Table of Contents
Conclusion – How to Reset Airbag Light Turn your ignition on and off. Restart your vehicle and do a test drive. Examine the passenger airbag switch. Inspect whether seat belts are fastened or working correctly. Verify that the passenger seat sensor is not applied. Use a scanner with an SRS or airbag light reset option.
What causes SRS light to stay on?
If the SRS light stays on or starts flashing on and off, you may have a problem with the airbags themselves, a loose wire, a faulty seat belt buckle, or a problem with the Engine Control Unit (ECU) that is causing the airbag warning light to stay on.
How much does it cost to fix SRS light?
What is typical cost to resolve an illuminated Supplemental Restraint System (SRS) Warning Light? Expect to pay between $100 to $200 for the initial diagnostic.
How do you reset the SRS airbag light?
How to Reset an Airbag Light Put the key into the ignition and turn the switch to the “on” position. Watch for the airbag light to turn on. It will stay illuminated for seven seconds and then shut itself off. After it shuts off, immediately turn the switch off and wait three seconds. Repeat Steps 1 and 2 two more times.
Can you reset airbag light without tool?
In some older cars, though, it is possible to reset the airbag light without a scanner by removing the car battery terminals. Check the wiring system underneath the driver or passenger seat for any loose wires or corrosion in the connector plug. Spray the connector plugs with an electronic cleaner and restart your car.
Can you drive with the SRS light on?
So is it safe to drive with an SRS light on? The answer would be no, Even though there’s a possibility that the airbags could still deploy with the light on it is a huge risk if one were ever involved in an accident. We recommend having a professional look at it and diagnose the issue to have fixed immediately.
Is it OK to drive with airbag light on?
When the airbag light illuminates, it means that there is a problem with the system. Most likely, the airbag will not deploy in an accident because of this fault. Therefore, it is not recommended that you drive the vehicle until you have the system repaired.
Will disconnecting battery reset SRS light?
Many air bag computers use non-volatile memory so even removing battery power won’t erase them. It takes a scanner to erase them. But even if you do erase it, whatever turned the light on to begin with will turn it right back on so you accomplish nothing.
Is it expensive to fix an airbag light?
Number 1 — Reset Airbag Light You’ll need to hire a professional to come in and examine the airbags before you continue to drive the car. This process can take several hours of time and usually costs a few hundred dollars, although depending upon the type of car it may be up to about $600.
Can I replace my airbag myself?
Repairing or replacing an airbag can be done, however it depends upon your level of technical ability, your confidence that you can adequately perform the repairs correctly and safely, and if your efforts outweigh the costs of taking it to a professional.
What is a SRS warning light?
The SRS warning light indicates a malfunction in the airbag system, front passenger occupant classification system or the seatbelt pretensioner system.
How do I turn my airbag light off?
How to Turn Off the Airbag Light Turn on the ignition switch with your car key. Wait for the airbag warning light to turn off. Turn the ignition switch of your car back off for a little longer than three seconds. Repeat steps 1 through 3 twice to make three times total.
Where are the airbag sensors located?
Usually, you have two airbag sensors located in the front of your vehicle behind the bumper. There is often also one airbag sensor installed inside of each door of your car.
What do you do when your service airbag light comes on?
The best thing to do if your airbag light has come on is to take the vehicle to a mechanic right away. A mechanic can help you to deal with the airbag light by examining the system with the help of the car diagnostic internal system.
What causes SRS?
Your SRS light might go on after an accident if the airbags did not deploy. When a collision occurs, the system was likely triggered through the crash sensors. However, if something malfunctioned, causing your airbags to fail, a fault will be sent to the computer.
How is SRS light diagnosis?
When the vehicle is first started, the SRS light should illuminate for 1 to 5 seconds while the system goes through a self-test sequence. If the light goes out, then the system is ready. If the light stays on, there is a fault somewhere in the SRS system. The system is disabled at this point.
What is an SRS malfunction?
SRS stands for Supplemental Restraint System. If this warning light stays on in your Mercedes Benz, that means that there is a problem with the airbags or the components that are part of the SRS system. While your car will run with this light on, it is important that you diagnose this problem as soon as possible.
Can a blown fuse cause the airbag light to come on?
Blown fuses can definitely cause the airbag light to come on. When the airbag system is malfunctioning, a mechanic or auto parts store should be able to read the code that the system is putting out which will give them a clue as to what particular problem the airbag is having.
