Table of Contents
Simply insert a penny into your tire’s tread groove with Lincoln’s head upside down and facing you. If you can see all of Lincoln’s head, your tread depth is less than 2/32 inch and it’s time to replace your tires.
How thick should tire tread be?
New tires typically come with 10/32” or 11/32” tread depths, and some truck, SUV and winter tires may have deeper tread depths than other models. The U.S. Department of Transportation recommends replacing tires when they reach 2/32”, and many states legally require tires to be replaced at this depth.
Is 9/32 A good tire tread depth?
New tires have an average tread depth of 8 to 9 millimeters (10/32 to 11/32 inches). As you drive, the tread will wear down. A tire with a tread depth below 1.6 millimeters (2/32 inches) lacks grip. Braking distance and vehicle control are impaired.
Is 7 32 A good tire tread depth?
A tread depth gauge is the most accurate way. 6/32″ or higher: Your tire’s tread depth is sufficient. 5/32″: If snow-covered roads are a concern, you should consider replacing your tires. 4/32″: If you frequently drive on wet roads, consider replacing your tires.
Is 60 percent tire tread good?
Used tires tread can be up to 90%, but the average is 6-8/32”. Tires in good condition should have a minimum of 6/32” to be useful, or 4/32” if the tire is 13-14”. The average legal minimum tread depth is 2/32”, but driving becomes unsafe with such a tread.
What is a good tread depth for winter tires?
winter tires should have a tread depth of at least 4 millimeters (5/32 inches). They need to be thicker to handle wet, icy, and snowy conditions.
Is 80 percent tire tread good?
Here’s what the heck that means: 2/32nds of tread is the legal minimum of tread you need on your tires to pass inspection in most states. Most tires have 10/32nds of tread when new, and when 80 percent of the tread has worn down, or its reached 2/32nds, it’s time for new tires.
How often should tires be replaced?
When Should You Replace Your Vehicle’s Tires? As a general rule, the National Highway Traffic Safety Administration (NHTSA) recommends that drivers change the tires on their vehicles every six years.
Is the penny test for tires accurate?
For years, motorists have been told the “penny test” is an accurate indicator of whether or not you need new tires. The test is conducted by sticking a penny head down in a tire tread; if you see all of Lincoln’s head, then you should change the tires. The one with an eighth of an inch of tread stopped in 300 feet.
Should I replace tires at 4 32?
The Tire Rack’s advice is that if rain and wet roads are a concern, you should consider replacing your tires when they reach approximately 4/32″ of remaining tread depth. Since water can’t be compressed, you need enough tread depth to allow the rain to escape through the tire’s grooves.
How good is 6 32 tread?
6/32” Your tire’s tread depth is sufficient for 3-seasons but nearing minimum for a winter tire. 5/32” If wet roads are a concern, consider replacing your tires. If it’s a winter tire, 4/32” is the minimum. 2/32” Your tires are legally bald and need to be replaced.
How much is 7 32 tread?
Tire Tread Depth Conversion /32″, Inch, MM Fraction /32″s Inch MM 7/32″ 0.219 5.56 8/32″ 0.250 6.35 9/32″ 0.281 7.14 10/32″ 0.313 7.94.
What percentage tread is 8 32?
8/32″ of useable tread depth. A tire that starts with 10/32″ of original tread depth has 12.5% wear for every 1/32″ that is worn away, and a tire that starts with 12/32″ ” of original tread depth, has 10% wear for every 1/32″ that is worn away, etc.
How many miles are tires good for?
Your tires should last 50,000 to 60,000 miles on average. But that really depends on the manufacturer. Some manufacturers build their tires to last up to 80,000 miles, while some design their tires to last as little as 30,000 miles. You can see how many miles to expect out of a tire by checking its treadwear rating.
What does 32nds mean?
adjective. the ordinal number of thirty-two in counting order. synonyms: thirty-second ordinal. being or denoting a numerical order in a series.
What is the penny trick for tires?
The Penny Test Insert a penny with Lincoln’s head upside down into a tire tread groove. If Lincoln’s head is covered and no longer visible between the grooves, your tread depth is good. If you can see all of Lincoln’s face, it means that the tire tread is 2/32 inches deep or less and it’s time to replace them.
How do you check tire tread with toonie?
Put the outside edge of the toonie in your tire’s tread. If the tread reaches the bear’s paws, your tires are probably pretty new. If it reaches all the way across the silver, they’re about 50% worn. If your tire tread reaches only about half-way into the letters, it’s time to shop for new tires.
