Table of Contents
Why does my Whirlpool Cabrio keeps saying uL?
If uL (unbalanced load) appears in display, the load is out of balance. The washer is running a load-balance correction routine. If the dial is flashing and the washer has stopped, redistribute the load, close the lid, and press START/PAUSE.
Why does my Whirlpool washer keep getting off balance?
Laundry caught below the tub or between the agitator and the inner tub can cause the washer to operate off balance with every load. The problem can be anything: a penny that worked its way out of a pocket, a button that fell off a shirt or a wayward sock or other article of clothing.
Why does my washing machine keep going off balance?
The most likely culprit is the suspension rods. These rods help to limit the amount of side to side and front to back movement that happens when a washer enters the spin cycle. As these rods age, they no longer work as intended and need to be replaced.
Can you reset a Whirlpool Cabrio washing machine?
How To Reset Whirlpool Cabrio Washer: Turn the washer off. Turn the washer off and unplug it for 10 seconds. Finally, turn on the washer and it should now be reset.
Why is my washer drum loose banging around?
If your washing machine makes a loud rumbling or repetitive banging sound, which is particularly bad on a spin cycle, then it is most likely due to loose or worn out drum bearings.
Why does my washing machine make a banging noise when spinning?
Most of the time, washers make banging sounds because the drum is off-balance, but sometimes it’s the entire washer. If one of your washer feet is too short or on uneven ground, your washer may wobble during the spin cycle. This, too, can create a repeated clanging sound while not necessarily being caused by the drum.
Why is my washer banging when spinning?
All front-load washing machines have shock absorbers that are used to dampen the tub movement in the spin cycle. When shock absorbers weaken or become damaged, unbalanced loads will cause the washer to shake or move and the machine will often make a loud banging sound during the spin cycle.
Why won’t my Whirlpool Cabrio washer drain and spin?
The most common causes of a Whirlpool Cabrio not spinning are: Defective lid switch. Broken drive belt. Loose drive pulley nut.
What does uL mean on washer?
uL. (none) Unbalanced load. uL is displayed when the machine/motor control detects an off-balance load and remains on while the washer runs a mini-cycle to rebalance the load.
How do I know if my washing machine balance ring is bad?
The balance ring is filled with fluid. This fluid helps to dampen the vibration of the washer. If this fluid leaks out of the balance ring, the washer tub will vibrate and shake during operation. Check the balance to determine if is still filled with fluid.
How do I reset the control panel on my Whirlpool washer?
Follow these steps to reset a Whirlpool washing machine: Make sure the power to the washer is turned on at the wall, but keep the Power button on the control off. Hold the Program button down while simultaneously pressing the Water Level button two times. When done correctly, the control panel lights should illuminate.
How do you manually drain a Whirlpool Cabrio washer?
Find the “Pause/Cancel” button on the control panel. Press this button twice to drain the washer. Press the “Power” button and rotate the cycle selection knob to “Drain and Spin” to remove the remaining water from the load. Check the washer’s discharge hose if the water fails to drain from the washtub.
How do I get my washing machine drum back on track?
Check your washer for an unbalanced load. Turn off the machine, and open the door. Remove the clothing or other items from the washer, and redistribute them evenly around the drum — making sure their weight is redistributed evenly. Close the door, and turn on the machine again.
Why is my Whirlpool washer shaking?
Common solutions for: Whirlpool Washer vibrating or shaking. One or more of the shock absorbers might be broken or worn out. The shock absorbers dampen the vibration of the washer tub. If one or more of the shock absorbers are worn out, the washer will vibrate or shake.
Should a washing machine drum wobble?
Washers do tend to wiggle a small amount when the drum spins, especially during high-speed spin cycles. This can be considered normal, but it can also be unpleasantly noisy or shake nearby objects.
What is the life expectancy of a Whirlpool Cabrio washer?
It does not do more than the average 8 loads of laundry per week that whirlpool statistics suggests an average household does. Whirlpool also says the lifespan of a Cabrio washer is 11 1/2 years, that’s comical, if you’re easily entertained by bad jokes.
How do you fix UL?
UL is the code for unbalanced load. Open the lid and redistribute your wash to balance the weight of the wet items, then restart the machine. Repeat until the washer spins without thumping.
