Table of Contents
10 Tips to Make Your Swamp Cooler Colder and More Efficient Use Your Swamp Cooler in a Dry Climate. Use Your Swamp Cooler Seasonally. Open the Windows. Run a Dehumidifier. Cultivate a Green Thumb. Experiment With Positioning. Prime the Pads First. Use Cold Water.
How can I make my swamp cooler more effective?
Increase Your Swamp Cooler’s Efficiency in Four Simple Steps Open the Window. Make Sure the Tank is Full and Pads are Wet. Allow Cooler to Run Before Turning on Blower. Clean the Cooler Regularly.
Why is my swamp cooler not getting cold?
Probably the single most common reason your swamp cooler is not blowing cold air is that the circuit breaker has tripped or the fuse has blown. These are installed so as to avoid electrical damage to the unit, so it doesn’t get fried in the case of an electrical overload.
Can you add ice to swamp cooler?
In actual practice, adding ice to your swamp cooler only has a limited effect. It’s the combination of temperature and humidity in the ambient air that determines how much of a boost ice provides, not the ice itself. In fact, adding ice to your evaporative cooler might actually hamper the cooling process.
At what temperature does a swamp cooler become ineffective?
A wet bulb temperature above 70 degrees Fahrenheit (21 degrees Celsius) means the swamp cooler won’t be able to adjust the temperature enough to keep it in the comfort zone. (This varies based on humidity, personal preference and activity, but it generally falls in the low 70s.).
How many windows should be open when using a swamp cooler?
Open the windows or vents on the leeward side of the house to provide 1 to 2 square feet of opening for each 1,000 cfm of cooling capacity.
Should you open windows with a swamp cooler?
Climate control inside a home with an evaporative cooler depends on proper air balance. A window should be open just enough to allow air pressure inside a room to slowly and quietly close the door to that room. If the door closes forcefully, there is too little exhaust and the window should be opened wider.
Do swamp coolers work in 100 degree weather?
Here’s the deal: your swamp cooler will only cool your home by about 10 degrees. In addition, it will struggle immensely, and likely will not work at all, when its humid outside. However, it will do a better job of cooling, and in humid weather your refrigerated air system will cool and dehumidify.
How often should swamp cooler pads be replaced?
These pads usually get hard water mineral buildup over time. So it’s important to clean them every year and replace every 3-5 years depending on how hard your water is.
What to do if cooler is not cooling?
Another effective way of increasing the cooling efficiency is by adding ice to the water in the tank. Many people have already tried it with their coolers. In fact, some coolers also come with dedicated ice compartments. Adding ice to the water makes the pads cooler, resulting in cool air passing through them.
Can you put fabric softener in a swamp cooler?
Many websites recommend putting fabric softener in your swamp cooler to eliminate or mask smells, but from a health standpoint, synthetic fragrances contain Endocrine Disrupting Chemicals or EDCs.
Does cold water make a swamp cooler colder?
8. Use Cold Water. Though you might think that hot water would evaporate more quickly since it’s closer to the boiling point (at which water dissipates into the air really fast), cool to room temperature water actually works better.
How long will ice last in a swamp cooler?
Three 10 pound bags of ice will last approximately 2-3 hours depending on the quality of the ice and outside temperature. If you need longer run times simply throw in another bag and off you go.
Does swamp cooler work in 110 degrees?
Evaporative coolers are limited in that they can only lower the temperature a few degrees below the ambient temperature of the room. If it’s 110 degrees outside, you need to lower the temperature inside by more than a few degrees. In places where triple digit heat is the norm, refrigerated air is a better choice.
Do swamp coolers work?
A swamp cooler is energy-efficient and an affordable cooling devices but they only work well in certain areas where there is low humidity. When the humidity level hits 30% l swamp coolers are going to slow up their cooling capacity, and when you hit 35% they basically stop cooling.
At what percent humidity do swamp coolers stop working?
When the outdoor humidity gets over 70-80%, you’ll reach the limitation of a swamp cooler.
How do you prevent calcium build up in a swamp cooler?
Regular Maintenance Use Quality Pads. The quality of cooler pads you use on your evaporative cooling unit determines your coolant’s ability to prevent deposit accumulation. Clean the Cooler Regularly. Add a Bleed-Off Valve. Shut the Evaporative Cooler.
Can you run AC and swamp cooler at the same time?
Never use both your AC and your Swamp Cooler at the same time. Due to their different technologies they actually make each other work harder and sort of cancel each other out in some situations. So one at a time. Swamp Coolers work most effectively during the middle of the day, when it is hottest and driest.
Can you leave evaporative cooling on overnight?
Using Evaporative Air Conditioning in a Heatwave You can keep it running 24/7 until the hot spell ends. You can turn the aircon on to fan only over night if the night temperatures are in the mid 20s or keep it running over night if the temperature are close to 30 degrees.
Is it OK to run a swamp cooler 24 7?
Don’t Use the Swamp Cooler All Day The swamp cooler can preserve water when it’s not running as often so you can safely leave your pets for an afternoon or even the entire day.
Can you put a filter on a swamp cooler?
Most evaporative coolers do not have air filters as original equipment, but they can be fitted to the cooler during or after installation.
