QA

How To Make A Concrete Retaining Wall

How thick does a concrete retaining wall need to be?

Base width = 1/2 to 1/3 of the height of the wall. Base thickness = 1/8 of the height of the wall but not less than 12 inches. Stem thickness = 6 inches + ¼ inch for each foot of wall height.

Can you make a retaining wall out of concrete?

Poured concrete retaining walls can be colored, textured, accented with embedded objects and much more. When installed properly, concrete offers much more room for customization than any other retaining wall material. If the wall exceeds four feet in height, footings should be poured separately. Allow concrete to cure.

Are poured concrete walls cheaper than block?

Is a poured concrete foundation cheaper than a block wall foundation? Usually, the cost of construction varies from place to place. But as a matter of fact, poured walls cost about 20% less than the block foundation walls.

Can you build your own retaining wall?

Choose a DIY-friendly building material. Retaining walls can be made from wood, bricks, natural stones or concrete blocks. For DIYers, it’s best to use concrete retaining wall blocks, which can be interlocking and are heavy enough to stay in place without cement or other adhesive.

What is the cheapest way to build a retaining wall?

The cheapest types of retaining walls are wood and concrete blocks, followed by concrete and stones or bricks. Each material has benefits and drawbacks, including strength, longevity, and attractiveness. For those who are planning on building their own retaining wall, it is vital to plan and research.

Do I need a concrete footing for a retaining wall?

A buried structural footing is usually required for larger retaining walls. To create this, a landscaper pours concrete below frost level (the depth to which the ground will freeze during the winter). Footings poured too shallow are prone to shifting and moving if moisture in the soil freezes and heaves.

Does a 2 foot retaining wall need drainage?

These walls need a drainage system regardless of the wall height. If there are poor draining soils such as clay behind the wall, there needs to be drainage incorporated the wall system. Clay when wet is very weak, so it is essential to provide a way for water to escape from behind the wall.

Are poured concrete walls better than block?

Poured concrete wall foundations are arguably stronger than cinder blocks. Poured walls have a better lateral strength, which means they are able to resist more pressure from the water and the soil from the outside. Poured walls tend to be the preferred choice of new construction builders.

What is the easiest retaining wall to build?

For the average do-it-yourselfer, building a retaining wall is easiest when using masonry blocks that will be stacked no taller than three feet, with no mortar binding the stones or concrete members.

How do you build a retaining wall step by step?

Follow these steps to properly install a retaining wall. Dig a level-bottomed trench wide enough for the base stones to fit into. Compact the bottom of the trench with a hand tamper. Lay landscape fabric in the trench. Start the wall’s second layer using a staggered pattern. Make sure the wall is level.

How much weight can a retaining wall hold?

Even small retaining walls have to contain enormous loads. A 4-foot-high, 15-foot-long wall could be holding back as much as 20 tons of saturated soil. Double the wall height to 8 feet, and you would need a wall that’s eight times stronger to do the same job.

How deep should footings be for a retaining wall?

All footings should be a minimum of 150mm (6″) in depth, with the bottom 350 – 400mm (14-16″) below ground level on most soils. For clay soil however, thicker and deeper footings should be used.

How far apart is rebar in concrete walls?

Rebar Placement in Walls Rebar is placed horizontally and vertically in the wall, in a grid pattern. As a minimum, #4 rebar (1/2 inch) is spaced vertically at 36 inches on center, continued to within 8 inches of the top of the wall, placed on the tension side — the inside face — of the wall.

How far should rebar be from concrete?

Reinforcement should also be placed low enough so saw cutting does not cut the reinforcement. For welded wire reinforcement, the Wire Reinforcement Institute recommends steel placement 2 inches below the surface or within the upper third of the slab thickness, whichever is closer to the surface.

How far apart should rebar be in concrete?

Place rebar in a grid pattern with a spacing between bars of approximately 12 inches. In either case, blocks should be used under the reinforcement to keep centered within the concrete. Synthetic fibers have also proven to be beneficial in driveways as a way to reduce shrinkage cracks.

In what way is concrete different from grout or mortar?

Basically concrete is stronger and more durable so it can be used for structural projects such as setting posts whereas mortar is used as a bonding agent for bricks, stones, etc. Concrete is a mixture of water, cement, sand just like mortar.

How much does it cost to build a concrete wall?

Concrete Wall Cost Per Linear Foot Expect to pay between $30 and $40 per linear foot for a concrete wall when working with concrete contractors.

What do you use for drainage behind a retaining wall?

In order to provide proper drainage, at least 12 inches of granular backfill (gravel or a similar aggregate) should be installed directly behind the wall. Compacted native soil can be used to backfill the rest of the space behind the wall.

What can I do instead of a retaining wall?

Reinforced Soil Slopes. Natural Stone Walls. Wooden Timbers. Gabion Walls. Soil Bioengineered Walls.