Table of Contents
How thick does a concrete floor need to be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks.
Is it cheaper to pour your own concrete?
Whether you’re pouring concrete countertops or a patio out back, it may be cheaper to pour concrete yourself rather than hiring someone. Whether you’ll save much in doing so depends largely on the amount of concrete needed and the amount of time you have to invest in your concrete project.
Is it hard to pour a concrete floor?
Pouring a concrete floor is hard work, and it takes skill, strength and tools. You may wish to have this job done by a pro, but you can do it yourself. A concrete slab on which a building is erected is a fairly simple concrete pour, but it takes more work in creating the forms needed to hold the concrete.
Do you need gravel under concrete?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.
Can you pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
How much does it cost to pour a 24×24 slab of concrete?
A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.
How many bags of concrete do I need for a 10×10 slab?
Regarding this, “how many bags of concrete do I need for a 10×10 slab?”, at 4 inches thick, generally you will need approximately either 74 bags of 60lb or 56 bags of 80lb premixed concrete for a 10×10 slab, at 5 inches thick slab, either 93 bags of 60lb or 70 bags of 80lb premixed concrete are required, while at 6.
How many bags of cement do I need for 12×12?
To determine how many bags of concrete you will need, divide the total cubic yards needed by the yields, at 4 inch thick, for a 12×12 slab you will need 1.76 yards of concrete, so number of 80lb bag of concrete = 1.76 ÷ 0.022 = 80 bags, No. of 60lb bag = 1.76 ÷ 0.017 = 104 bags & No.
How many 80lb bags of concrete make a yard?
One 80lbs bag of Quikrete Concrete Mix will yield approximately . 60 cu ft. So it will take 45 bag to equal one cubic yard of concrete.
How much does a 30×50 concrete slab cost?
The base cost of material for a 30×50 concrete slab is between $2.83 and $5.47 per square foot. The total cost may range from $4,245 to $8,205. However, hiring a contractor may cost between $6 and $8 per square foot, bringing the price range to $9,000 to $12,000. The biggest cost is the material.
Can you do concrete work yourself?
Pouring a concrete slab yourself can be a big money-saver or big mistake. We show you the best techniques and tools so you get concrete forms right the first time.
Does a 4 inch slab need rebar?
Rebar is not necessary for every concrete project. The general rule of thumb is that if you are pouring concrete that is more than 5 inches in depth, you are probably going to want to add in some rebar to help reinforce the entire structure.
How long does concrete need to set?
Concrete typically takes 24 to 48 hours to dry enough for you to walk or drive on it. However, concrete drying is a continuous and fluid event, and usually reaches its full effective strength after about 28 days. Here are some of the basic facts regarding the question of concrete drying time.
Is sand a good base for concrete?
Simply put, sand isn’t sturdy enough to work well as a subbase for something like a driveway. It is also difficult to maintain a level sand surface when pouring concrete, and therefore difficult to maintain a uniform thickness of the concrete slab.
How many inches of gravel do you need for a concrete slab?
How Much Gravel Do You Put Under a Concrete Slab? You will need 3 inches of gravel under a concrete slab that is 4 inches thick. More gravel is better, but 3 inches is the minimum amount of gravel you should have with a 4” slab. Use ¾” washed and screened gravel, then compact it to level.
Can you pour concrete over gravel?
Laying a concrete driveway over an existing gravel one is possible, but it is not generally recommended. However, if the gravel in your driveway is small enough, it is possible to create a cement driveway over the existing one.
What is the minimum thickness of a concrete foundation?
For masonry or concrete construction, the minimum foundation wall will be 6 inches. The minimum reinforced concrete footing thickness will be 6 inches or 1-1/2 times the length of the footing projection from the foundation wall, whichever is greater. REQUIREMENTS.
How much does a 40×60 concrete slab cost?
How much does a 40×60 concrete slab cost? It would be about $8,500 to $12,000 for a 40×60 foot concrete slab, 6 inches thick. That’s based on national averages of around $5 per square foot for a fully engineered, finished concrete slab, including labor and materials.
How much is a truck of concrete?
The average cost of concrete delivery is $119 to $147 per cubic yard for a full 10-yard truckload of ready-mix concrete, and $172 per yard for a short-load of less than 10 yards. The cost of concrete to pour a sidewalk is $255 to $320, while a driveway or garage slab runs $1,060 to $1,270.
Why is concrete so expensive?
As more areas become industrialized—and as there grows a greater need for durable building materials to withstand severe weather and long-term wear—the demand for concrete has significantly increased. This alone has affected the price of concrete over the years.
