Table of Contents
Can I remove a gas fire myself?
Can I remove a gas fire myself? To be clear, you should never attempt to remove a gas fire yourself. It is a legal requirement that this job is completed by a Gas Safe Registered engineer. The risks of tackling this as a DIY job include fire, and death through inhalation if you do not properly cap off the gas pipe.
How expensive is it to remove a gas fireplace?
The average cost to remove a fireplace is $500 to $2,500, depending on the size, fuel type, placement, and material.Cost To Remove Fireplace. Type Average Cost Gas Insert $500 – $2,500 Electric Insert $500 – $1,000 Outdoor $500 – $2,000.
How do you remove a gas fireplace?
Start by shutting off the gas to your home at the main valve so there’s no chance of a leak. Take a crowbar and remove the trim around the insert. When you can access the gas line, remove it as well. Then, carefully wiggle the insert out of the fireplace and remove it.
How do you disconnect a gas fireplace?
Beside turning off at the fireplace valve, turn it off at the tank or at the meter too. With the valve closed, remove the pipe from the fireplace back to the basement or to the valve if it is outside of the fireplace. It will need a black iron pipe cap or plug with proper thread seal at that point.
Can you remove a wood burning fireplace?
It is possible to remove the fireplace by itself and leave the stack or chimney flue. The most important aspect of this kind of removal is reinforcement. A lot of supports will need to be installed in order to maintain the structural integrity of your house.
How do you remove a chimney from a wood burning stove?
To disconnect chimney pipes, locate the first pipe connection. You should see screws or rivets on the bottom or “female” pipe end, which holds the top or “male” pipe end in place. Using a screwdriver or ratchet wrench, loosen the screws or rivets. Locate the second pipe connection and do the same.
Is it hard to remove a wood burning stove?
The actual disconnection of the stove takes only a few minutes using a screwdriver. You may need to apply lubricant spray to loosen the heat-baked connections on the chimney pipe where it fits onto the back or top of your stove.
Does removing a fireplace decrease home value?
But losing a fireplace can affect a home’s appeal and possibly even its resale value, real estate pros say. A fireplace can particularly be viewed as a valuable amenity in colder climates, and removing one could even reduce the number of buyers drawn to a property, some agents say.
Is it a good idea to remove a fireplace?
Our experts says that, in most cases, you should just leave your fireplace be. He would never advise removing a fireplace unless there were certain reasons to justify this action. “Even if someone doesn’t plan on using it, they can turn it into a decorative fireplace and put candles or stacked wood in it,” he says.
How easy is it to remove a fireplace?
If it’s a wooden or tiled surround, it can be as simple as removing screws and lifting it away. You may need some help with tiled surrounds due to their weight. It’s also important to wear gloves and protective goggles if you choose to break them up with a sledgehammer.
How do you move a gas fireplace?
Steps to move a gas fireplace Find an appropriate location. Disconnect the Gas supply. Disassemble the fireplace and remove the unit. Move the fireplace to the new location. Assemble the fireplace.
How do you remove a gas fireplace surround?
To start removing one of these fireplace surrounds, you will have to chip away the plaster around the edge of the mantelpiece. This should reveal the lugs holding it to the wall. You can then go about removing the screws, which should start to release the surround from the wall.
How do you remove a ventless gas fireplace?
Most are just two pieces, the surround, and the fire box. Follow the gas line back to the supply, shut off the gas, remove the line and cap or plug off where the line was connected. In most cases that surround is just sitting against the wall and can be slid straight out. Once it’s gone you can get to fire box.
Where is the gas shut off valve located?
Your main shut off valve is located just before the gas meter. This is called your “street side valve”. On the inside of your house, where the pipe enters your house, you can find your “house side valve.” This ball valve is attached to a black iron pipe.
How do you remove a fireplace?
The fireplace removal process Remove or cover furniture. Check whether the chimney breast supports any of the house’s framing. Seal off doors to protect from dust. Dismantle brick-by-brick, using a cold chisel and hammer. Chisel out the mortar and remove the bricks to at least one foot below the roofline.
Is it hard to remove a gas fireplace?
For natural vent gas fireplace inserts located within masonry fireplaces, removal can be relatively straightforward once a professional has disconnected the gas.
How much does a new fireplace insert cost?
How much does a fireplace insert cost? Most fireplace inserts and a professional installation cost about $2,000 to $4,000, depending on the state of your existing chimney and the model you select. Some electric models cost significantly less, but they offer less heat output than wood and gas fireplace inserts.
