Table of Contents
What are boat lift bunks made of?
Vinyl Aluminum Bunks The full support “C” channel bunks are covered with high-quality marine-grade vinyl for additional protection and durability. The vinyl keeps the aluminum from marrying the bottom of your boat: sand and debris don’t adhere to the bunks easily, and it rinses clean.
How far apart are bunks on a boat lift?
The outer bunks are 66″ apart from each other. This allows the hull to ride approximately 3″ above the cross beam and eliminates the chance of rubbing.
Is it OK to leave boat lift in water?
Leaving your boat lift in the water could result in damage from freezing conditions, especially if you live in an area where ice movement is common. A wheel kit from ShoreMaster can make boat lift removal as easy as rolling it out of the water, and your boat lift can easily sit on those wheels or its pads.
How long should pontoon bunks be?
There isn’t an exact length of bunk boards that are required for pontoon boat bunks but in general around 75 percent of the length of the boat should be the length of the pontoons and you’ll be good. So for a pontoon boat that measures 16 feet your best bunk length would be right at 12 feet.
What is pontoon bunks?
Most pontoon trailers have 2” x 4” wooden bunks. They are usually lag bolted from beneath, through the bunk brackets into the wood. Most companies use full length bunks. On a launching ramp with a steep angle the pontoon boat nose cone could potentially get wedged in the space not covered by bunks.
What is a bunk on a boat lift?
Vinyl / Aluminum Bunks ShoreMaster Boat Lift Bunks are designed to provide safe, non-marring protection of your boat’s hull, or your pontoons, while the watercraft is stored on the boat lift.
How long should boat bunks be?
Ideally, the bunk boards should be at least half as long as your boat and run from the stern (or a few inches beyond it) to the bow as far forward as you like.
What kind of wood do you use for boat trailer bunks?
For wood, pressure-treated pine is the industry standard for trailer bunks. Popular alternatives are oak, cypress and other hardwoods that add even more durability. Composite boards used for patio decking are other options, but pressure-treated pine is a proven material with economic benefits.
How do you put bunks on a boat trailer?
Start at the most forward point of the bunk, raise the bunk until it touches the bottom of your boat and tighten until the bunk is in place. Repeat this step moving down your trailer until all of the bunks are touching the bottom of your boat, and are secured in place.
How do you center a boat on a lift?
Switch on your blower motor and place your valve handle levers in the lift/launch position. Quickly grab the bow of your boat and center the bow over the hoist frame and push the boat back against the guide ropes. The guide ropes will align the boat over the hoist fore and aft and will also center the rear of the boat.
Can I leave boat on lift over winter?
Many people choose to leave hydraulic boat lifts in over the winter. This is possible in areas where ice flows aren’t a concern. However, it is only possible so long as you properly flush the lines to ensure there is no moisture, and verify that the hydraulic fluid is formulated for winter weather conditions.
Can you store a boat on the lift?
By storing your boat on a lift, you will gain valuable time back on the water. A boat lift minimizes maintenance to save you time and money in the long haul. A boat lift keeps your boat ready go at a moment’s notice, so you can step aboard and enjoy the great blue yonder!Nov 9, 2020.
What do you do with a boat in the winter?
Follow this winter boat storage checklist to make sure your boat is properly winterized for storage.How to Store a Boat for Winter Run your boat once more. Drain your boat. Clean your boat. Winterize the engine. Lubricate moving parts. Remove and charge the battery. Remove sensitive materials. Seal exhaust ports.
What kind of trailer is needed for pontoon boat?
Bunk-Style Trailers They are recommended for all pontoon owners that plan on trailering the boat more than 10-15 miles down the road. If you travel with your boat, this is the trailer to have. This style can be built for pontoons with two or three tubes.
How far apart are pontoon bunks?
Most pontoon boats with 8′ wide decks usually have 72” bunk centers. Most pontoon boats with 8’6” wide decks usually have 77” bunk centers.
Is it hard to load a pontoon boat?
Loading your pontoon boat can be difficult and time-consuming, no matter how experienced you are. Fortunately, there are many trailers on the market designed to reduce the stress that comes with trailering your boat. Easy-load boat trailers are equipped with guides and rails that help you get a perfect load every time.
