Table of Contents
Can you open the doors on a gas fireplace?
The glass doors should be closed as the fire dies down to minimize the amount of room air going up the fireplace chimney. When burning gas logs in a wood-burning fireplace, the glass doors should always be fully open when the gas logs are burning.
How do you open bifold fireplace doors?
Take hold of each door, lifting up until the bottom pin clears the bottom receiving hole in the fireplace. Carefully angle the bottom out of the folded door toward the middle of the fireplace until it can be pulled away from the receiving hole.
How do you open an enclosed gas fireplace?
Turn the knob from the “Off” to the “Pilot” position. Push in the pilot knob, which manually sends gas into the system. Push the igniter button once every second until it lights. Depending on how long it’s been since the gas fireplace was last used, ignition may take multiple attempts.
How do you open a electric fireplace door?
All you need to do is find the front of your fireplace and then open it up by turning the handle that should be located on one side or another. You can then push forward with your hands or pull back if there’s a latch on this side, to get it fully opened so you can see what’s inside.
Do I need a door on a gas fireplace?
Vented gas logs are designed to be used in a fireplace that is capable of burning wood and is directly connected to a chimney (better known as a masonry fireplace). Because of the damper position requirement, the use of masonry fireplace glass doors is required with a vented gas log setup.
What is the purpose of glass doors on a gas fireplace?
Glass doors actually help your fire burn better. By enclosing the burning area, firewood is able to burn greater and produce more heat. The glass doors also absorb and radiate heat into the room better than a fireplace without doors.
How do I remove my fireplace doors?
Steps to Remove the Door Completely open each door to their respective sides. Push up on the top clip to reduce the pressure so that you can get the door pin out of the clip. Grab the each door and lift up the door until the “bottom door pin” can clear the “bottom receiving hole” located on the fireplace.
How do you open a fireplace flue?
You should turn the knob clockwise, as far as it can go, or push the rod all the way up to open the damper. If there is a metal chain in or besides your fireplace, it means that your chimney has a top-mounted damper. If the chain is tightly attached to a hook, the damper is closed.
How do you clean fireplace doors?
Use vinegar solution: Try a homemade soot-cleaning solution made of ammonia and vinegar (1 cup vinegar, 3 cups warm water and 1 tablespoon of ammonia). Spray solution onto the glass and let sit for 30 seconds. With a clean cotton cloth, scrub in a circular motion until soot is loosened.
How do you know if the flue is open?
Conduct a visual check. Lean in under your chimney just outside of your wood burning stove. You should find a metal device just within the chimney or flue opening. The damper is open if you can see through the damper up to your chimney. If you only see a metal plate, the damper is in a closed position.
How do you tell if the flue is open on a gas fireplace?
Feel the Breeze Feeling the breeze is another method you can use to know whether you have an open or closed flue. Locate your hand inside the fireplace and wait to notice if you can feel the air flowing. When the flue is open, air will flow down the chimney.
What is the lever on the side of my fireplace?
What is this? The second handle you may find in your fireplace (usually located on the left inside panel) is a control lever for the outside air kit. When burning your fireplace, the outside air kit lever should always be in the open (or up) position.
How do you remove an electric fireplace insert?
To remove an electric fireplace insert, check for any connections holding the insert in place and remove them, and pull the electric insert out of where it currently sits until the electrical connection can be seen. Unplug the electric insert from the outlet and pull the electric insert out completely.
Where do the crystals go in an electric fireplace?
If you want a more contemporary looking fireplace, use just the crystals. They just lay in the trough area. If you want a more traditional looking fire, place the log pieces in the order as shown in the directions. Once you have those in-place you can fill the void areas of the trough with crystals.
Do you have to have glass on a gas fireplace?
Direct vent fireplaces are sealed combustion systems and need the glass on to function properly. The other type of gas fireplaces we sell, called B-vent fireplaces, come with fixed, not sealed, glass fronts.
Can you change fireplace doors?
Surprisingly, the answer is yes! Some replacement fireplace doors come with a frame, and others do not. Let us explain: Replacement doors that do not come with a frame are for prefab or zero clearance fireplaces.
