Table of Contents
What do you put under a concrete walkway?
A firm, well-drained base is the key to crack-free concrete. The best plan for a solid base usually includes compacted soil followed by several inches of a base material such as gravel. But the best base depends on climate and soil conditions.
How deep does a concrete walkway need to be?
Sidewalks should be at least 4″ (100mm) in thickness. Simple slabs for small foundations, bases, etc., normally 4″ to 6″ (100mm to150mm) thick, depending on the load they must bear. Slope the walk away from buildings to provide proper drainage.
Do you need wire mesh in concrete sidewalk?
When it comes to concrete, you can’t avoid cracks entirely, but wire mesh reinforcement will help hold the material together when they do occur. Also, it will help evenly distribute the weight of cars on your driveway. The added strength of steel is especially crucial if your subgrade isn’t up to par.
Can you pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
Do I need gravel under concrete?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.
How much does it cost to pour a concrete walkway?
Walkway & Sidewalk Cost. The cost of a concrete walkway can vary widely depending on its size and finish. Most U.S. homeowners pay between $6 and $12 per square foot for installation of a new concrete walkway. Prices can go beyond this if significant grading is required or a complex decorative finish is requested.
How hard is it to pour concrete?
On a small scale, concrete is fairly easy to work with, but installing an entire patio can be a challenge. It is possible to build an attractive concrete patio yourself, but careful planning and preparation is necessary. Once concrete is in place, you’re stuck with it forever; replacement is costly and difficult.
Does 4 inch concrete need rebar?
Rebar is not necessary for every concrete project. The general rule of thumb is that if you are pouring concrete that is more than 5 inches in depth, you are probably going to want to add in some rebar to help reinforce the entire structure.
How much is a roll of wire mesh for concrete?
Concrete Wire Mesh Prices Minimum Cost Maximum Cost Rolled Concrete Wire Mesh $0.14/sf $0.40/sf Flat Concrete Wire Mesh $0.25/sf $0.60/sf Labor Costs $0.80/sf $1.50/sf Total $0.94/sf $2.10/sf.
Is wire mesh better than rebar?
Considering the support constraint, rebar is undoubtedly stronger than wire mesh. Several constructors consider rebar for domestic jobs. For thicker driveways and locations that involve greater traffic, rebar is always a good option to consider.
Do sidewalks need expansion joints?
A.: According to several industry sources, expansion joints, even at 50-foot intervals, are not necessary for the sidewalk project. Long stretches of concrete do not require intermediate expansion joints.
Is sand a good base for concrete?
Simply put, sand isn’t sturdy enough to work well as a subbase for something like a driveway. It is also difficult to maintain a level sand surface when pouring concrete, and therefore difficult to maintain a uniform thickness of the concrete slab.
Can you pour concrete over gravel?
Laying a concrete driveway over an existing gravel one is possible, but it is not generally recommended. However, if the gravel in your driveway is small enough, it is possible to create a cement driveway over the existing one.
Does ground have to be dry to pour concrete?
Civil engineer here. The concrete needs to stay wet in order to cure properly. As noted before, concrete doesn’t dry out to harden, it cures through a chemical reaction that needs water to facilitate the reaction. If the ground is dry, the ground will absorb moisture from the concrete and it won’t cure properly.
How many inches of gravel do you need for a concrete slab?
How Much Gravel Do You Put Under a Concrete Slab? You will need 3 inches of gravel under a concrete slab that is 4 inches thick. More gravel is better, but 3 inches is the minimum amount of gravel you should have with a 4” slab. Use ¾” washed and screened gravel, then compact it to level.
Is it cheaper to lay concrete or pavers?
As far as installation costs and concrete costs go, poured concrete is technically the most affordable per square foot. However, even though the upfront cost of pavers is higher, concrete pavers offer greater value and durability than poured concrete and stamped concrete.
How much does it cost to pour a 24×24 slab of concrete?
A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.
How wide should a sidewalk be?
Sidewalks should be wide enough to allow two adults to walk comfortably next to each other. A good standard width is 48 inches.
Is it cheaper to pour your own concrete?
Whether you’re pouring concrete countertops or a patio out back, it may be cheaper to pour concrete yourself rather than hiring someone. Whether you’ll save much in doing so depends largely on the amount of concrete needed and the amount of time you have to invest in your concrete project.
How many bags of concrete do I need for a 10×10 slab?
Regarding this, “how many bags of concrete do I need for a 10×10 slab?”, at 4 inches thick, generally you will need approximately either 74 bags of 60lb or 56 bags of 80lb premixed concrete for a 10×10 slab, at 5 inches thick slab, either 93 bags of 60lb or 70 bags of 80lb premixed concrete are required, while at 6.
Can you pour concrete alone?
Pouring a concrete slab yourself can be a big money-saver or big mistake. We show you the best techniques and tools so you get concrete forms right the first time.
