Table of Contents
How do you remove electric blanket cords?
Usually the best way to remove wires from an unplugged electric blanket is to cut small openings near the wires at the top and bottom of the blanket. Then carefully pull out the wires and the thermostat. You may have to snip the blanket at each thermostat and cut the wire there also.
How do you clean a Sunbeam electric blanket?
Wash in mild soap and cold water on the “delicate” or “gentle” cycle in the washer for two minutes. Do not use bleach. Rinse in fresh, cold water. Spin dry in the washing machine.
How do I connect my Sunbeam electric blanket?
Sunbeam Electric Blanket Operating Instructions Lay the electric blanket on your bed. Connect the cord to the module at the bottom of the blanket, near the label. Run the cord along the floor under the bed. Place the warming control on either side of the bed, near the headboard. Plug your blanket into the outlet.
How do you clean a sunbeam warming throw?
Sunbeam suggests pre-soaking your electric blanket in cold water with mild soap for 15 minutes before washing. Once it’s soaked, wash the blanket in mild soap and water on the “delicate” or “gentle” setting for 2 minutes. Then, rinse in cold, fresh water, and let it spin dry.
What type of wire is used in electric blankets?
Electric blankets use between 15 and 115 watts. Some modern “low voltage” electric blankets have thin carbon fiber wires and work on 12 to 24 volts.
How do you turn on a Sunbeam heated blanket?
1 To turn the control on, simply press the “On/Off” button. by flashing “88” and then will return to the previous setting and will begin to warm. 2 Adjust the warming setting to your personal comfort level. 3 To turn the heated blanket/mattress pad OFF simply press the “On/Off” button.
How do you wash an electric blanket in the washing machine?
Instructions Prep the Blanket. Shake out the blanket to get rid of as much loose debris as possible. Add the Blanket to the Washing Machine. For high-efficiency washers, load the blanket in loosely. Select a Water Temperature and Detergent. Choose the Washer Cycle. Wash Quickly and Switch to the Rinse Cycle. Dry Gently.
How do you hand wash an electric blanket?
To wash by hand, dunk the blanket (not including any electrical cords) into a tub with cold water and mild detergent and swish it around for a minute or two. Let it soak for fifteen minutes, squeeze soapy water out, and rinse in cool water before drying.
How do you wash a Costco heated blanket?
Hand wash in cold water using a small amount of mild laundry soap or detergent. Do not rub or scrub. Rinse thoroughly in cool water until all traces of soap or detergent are gone. Lightly squeeze excess water out by hand.
Can I plug a heated blanket into an extension cord?
DO plug space heaters directly into a wall outlet. Do not use an extension cord which could overheat and result in a fire. DON’T use electric blankets while sleeping or as a mattress pad.
Why is my Sunbeam heating blanket blinking?
Sunbeam Heated Blanket Blinking Yellow Light – Why? The light normally blinks because you have to reset the blanket. If resetting doesn’t work, check the connections between the power cord and the wall outlet, and the power cord and the blanket. They should be secure.
How does a Sunbeam electric blanket work?
Heated blankets are powered by an electric current that passes through the material. Sunbeam Heated Bedding have smart technology that adapts according to both external room conditions and internal body temperature.
How do you clean a pure pleasure electric blanket?
Care Instructions Always remove the plug from the power supply before attempting to clean the blanket. Small spots can be cleaned with a cloth or damp sponge and if necessary a little mild detergent. DO NOT dry clean, machine dry or iron the blanket. DO NOT switch blanket on to dry it.
What happens if an electric blanket gets wet?
If an electric blanket gets wet, dry it thoroughly following the manufacturer’s instructions. Young children should use electric blankets only when they no longer need nappies and have been taught to use a blanket safely. Dampness or spilled water could cause an electric shock if the blanket is faulty.
Is it safe to leave an electric blanket on all night?
Using an Electric Blanket All Night Long While a modern, well-maintained electric blanket is unlikely to cause problems with proper use, it is not recommended to keep electric blankets on all night. The blankets will trap the heat in the mattress so that the entire bed will feel warm when you get in.
Do heated blankets need to be plugged in?
The safest place for the connector to rest during use is at the foot of the blanket or towards the end of the bed. This ensures the blanket will not be disconnected throughout the night or overheat due to sleep-related movements, plugging and unplugging the connectors, which can interrupt the power source.
How long do electric blankets last?
If you care for and use an electric blanket properly, it can last up to 10 years. If you notice that the heat doesn’t seem evenly distributed or if the blanket is discolored in certain spots (a sign that there’s internal burning), it’s time to get a new one.
