Table of Contents
Lift the washer onto the ramp and shift it up towards the middle of the beam. Continue sliding the washing machine over the other side of the ramp, down to the pan. Once the back edge of the washing machine is in the pan, slide the 2×4 ramps out from underneath, gently lowering the rest of the washer into place.
How do you put a pan under a washing machine?
Tip it up on one foot put the pan under it. Put it back down, and tip it up on the foot across from it that is in the the pan, pivot the pan around until the first foot is within the pan, put it back down, slide pan and machine into its new home.
How do you lift a washing machine?
Move the hand holding the leg stand at the front to the corner at the back, so you’re holding both sides. Lift the washing machine and let it rest on your leg. Pull the appliance up to your chest and keep your arms at a 45-degree angle.
Can you drain a washing machine into a floor drain?
Draining a washing machine into a floor drain might be okay if it’s properly done and if the floor drain is not connected to a storm sewer. Any connection between the washer and the floor drain should be through appropriate plumbing, so the water is not splashing onto the floor.
How do you install a washing machine floor drain?
Instructions Locate and Cut a Hole in the Floor. Install the Drain in the Floor. Install an Extender Pipe to the Drain Assembly. Install the P-Trap. Cut Into the End-Point Drainage Pipe. Install the Pipe to the ABS Tee.
Can I lift a washing machine on my own?
Tilt the washer to one side and slide the dolly underneath it. Carefully lift it back up, so it rests upright on the dolly. Secure the appliance with rope or moving straps. Move the washing machine.
How do you raise a washing machine off the floor?
Place a washing machine on top of a pedestal drawer to increase the washer’s height. A pedestal drawer is a feature available for most front-loading washing machines and is installed directly below the washer.
Do I need a trap for my washing machine drain?
Your washing machine needs a trap on the drain line because the drainpipe connects to the sewer or septic system. This means the pipe can be a conduit for sewer gas to drift up into your home. Every time your washer drains, some of the water that flows into the pipe is caught in the trap.
Should there be standing water in floor drain?
Yes, floor drains should have water in them. They contain drain traps that keep them clean. Therefore, it is necessary to have a fixed volume of water in your drain. Ideally, many suggest maintaining the water level at least 2-3 inches below the drain.
Can a washing machine drain into 1 1 2 pipe?
Drain and Trap Requirements A 2-inch drain pipe is required for all washing machines. The former requirement of 1 1/2-inch pipe is not enough to handle the fast drainage of modern washers. As with all plumbing fixtures and appliances, a washing machine drain pipe must also contain a P-trap.
How do you hook up a washer and washing machine to the same drain?
Connect the Sink and Washing Machine Insert the drain hose from the washing machine into the top of the sewer pipe. Fit together the p-trap and drainpipe and place them into position between the tailpiece and the sewer pipe. Connect the drainpipe for the sink to the tee inlet.
How do you slow down a washing machine drain?
A solution to your problem is to put a restriction in your washing machine discharge hose to slow down its flow to what your drain can handle. Just don’t slow it down to the point that your washing machine timer times out and goes on to the next step in the cycle!.
What can I use to move my washing machine?
Before moving a washing machine, make sure you have shipping bolts or a foam core, an appliance dolly or hand truck, a wrench or slip-joint pliers, a bucket and some packing tape. Get some moving straps to make the job easier and moving blankets to protect the washing machine from damage.
How do you move a washing machine by yourself?
Here are the preparation steps when moving a washing machine by yourself: Remove any clothes from the washer. Clean out the drum. Dry out the drum. Disconnect the power supply. Shut off the water supply. Drain the hoses that supply water. Remove and pack the hoses that supply water. Empty the washer’s drain hose.
Can you lay a washing machine down?
It’s recommended you always keep a washing machine in an upright position. Laying a washer on its side can cause the inner and outer tubs to bump against each other, which can loosen support pads or damage the suspension. It can also cause the tubs to move out of alignment and alter the way your unit works.
Can I use any pedestal for my washer?
Pedestals are made for front-load washers and dryers. Top-load washers and dryers will be more difficult to unload with the added height of a pedestal. Only use pedestals for side-by-side washer and dryer installations. You cannot use a pedestal to stack a washer and dryer.
How do you move a washing machine without damaging the floor?
First, tilt the appliance backwards enough to slip a thick piece of cardboard (or a piece of carpet) under the two front legs and as far back to the back legs as you can. Next, wiggle the appliance forward a bit until the back legs sit on the cardboard.
