Table of Contents
Are cold air returns necessary in a basement?
I recommend that all basements should have at least 2 supply registers and 1 return register in the basement/equipment area just to keep that area slightly warm or cool and the air fresh. If you are going to finish that area to be used as living space, then more supply and returns will be needed.
How do you run a return air duct?
Step 1: Determine Where the Ducts Will Go. Locate where you want your return air ducts. Step 2: Begin Adding Panning. Go into the basement and locate the holes. Step 3: Enclose New Ductwork. Step 4: Add New Air Return Duct to Furnace. Step 5: Install New Air Filter. Step 6: Install Return Air Register Covers.
How do you install return air ducts in a wall?
Where should the return vent be located?
The best location of the return vents depends on whether the system is heating or cooling the air. If it’s cooling, the return vents should be near the ceiling, where the warm air collects, but if it’s heating, the return vents should draw cool air from the floors.
Can I tap into existing ductwork for basement heat?
Here are a few popular heating options for your basement: Extend Your Ductwork: Tapping into your existing heat and air conditioning system will provide the basement with reliable heat and prevent you from having to maintain separate heaters.
What happens if there is not enough return air?
If there is not enough return air available, your HVAC system will not heat or cool properly. If not enough air is brought back, your HVAC system will not be able to keep up with temperature demands. In some cases, two returns may be necessary to provide enough return air.
Should I open my basement vents in winter?
Closed air vents increase heating costs Those rooms with closed vents will become colder than the rest of the house, forcing your furnace or heat pump to use more energy to try and maintain a consistent temperature. Leave your heating vents open to lower your heating bills this winter.
How big should my return air duct be?
The duct for this system must be sized by using 6 square inches of clear duct area for each 1000 BTU of cooling. Each ton of cooling contains 12,000 BTU. Multiply the tonnage, 3.5, by the total BTU per ton and this will give you the total BTU rating.
Can flexible duct be used for return air?
Flex duct is widely used for return air in commercial air conditioning systems. Flex duct is able to withstand a certain negative pressure of return air. When installed properly, a flex duct is a reliable and convenient ductwork solution. Flex duct often gets a bad rep because of airflow issues.
How big does a return air duct need to be?
In most cases, if you are installing ducts in each room where there is a supply, you will want to go with the same size as your supply vents. If you are installing just one or two return vents, you will want to go with a 12-inch return for 2-ton units and lower. 14- inches for 3 and up.
How far away should a return vent be from a supply vent?
You are correct, the supply should be at one end of the room and the return at the other end.
How much does it cost to add a return vent?
Cost of Return Air Plenums Return Air Plenums Costs Zip Code Basic Best Return Air Plenums – Material Prices $50.00 – $60.00 $95.00 – $105.00 Return Air Plenums – Installation Cost $100.25 – $100.35 $150.00 – $200.00 Return Air Plenums – Total $150.25 – $160.35 $245.00 – $305.00.
Does every room need a cold air return?
While it is a myth that air return grilles are required in each and every room in the house, it is definitely necessary to have more than one of these grilles installed at strategic places in the house. The most important place to have these would be the bedroom.
How many vents should be in a basement?
How many vents should be in a basement? A general rule of thumb is that there is one vent for every 300 sq.
Can you have too many return air vents?
Having several return vents (ideally one in every room, but even two or three is better than just one) creates consistent air pressure. If you have one return vent, your home is fine. Keep the doors to each room open so air can properly circulate.
Do you put a filter in a return vent?
Should you use a filter in your return vent? For most homes, return vents filters are suggested. They typically won’t cause any damage to your HVAC system and are easy to install – there’s no need for an HVAC technician.
Should return air ducts be high or low?
For optimal efficiency, it’s ideal to have return registers installed. To ensure efficiency during the cooling season, your home should have high registers. High return registers draw hot air that rises to the ceiling back into the system to repeat the cooling cycle.
Should air vents in basement be open or closed?
There’s no harm in closing a few basement vents. However, you should make a point of reopening those vents after a day or two of leaving them closed. You should also try and keep the vents on all the other floors of your home open to promote consistent and effective airflow.
