn on. It will stay lit for seven seconds and then shut itself off. After it shuts off, turn the switch off and wait three seconds.
How do you reset the airbag light on a Chevy?
Turn Your Ignition on and Off. First, turn the ignition switch on. Next, wait for the airbag light to turn on – it normally stays lit for seven seconds before shutting itself off. Then, immediately turn off the ignition switch, and wait three seconds. Repeat the initial steps once or twice before starting the engine.
Why is my airbag light on Chevy Silverado?
If the Chevrolet airbag light stays on and won’t turn off, it is because the Safety Restraint System (SRS) has detected a problem with one of the airbag components. Two possibilities include damaged wires or low voltage.
How do I reset my airbag light?
How to Reset an Airbag Light Put the key into the ignition and turn the switch to the “on” position. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds. Repeat Steps 1 and 2 two more times.
How do I turn off the service airbag light for a 2005 Chevy Silverado?
Turn on the scan tool and select “Air Bag” from the main menu. Select the “codes” menu, then select “clear all codes.” Unplug the scan tool from the vehicle. Start up the engine and check to make sure that the air bag light is no longer on. The air bag system is now reset.
How do I turn off the airbag in my Silverado?
How to Disable the Silverado Airbag Turn off the engine and take the key out of the ignition. Place the transmission in park and apply the parking brake. Insert the key into the passenger airbag “ON/OFF” switch. Turn the key to the “OFF” position and remove the key from the switch.
Can you reset airbag light without tool?
In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Spray the connector plugs with an electronic cleaner and restart your car.
Will disconnecting the battery reset the airbag light?
No, this information is stored in non volatile memory. The airbag light is usually on if there’s a problem with the system. Even if you could clear the code which is reporting that, if the problem isn’t fixed then it will just be detected again, and the light will come back on.
What do you do when your airbag light comes on?
The bottom line is that, when your airbag light comes on, it’s vital that you don’t drive any further and have your car checked by a mechanic as soon as possible. Until the problem is diagnosed and fixed, your airbags will not deploy.
Can you drive with the airbag light on?
When the airbag light illuminates, it means that there is a problem with the system. Most likely, the airbag will not deploy in an accident because of this fault. Therefore, it is not recommended that you drive the vehicle until you have the system repaired.
How much does it cost to turn off the airbag light?
Number 1 — Reset Airbag Light This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
Where is the airbag sensor?
Usually, you have two airbag sensors located in the front of your vehicle behind the bumper. There is often also one airbag sensor installed inside of each door of your car.
Will removing fuse disable airbag?
If it has a fuse, will removing it disable the airbag? In most cases, removing an airbag fuse does not disable the airbag. This especially happens if the airbag deploys even when the power that drives it is cut off.
Where is the airbag sensor on a 2005 Chevy Silverado?
The 2005 Chevy Silverado’s front airbag sensors should be mounted on the bottom of the front radiator supports. A sensor will be bolted to either side of the core and removeable after releasing a metal protective shield. The shield is secured by three-four15mm bolts. Gain access from underneath the vehicle.
What does it mean when your truck says service airbag?
The airbag light indicates that something is wrong with the seatbelts or airbags. This means that it’s probably not safe to drive with the airbag light on. If it stays illuminated in your vehicle, we recommend having it towed to the dealership rather than driving it yourself.
How do you disable air bags?
How to Disable Airbag System? Find out here! Purge the Power. The first step involved in the process of how to disable airbag system in your car is to cut off the power. Take Out the Fuse. Take Away the Dashboard Cover. Immobilize the Passenger Airbag. Remove the Steering Wheel’s Lower Panel. Finally, Disable the Airbag.
How do you turn off the airbag in a 2014 GMC Sierra?
To turn off the right front passenger airbag, insert the ignition key into the switch, push in, and move the switch to the off position.
How do you turn on the passenger airbag on a 2009 Chevy Silverado?
Turn on the vehicle, wait for the air bag control to signal ON, and then keep the person and the seat in the same position for one minute. After one minute, the passenger can adjust their seat and sitting position, and the air bag will stay on.
What scanner will reset airbag light?
Autel AutoLink AL619 OBD2 Scanner, ABS, SRS Airbag Scan Tool, Turn Off ABS, Airbag Warning Lights, Ready Test, Advanced Version of ML619.
How do I check my airbag light code?
The airbag codes are double digit numbers. To read the codes, count the number of times the light flashes, wait for the pause and count the flashes again. For example, two flashes, a pause and four flashes mean that your airbag system’s problem is a code 24.
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.
