Table of Contents
DIY Hot Tub Cover – Make Your Own Spa Cover Materials Needed to Make Your Own Spa Cover. 2- 2″ thick 4×8′ Polystyrene Foam Boards. STEP ONE: MEASURE YOUR SPA. STEP TWO: CUT THE MATERIALS. STEP THREE: WRAP THE FOAM IN HEAVY PLASTIC. STEP FOUR: GLUE THE FOAM TO THE WOOD BOARDS. STEP FIVE: PAINT THE WOOD AND INSTALL THE HINGE.
Can I use a tarp to cover my hot tub?
Your hot tub water won’t stay warm under a plastic tarp cover. It will stay clean, though, if you secure the tarp. The extra kitchen table that’s taking up room in your garage can be used as a temporary hot tub cover if it’s not too heavy.
What are hot tub lids made of?
Specification: Marine grade vinyl, treated against mildew. Top quality stitching using marine grade polyester thread and filled with top rated insulation. 4″ to 3″ tappered foam to allow water run off (101mm to 76mm). skirt length of your choice. Full Heat Lock Hinge to prevent heat loss through the cover hinge.
How do you make a hot tub cover last?
To that end, here are six simple tips that can extend the life of your hot tub cover by up to three years! Clean your spa cover regularly. Apply a vinyl protectant spray. Use a cover lift to prevent damage. Avoid extreme exposure to the elements. Keep kids and pets off the cover. Don’t forget about the underside.
Can I leave my hot tub uncovered?
leave your spa uncovered Besides getting dirty, wasting water and chemicals, and causing your spa heater to work overtime, leaving a spa uncovered and unattended is unsafe for children, animals and some adults.
Is it good to leave hot tub uncovered?
Use your hot tub cover and/or floating blanket as much as possible. Leaving the hot tub uncovered results in the most water evaporation due to the high water temperature (warm water evaporates quickly). No cannonballs in the hot tub. Splashing and jumping causes water to splash out of the hot tub.
What can I use to cover my hot tub?
A spa cover, cover lifter, and umbrella will protect your hot tub year-round. A top quality spa, including every Hot Spring® spa, will come with a cover that should be used whenever the hot tub isn’t occupied.
What type of foam is used in hot tub covers?
Expanded polystyrene (EPS), commonly known as polystyrene, is the standard filler material for hot tub covers because of its insulation capacity, rigidity, and resistance to moisture.
How long do hot tub covers last?
How long does a hot tub cover last? On average, a hot tub or swim spa cover will need to be replaced every 5–7 years. While some covers are built to last much longer than others, any object that is subjected to the elements will eventually show signs of wear.
Can I use Armor All on my hot tub cover?
Do not use protectants that have petroleum or alcohol in them, like Armor-All, which will damage the vinyl on hot tub covers. Hot tub covers tend to sag after a few years of use and after water seeps into the inner core, which will happen over time.
Can you use car wax on a hot tub?
Re: Auto Detailer Products For Cleaning Hot Tubs I use 303 on my hot tub cover and my car’s convertible soft top. Once a month on each. It’s good stuff. For the spa’s shell, etc, I just wipe it down with a microfiber towel (also from my car care kit).
Can you run a hot tub without water?
Water left in the pipes and equipment can grow bacteria biofilm, which is difficult to eradicate. Plus, without water, seals and gaskets become dry and begin to leak. Therefore, make sure to not leave your hot tub sitting empty.
How often should I open my hot tub cover?
It’s also a good practice to remove the cover periodically to allow trapped moisture and chemicals to evaporate. If you enjoy a soak in your hot tub weekly, you do not need to worry about this, but if you go long periods without use, leave the cover off for about an hour when you treat it.
How long can you leave water in hot tub?
If you do not want to put any chemicals in to your hot tub, no problem. But you must drain down and refill after each use and ensure that the water is never in the spa for more than 12 hours!.
How do you protect a hot tub with rain?
Check your cover stays put in windier weather by using safety straps to keep it secure. There are a variety of hot tub cover straps to choose from, with some including a locking mechanism with a handy little key.
How do I stop rain in my hot tub?
5 Simple Tips To Help You Enjoy Your Hot Tub in the Rain Warm up your bath robe and towel. Wear slippers to keep you from slipping. Shield Yourself From the Rain with an Umbrella or a Hat. Sip On Something Warm. Put Moisturizer on Your Face During Really Cold Times.
Can you replace the styrofoam in a hot tub cover?
You can replace the foam core inserts in any hot tub cover or spa cover. Broken or cracked foam does void the warranty of any cover that The Pros know about, so you will not have any recourse there.
Why do hot tub covers get heavy?
The main reason why the cover gets heavier with time is that the foam core becomes waterlogged. Over time corrosion disintegrate the vapor barrier around the foam cores. A heavy hot tub cover is not only fully protecting your hot tub from the elements but also increasing the cost of running your spa.
Will waterlogged Styrofoam dry out?
Waterlogged Styrofoam is a problem most commonly seen in hot tub and spa covers. You will know if your Styrofoam is waterlogged because it will be much heavier than normal. The waterlogged Styrofoam can be repaired by drying in high sunlight, but it is cheap and more effective to simply replace the Styrofoam.
