Table of Contents
Add a cup of vinegar to the cooler pan and let the vinegar cycle through the system for up to an hour. This will eliminate odors, mold, mildew and some corrosion, calcium deposits and other types of build-up. Repeat one to two times a season or as needed.
How do I stop my swamp cooler from smelling?
Pour two or three drops of tea tree oil or grapefruit seed extract into the water in the swamp cooler. These substances will help neutralize offending odors and prohibit the formation of mold and mildew that can form within the unit. Tea tree oil is very effective but produces a strong aroma that may offend some.
Why does my swamp cooler smell bad?
As you know, your swamp cooler works by using water to moisten your swamp cooler pads, so that as the air moves through the wet pad, it cools down the air while also adding some humidity to your home’s dry air. Because the pads use water, this can sometimes cause them to smell over time, much like a kitchen sponge.
Why does my swamp cooler smell like a swamp?
The cooling pads, which are typically saturated with water to produce cooling, may have developed mold and / or mildew. When the system runs, it may be emitting this fishy or moldy smell, as a result. This is especially common if you have been running the swamp cooler constantly, and water has been continuously used.
Why does my swamp cooler smell like wet dog?
If your swamp cooler smells murky or has a damp, stale odor, it’s time to replace the cooling pads. Over time, the pad material can develop mold and mildew, which emits a fishy or “swamp”-like smell. It’s also important to thoroughly drain and clean the water reservoir and replace it with fresh water before every use.
Can I put fabric softener in my swamp cooler?
You should use fabric softeners or essential oils added to the water sparingly to avoid possible health risks or damage to your cooler. A little hydrogen peroxide can prevent problems before they start. Never attempt electrical repairs on your own; call a qualified professional.
Will vinegar clean swamp cooler pads?
Vinegar works just as well, clean pads by combining water and vinegar in a 50-50 ratio solution. Note: Use Vinegar, but the smell can soak into your cooling pads and can be very difficult to remove. Once cooling pads have been thoroughly soaked, rinse thoroughly and then set them aside to dry.
How do you disinfect a swamp cooler?
Drain the water in the swamp cooler by opening the drain plug or siphoning with a hose. Brush the inside of the swamp cooler with a stiff-bristled brush or whisk broom. Use a wet/dry shop vacuum to remove the dust and dirt quickly. Pour the white vinegar into the water reservoir and allow to soak for an hour.
Can we put Dettol in cooler?
What to do if there is a bad odour coming from Air cooler? A: Best option is to drain water out completely & let the Air cooler dry for a day, but another solution is to add a 50 ml of dettol/ or any non corrosive disinfectant into water run it for 15 minutes & drain the water.
Can you put essential oils in a swamp cooler?
Add essential oils to the swamp cooler to eliminate odors. Swamp coolers can have musty smells. Mixing 15 drops of a scented essential oil, like lemon, lavender, or peppermint, or a mixture of essential oils can help make the swamp cooler smell better. Mix the essential oils with vinegar and place it in a spray bottle.
What can I put in my cooler to not smell?
How to Get Rid of a Bad Smell in Your Cooler Step One: Rinse out the inside of the cooler using a hose. Step Two: Scrub everything down with soap and water. Step Three: Mix baking soda and water and clean the inside of the cooler. Step Four: Soak a towel in lemon juice and clean the entire inside.
Why does my swamp cooler smell like it’s burning?
A burning smell coming from a cooling system can be just the smell of the new filter pads and should dissipate after a second cycle. However electrical, plastic or a strong rubber burning smell while cooler is ON is an obvious sign of serious electrical issue related to the fan motor, main control board or a capacitor.
Why does my water cooler smell?
When water is first introduced to the cooler the glue that holds the media together may emit an odor that smells offensive. This smell will go away after the media has been soaked well and rinsed. Run the pump long enough to wet out the pads and then dump the water. Repeat the process.
How do I prevent mold in my swamp cooler?
To prevent mold growth, you need to keep the moisture level under control. In many cases, you can leave another window open to reduce the overall humidity in the evaporative cooler and air. A HEPA air cleaner can clean the air if you do get mold in the unit. You’ll need to clean it before operating it again.
Why does my swamp cooler smell like skunk?
Methyl mercaptan is usually the culprit when it comes to gas that distinctly smells like a skunk. Once this gas gets into the air of your house, you and your family are at risk. The minute that you smell it you should get out of the house and call your gas company.
