Table of Contents
Steps to Follow When Building a Retaining Wall on a Slope Step #1: Get the Trench Compact and Level. Step #2: Install the Wall Rock. Step #3: Excavate the Second Level. Step #4: Place the Base Course of Blocks. Step #5: Compact the Wall Rock Behind the Blocks. Step #6: Fill in the Step Up Areas.
Does a 2 foot retaining wall need drainage?
These walls need a drainage system regardless of the wall height. If there are poor draining soils such as clay behind the wall, there needs to be drainage incorporated the wall system. Clay when wet is very weak, so it is essential to provide a way for water to escape from behind the wall.
Do you have to build a retaining wall on a slope?
You Might Need a Retaining Wall If… Retaining walls minimize erosion by decreasing the angle of a slope and holding back soil. Erosion can threaten your home’s foundation. If the soil around a downhill foundation is washing away, or erosion from a slope is compacting an uphill foundation, a retaining wall can help.
What is the easiest retaining wall to build?
For the average do-it-yourselfer, building a retaining wall is easiest when using masonry blocks that will be stacked no taller than three feet, with no mortar binding the stones or concrete members.
What is the cheapest way to build a retaining wall?
The cheapest type of retaining wall is poured concrete. Prices start at $4.30 per square foot for poured concrete, $5.65 for interlocking concrete block, $6.15 for pressure-treated pine, and about $11 for stone. Installation or supplies, such as drainage stone or filter fabric, are not included.
How far apart should posts be for a retaining wall?
Retaining wall posts should be at least three feet apart. The distance can be slightly longer or shorter if it works better with your measurements. However, you shouldn’t go more than seven feet apart to make sure your wall is sturdy enough.
How deep should the footing be for a retaining wall?
The general rule of thumb is to bury about one-eighth of the height of the wall. For example, if your wall will be three feet (36 inches) tall, the first course of blocks should start five inches below soil level. The gravel base should start three inches below this.
How deep do you have to dig for a retaining wall?
The trench should be deep enough to bury at least half the height of your first course of blocks as they sit on a 2- to 3-inch base of gravel. Depending on the size of your blocks, this depth will be about 4 to 6 inches. The trench should be twice as wide as a single block.
How much of a slope requires a retaining wall?
All retaining walls should lean into the hill 1 inch for every 12 inches of height. Timber walls 4 feet or higher should be tied to the hillside with “deadmen” anchors (6-foot-long, T-shaped tiebacks buried in the hillside) attached to the wall every 8 feet, extending 6 feet back to a 2-foot-wide T-bar.
How many deadmans are needed for a retaining wall?
Install one dead man every 6 to 8 feet around the entire wall. Continue building up the retaining wall, using landscaping screws to secure each timber. Cover the ground in front of the retaining wall with 2 to 4 inches of bark mulch.
What can I do instead of a retaining wall?
Reinforced Soil Slopes. Reinforced soil slopes are a quick and easy construction style that uses a geotextile, such as polyethylene or polypropylene, to lock existing soil into place to create a reinforced mass. Natural Stone Walls. Wooden Timbers. Gabion Walls. Soil Bioengineered Walls.
Is wood retaining wall cheaper?
The cheapest types of retaining walls are wood and concrete blocks, followed by concrete and stones or bricks. Each material has benefits and drawbacks, including strength, longevity, and attractiveness.
Do you need plastic behind retaining wall?
Re: Retaining wall with no plastic sheeting – incorrect? You should have good drainage either through the wall or behind the wall as you shouldn’t let water build up behind the wall. Up to now its probably been the same cost for the ag pipe and stone.
How tall can a retaining wall be built?
A retaining wall can reach heights of over ten feet depending on the size of your project. That said, most cities require a permit for walls over three feet tall, so remember to check your local building codes before breaking ground.
Do you need rebar in a block wall?
Wall Size. A freestanding garden wall or block privacy fence will require less reinforcing than a basement or other load-bearing wall in a house or other building. An 8-foot-high wall will obviously require more rebar than a 4-foot wall. Very short walls, under 4 feet and laid with mortar, may not require any rebar.
Can you put retaining wall on concrete?
While you can build a retaining wall on concrete, it isn’t that straightforward. If you have an existing concrete base, you cannot just build your wall on top of it. Without being secured into the concrete, your wall will slide due to the soil pressure against the wall.
How do you build a retaining wall with uneven ground?
Step 1: Install Stakes and Attach String. Step 2: Level the String. Step 3: Dig Retaining Wall Trench. Step 4: Tamp Soil and Add Gravel. Step 5: Add Sand and Wall Blocks. Step 6: Add Second Row of Blocks. Step 7: Pour Gravel and Spread Fabric.
