QA

How To Refinish Hardwood Floors Under Carpet

How to Refinish Your Hardwood Floor (under Carpet) Step 1: Check for Hardwood. Step 2: Remove Carpet and Padding (foam) Step 3: Install Edging for Remaining Carpet. Step 4: Sand Your Wood. Step 5: STAIN and Your Done.

How do you restore hardwood floors under carpet?

Restoring hardwood floors under carpet – in 4 easy steps Remove carpet, padding, and all debris from the floor. Thoroughly wash the hardwood floor. Apply Weiman High Traffic Hardwood Floor Polish & Restorer. Apply a final coat of Weiman High Traffic Hardwood Floor Polish & Restorer.

Does carpet ruin hardwood floors?

Carpet can be installed over hardwood floors with minimal damage and without ruining it. By using tackless strips with thinner nails around the room, limiting the use of staples, avoiding the use of adhesives, and careful carpet installation, you can minimize any damage done to your hardwood floor.

How do you treat hardwood floors after removing carpet?

Three Steps for Cleaning Old Hardwood Floors Remove Dirt and Debris. Start by sweeping up any loose dirt and dust that accumulates on your floor. Apply Mop. After you remove all the dirt and dust off the floor, you are ready to apply your cleaning solution. Polish and Shine.

Is it cheaper to refinish or replace hardwood floors?

In general, it will almost ALWAYS be less expensive to refinish your hardwood floors. If you replace them, you need to pay for additional wood as well as ripping up and hauling away existing hardwood. Even if you have this, it will still be less expensive then replacing the whole floor.

What does it cost to have a hardwood floor refinished?

Nationally, the average cost for refinishing a hardwood floor is $1,761, within a typical range of $1,074 to $2,486. But there’s every chance your floor is anything but average, and your actual costs can vary depending on many factors, especially the availability and cost of labor in your area.

What should you not put on a hardwood floor?

Avoid using water and vinegar, soap-based cleaners, wax or steam cleaners on hardwood floors. Vinegar and water can dull the floor’s finish over time, while soap and wax leave a residue. Steam cleaners put heat and excessive water on your floor, which can lead to cupping and long-term damage. Use mats.

How much does it cost to rip up carpet and refinish wood floors?

Cost to rip up carpet and refinish hardwood floors Carpet removal and disposal costs $0.25 to $1.00 per square foot alone, plus $2 to $7 per square foot for hardwood floor refinishing. Removing carpet from stairs adds $7 to $10 per step.

Why do people put carpet over wood?

Because builders found they could put plywood floors and cover them with carpet , and it was cheaper for them, THEY did this in the late 50s. This was copied by people with hardwood floors because it was viewed as “modern”.

Is there a subfloor under carpet?

The subfloor is the layer underneath the carpet and carpet padding. It’s usually made of plywood, but can be wood, OSB board, or particle board as well. It’s laid on top of the joists in the floor and attached with nails or screws. When you step on those gaps, the nail squeaks in the loose hole it has made.

How can you tell the difference between hardwood and engineered hardwood?

The simplest way to tell the difference between the two types of wood is to pick up a loose plank. Look at the side of the plank. If it is one solid piece of wood with a continuous grain, it’s solid hardwood. If you see different layers of wood, it’s engineered hardwood.

How can I tell if my floors are hardwood or laminate?

Look for water marks, stains and faded areas on the floorboards. Laminate doesn’t stain the way natural wood does, so if you see water rings, random splotches or discolorations on the floor, it is probably hardwood. Determine how the floorboards are attached.

How can I refinish my hardwood floors without sanding?

3 Approaches to Refinishing Hardwood Floors Without Sanding Use a store-bought chemical abrasion kit. Buff and recoat floors with polyurethane. Use a revitalizer.

Can you refinish floors yourself?

If you only have some minor scratches and dings or a dull finish, you might be able to simply buff and add a new coat of varnish. But, even if your floors need a complete makeover, refinishing hardwood is a very manageable and rewarding do-it-yourself job that can save a lot of money.

How much does it cost to refinish 1500 square feet of hardwood?

Cost per square foot to refinish hardwood floors: Flooring square footage Average cost 751 – 1000 sq. ft. $2,100 1001 – 1500 sq. ft. $2,350 1501 – 2000 sq. ft. $3,500 2001 – 3000 sq. ft. $5,000.

Are my wood floors worth refinishing?

“Refinishing a wood floor is cheaper than putting in nice $50-$60-a-yard carpeting,” Lessick says. Besides, a properly maintained wood floor can go 20 or 30 years or more before needing to be refinished, says Lupresto. And it can be sanded and refinished “easily six or seven times” over its lifetime, he says.

What is the cheapest way to refinish hardwood floors?

Applying a revitalizer gloss is the simplest and cheapest way to refinish hardwood floors. This approach works best on floors that only have surface-level scratches and other minor wear and tear issues. You can get the job done without the need for equipment rentals or hard-to-find materials.

How long do you have to stay off hardwood floors after refinishing?

How long do I have to wait to use my room after my floors are refinished? We recommend waiting 6 hours before walking on your new floors in socks. After 24 hours you can walk through with shoes on. Allow 48 hours before setting furniture and returning pets.

How much does it cost to refinish $1000 square feet of hardwood floors?

The cost to refinish 1,000 square feet of hardwood flooring averages between $3,000 to $8,000.