Table of Contents
INSTRUCTIONS: Prepare your snow blower for maintenance. Place your snow blower on a flat surface. Change the engine oil in your snow thrower. Install a new spark plug if necessary. Inspect belts for wear. Drain the gas tank and replace with fresh fuel. Lubricate the drive and chassis.
Should I run my snowblower out of gas?
Even if the gas has been stabilized, we recommend completely draining your snow blower’s fuel system before storing it away for the season. Gas oxidizes and breaks down over time, creating sludge that can build up inside your snow blower’s fuel tank, carburetor and fuel lines.
How do I drain gas from my snowblower?
Step 1: Turn off the system, Let it cool. Before you set to begin the process, turn off the snowblower and let it cool. Step 2: Stabilize the gasoline fuel. Open the fuel tank by removing the cap. Step 3: Do the siphoning to remove gas. Step 3: Drain fuel from the carburetor bowl. Step 4: Burn out the remaining gas.
How do you maintain a snowblower after winter?
Here are the steps to take. Run the engine dry. The single-most important task to guarantee starting next winter is how you deal with remaining fuel now. Change the oil. Swap out the spark plug. Stock up on spare parts. Tighten fasteners. Check the tires. Take care with batteries.
How do you maintain a snow blower?
Maintain Your Snow blower – 8 Things to Do Before the Snow Flies Change the Spark Plug. Disconnect the plug from the lead, and remove it with a wrench. Inspect the Belts. Give the Paddles Their Due. Check the Shave Plate. Flip the Skid Shoes. See if the Shear Pins are Damaged. Change the Oil. Use Fresh Gas with Stabilizer.
Is it OK to leave gas in snowblower over summer?
Storing fuel long-term in any type of gas engine is not recommended because of the issues caused by old gas corroding and gunk building up inside your tank. To avoid this hassle and be sure there’s no fuel left in the system, simply run the snowblower until the remaining gas burns out.
Is it better to drain gas or use stabilizer?
If draining the tank becomes a yearly habit, there’s a good chance you’re shortening the lifespan of your lawn mower and other tools. There’s a much easier way to properly store your lawn equipment. To avoid damage, simply use a quality fuel stabilizer and fresh fuel before putting equipment away for the season.
How long can gas stay in snow blower?
Seasonal or Long Term Storage Drain all the gasoline from the fuel system (including the fuel tank) by following the instructions in the owner’s manual. Do not allow gasoline (with or without stabilizer) to remain in your snow blower/ snow thrower for more than 90 days of inactivity.
How long does it take for a snowblower to run out of gas?
It is very unlikely that a snowblower will do better. There are 6.5 lb of gasoline per gallon, so 3.25 lb of gasoline (a 1/2 US gallon) will last no longer than 3.25/2 = 1.65 hrs; probably more like 1 hour!.
What happens if you prime a snowblower too much?
Priming the engine moves fuel through the fuel lines and into the carburetor. Our Toro snowblower recommends pressing the primer button twice. We’ve found it actually requires more like 8-10 pumps to get going. Be careful not to over-prime, however, since it can flood the engine.
Where should I place my snowblower in the winter?
However, it’s always best to store your snowblower in a clean, dry area, so consider keeping it in a storage unit if you don’t have a garage or shed. It’s time to breathe a sigh of relief—you’re done fighting mounds of snow for another year.
How long should you let a snowblower warm up?
5 -10 minutes.
How often should I change the spark plug in my snowblower?
Spark plugs need to be replaced once per season, or after 100 hours of use. It’s a good idea to clean your spark plug every 20-30 hours of use and check its gap. This way it stays clean, and if it needs to be changed sooner, you’ll know.
How often should I put oil in my snowblower?
How often should you change oil in a snow blower: With normal usage you only have to change the snowblower oil at the end of the season, so one time per year. Don’t use oil in your blower for more than 2 years, as it can make starting your engine really hard in the new season.
How do you clean a snowblower after use?
After use, run the snow blower for a few moments to clear out snow and to prevent freeze-up of the auger or impeller. Sweep off the machine and dry it with a cloth to help keep melting snow and ice from causing corrosion or rust.
How do you start a snowblower with old gas?
Add fuel stabilizer to the gas tank. To dissolve it, try adding fuel stabilizer (view example on Amazon), a gasoline treatment product that helps liquefy residue. Add fuel stabilizer to the snow blower’s gas tank at the rate specified on the container, and then try to start the machine.
