Table of Contents
Locate the small hole at the bottom of the main drain. This is the plumbing line to the filter. Plug the small hole with an expandable rubber plug or a plastic threaded plug, if the hole is threaded. Replace the main drain lid if needed.
Is a pool main drain necessary?
Main drains are not required in an inground swimming pool, however, they are strongly recommended and can be extremely useful in some circumstances. This is useful when replacing your pool liner. Main drains are also helpful in the filtering of water and dirt from the bottom of the pool.
What is the main drain on inground pool?
The main drain for a pool is a suction port that should be located at the deepest point on the pool floor. A main drain is responsible for aiding in the circulation and filtration of the pool water. Having a properly working and dedicated main drain line can also allow you to fully drain your pool if necessary.
Where are pool drain plugs?
Pool Heaters typically have 2 plugs, a drain plug in the front header and the rear header. Heat pumps usually have a small plug on the lower exiting pipe, but sometimes not, many are drained at the unions.
Can pool main drain get clogged?
A pool’s main drain can become clogged with debris. Your swimming pool’s main drain requires regular maintenance. Although the rest of the pool’s parts, such as the filter, may seem to be working just fine, the drain is always at risk of getting clogged.
How do you know if your main drain is leaking?
Symptoms of a leaky sewer pipe The sound of trickling water. If you hear water trickling somewhere, check the toilet and make sure all the faucets are off. Damaged floor. Bad smells. Cracks in foundation or walls. Unusually healthy vegetation. Rodents or insects. Moldy walls. Sluggish drains.
What does drain at bottom of pool do?
Main Drain: The main drain is typically located at the deepest point of the pool and is used to lower the water level, however its primary purpose is to circulate water from the bottom of the pool.
What is the purpose of a pool main drain?
The main drain is the primary way that water is drawn from your pool into the pump and filter. The main drain is located on the bottom of the pool in the deepest part. Most pools have one, but larger pools may have multiple main drains. Main drains must be protected by an approved cover.
How do you install a main drain in an inground pool?
THE SWIMMING POOL MAIN DRAINS MUST BE SET IN CONCRETE. To install your inground pool kit plumbing lines, dig a small trench in the hopper, starting at the main drain, crossing the hopper, up the side or back wall slope (whichever is closest to the filter), and out under a panel. Set your line, cover and tamp.
Should the main drain on a pool be open or closed?
For proper water circulation, it is best to position the flap so that it is about 2/3 closed. This will allow for more flow through the main drain than through the skimmer, which will promote a “bottom-to-top” circulation throughout the pool.
Should I Use main drain or skimmers?
Skimmer Vs. Drain. If the pool receives a lot of leaves and other debris, more suction may be required at the skimmer than the main drain to adequately strain debris floating on the surface. Conversely, if dirt on the bottom of the pool is the principal contaminant, more suction is required at the main drain.
How do I know if my main drain is working?
Multiple plumbing fixtures in your home clogging or backing up at the same time is a telltale sign of a sewer line clog. If you notice when you flush the toilet that water backs up into the shower, you likely have a mainline clog.
How do you unblock underground drain pipe?
What if I’m trying to unblock a drainpipe? Pour boiling water down the drain. Add a cup of bicarbonate of soda. Now add a cup of vinegar and watch it start to fizz and froth. Replace the drain cover loosely and let it work its magic for a few hours. Repeat until you make headway.
Can you snake a pool drain?
Also, do not try using a plumber’s “snake.” A snake typically doesn’t work on pool pipes because pools use 90-degree elbows and house plumbing uses 90-degree “sweeps,” which allow the snake to round the corners. Also, a sewer-line snake should not be used on a pool for sanitary reasons.
Is my main sewer line clogged?
If more than one of these drains is slow-moving, is gurgling, has a foul smell, or has water backing up, that is signs of a clogged sewer line. Slow-flowing water is an indication that your main sewer line may have become clogged. Eventually, the wastewater is forced to back up other drain lines.
How do you know if your main sewer line is broken?
What are the Signs of Sewer Line Repair? Sewage Backup. One of the most common signs of sewer line problems is water backing up in one area of your home. Foul Smell. Another sign of disrepair is a bad smell. Slow Drains. Mold Growth. Lush Grass. Cracks in Your Foundation. Pest Invasion. Do Your Research.
