Table of Contents
How does a claw foot tub drain?
Source and drain lines come through the floor. In a typical clawfoot tub installation, both the water source pipes and the drain pipe enter the bathroom through the floor. Consult with a licensed plumber if you intend to install a clawfoot tub on the second floor of your home!Aug 21, 2013.
What size is a clawfoot tub drain?
Dimensions: Waste arm: 4-1/2″ long. Overflow arm: 14-1/4″ long. Drain flange: 2-3/4″ in diameter.
Does a clawfoot tub need AP Trap?
Not lavs. A claw foot tub has the p-trap below the floor. If you are using a slip joint waste and overflow, the theads are about at floor level which puts the slip joint nut accessible from above.
How heavy is a cast iron clawfoot tub?
All bathtubs are heavy, but clawfoot tubs tend to be especially heavy – particularly the cast-iron models. A cast-iron tub can easily weight 200-400 pounds while empty – fill it with water and climb in and you’re looking at several hundred pounds of weight.
How do I stop my freestanding tub from moving?
Carefully set the tub in position and adjust the tub feet as necessary until level. Once level, apply a generous bead of silicone on the bottom of the feet. This will prevent the tub from shifting after installation.
Do freestanding tubs have an overflow drain?
Some bathtubs, such as freestanding or clawfoot tubs, look better without an overflow drain. You can install a floor drain instead, so that any overflow gets drained away properly, instead of damaging your floors and potentially ceilings.
What do you put under a cast iron tub?
The cement backer board, the thin set mortar and tiles should secure it in place. If you put an underlayment on your floor, cut that to rest against the apron that will help as well. No thin set morter bed is necessary under a cast iron tub.
Are tub drain locations standard?
The position of the tub drain will vary, depending on the size and design of the tub, and you’ll need to cut an access hole in the floor at the drain end of the tub to allow for positioning and installing the drain line. This hole should be 9 inches wide and extend at least 12 inches from the wall.
How do you remove a cast iron tub drain?
How to Remove a Cast Iron Tub Directions Shut off the water supply to the tub. Open tub faucet to drain water remaining in supply lines. Remove screws securing the plate covering the overflow assembly. Work loose the lever hook and take it out. Take out the drain stopper.
Are all tub drains the same?
Bathtub drains are 1 1/2 inches wide and fit all standard bathtubs ranging from 14 to 26 inches deep. They are this size because they must fit the opening of the P-trap — also 1 1/2 inches wide — which is a special pipe that has a sharp bend in it.
Is AP Trap necessary?
Plumbing codes require a P-trap be installed anywhere there is an open drain line that expels wastewater into a drain waste-vent system. The P-trap traps solids that can clog the drain or sewer line.
Does AP Trap have to be directly under the drain?
The “P” trap SHOULD be directly under the drain, but no more than a few inches off center of it, if conditions require it. NO trap, TWO traps, and/or a 9 foot offset are NOT allowed and if he suggests any of them get a different installer who is a REAL plumber.
What can I use instead of AP Trap?
Bottle traps have a horizontal waste water exit with a lower half that unscrews to allow debris and clogs to be removed. Bottle traps take up less room under the appliance than P- or S-traps, making them appropriate for tight spaces. Thes traps catch the first and debris the same way as a p-trap.
How many gallons does a cast iron tub hold?
Alcove cast iron bathtubs are usually 60 inches long, hold 32 gallons of water, and weigh 320 pounds on average. Freestanding cast iron bathtubs are 60 to 75 inches long, hold up to 82 gallons of water, and weigh an average of 385 pounds; however, large ones can weigh up to 500 pounds.
Does a clawfoot tub add value to a home?
According to the RealEstate.com survey, starter homes with claw-foot tubs sold for nearly 30% more than expected. Coffered ceilings also helped homes sell for 30% more than expected, and farmhouse sinks (thanks Joanna Gaines) helped homes sell for 26% more than expected.
Can you scrap a cast iron tub?
If you have a cast iron sink or tub, it may very well be worth scrapping, especially if you can’t find some way of selling it to someone else. While you can find ways to repurpose a cast iron sink or tub, you may also need to get rid of it from your home.
Can you move a clawfoot tub?
There are three ways to move a clawfoot tub: hard, harder, or easy. To do it the hard way, load the tub on its side onto a furniture dolly. If you have to transport the clawfoot tub up or down a long staircase, this might be the only way to move it yourself.
How are freestanding tubs secured to the floor?
Once your floor is cleaned and dry, run a large bead of caulk around the bottom base of your bathtub and stand it upright. Run another large bead of caulk around the bathtub to fully secure it to the floor.
