QA

Question: How To Drain Pool With Hayward Pump

Can you use your pool pump to drain the pool?

Never use your pool pump to try to drain the pool. Inevitably, you will pull air into your suction line, the pump will lose its prime, and you will damage or burn up your pump. Always rent or purchase a submersible pump to drain the pool. After removing the old water, you can refill the pool with a garden hose.

Can I use filter pump to drain pool?

In some cases, you can get nearly all the water out with the filter pump, but normally you will be left with several hundred gallons at least, when using the pool filter pump to drain a pool.

How long does it take to drain a pool with a pump?

How long it will take to drain your pool will depend on the size of your pool, and how many gallons per minute the pump can move. But you’re probably looking at somewhere between 8 and 14 hours for your pool to empty.

Where are drain plugs on pool pump?

plug without an O-ring. Pool pumps usually have two pump drain plugs: one in the front, at the base of the hair and lint strainer or pump pot, and another plug further back toward the motor to drain the volute, or impeller housing.

Where are drain plugs on pool equipment?

Pool Heaters typically have 2 plugs, a drain plug in the front header and the rear header. Heat pumps usually have a small plug on the lower exiting pipe, but sometimes not, many are drained at the unions.

How long does it take to drain a 10000 gallon pool?

A 10,000 gallon pool will take about 14 hours to drain, the maximum rate recommended by the City of Phoenix.

What size is the drain plug on a Hayward pool pump?

Hayward Pump 1/4 Inch Drain Plug & Gasket SPX1700FG. Hayward Pump 1/4″ Drain Plug & Gasket fits all models of Hayward pumps.

How can I drain my pool without flooding the yard?

All you need is a medium-size water or vacuum pump. Unroll the pump’s intake hose so that it reaches the center of the pool (or as close to it as possible), and submerge it in the pool. Place the outlet hose so the exiting water doesn’t flood the area, but drains off away from the pool. Dry your hands thoroughly.

How long does it take to drain a 5000 gallon pool with a hose?

At 540 gallons per hour, it will take about nine hours to fill a 5,000-gallon pool with your 1/2-inch hose.

Where is the pool main drain valve?

The main drains are usually located on the lowest point in the pool, so the entire pool surface slants toward them. Most of the dirt and debris that sinks exits the pool through these drains.

What is the plug at the bottom of my pool?

A hydrostatic valve is a pressure relief one-way valve or “plug” installed usually at the deepest point of a swimming pool.

Does a pool pump need a disconnect?

A maintenance disconnect is required for shutting off power to pool or spa pumps, filters, and other utilization equipment. The disconnect must be installed within sight of the pool or spa but can be no closer than 5 feet from the pool or spa so that you cannot turn the power on or off while leaning out of the water.

How long does it take to drain a 4000 gallon pool?

Draining a pool can take up to 14 hours, depending on the size, so be sure to drain it on a day when you have sufficient free time. You need to be home to check on the pool, the hoses, and the pump frequently.

How long does it take to drain pool with garden hose?

The average outdoor spigot on a home can produce up to 12 gallons per minute. A small pool can be filled in a few hours, while a large one can take 14 hours.

What kind of pump do you use to drain a pool?

If you’ve ever needed to drain your pool, it’s likely you’ve already encountered a submersible pump. A submersible pump, as the name implies, operates while fully submerged in water. These pumps feature a lot of horsepower, and primarily drain the water safely from swimming pools and spas.

Should I drain my above ground pool and start over?

You may throw up your hands and decide the best course of action is to drain the pool and start over. In fact, draining a pool should be a last resort. Pools will need to be drained and refilled every 5-7 years on average, or if there is a major necessary repair. Otherwise, avoid draining your pool if at all possible.

How do you get a plug out of a skimmer?

How to Remove In-Ground Pool Skimmer Plugs Remove any debris or equipment from the area around the skimmer. Ensuring the area is clear prevents debris or other objects from falling into the pool lines. Unscrew the skimmer plugs from the skimmer hole. Pull the plug out of the skimmer hole.

Can I drain pool water on lawn?

Flooding Your Grass Is Not A Good Idea The problem with draining your pool in the yard, if permitted by your local water regulatory laws, is that it will quickly reach its saturation level and increase the risk of flooding your lawn, drowning the roots of your grass, and attracting mosquitoes.

Where do I drain my pool water?

The best way to drain the pool is to empty it directly into the sanitary sewer line outside your home. The process is simple but can be time-consuming, depending on how fast you are able to pump the water.

Can I use a shop vac to drain my pool?

Although you normally clean your pool with a manual pool vacuum or a vacuum device often called a “creepy crawler,” you can clean it with a standard wet/dry shop vac. The very big plus is the dirt and debris in the pool can be dumped directly into the grass, as opposed to sending it through the pool filter.

How long can a pool stay empty?

Knowing the construction of your pool will give you a better idea of how long you can leave it drained; some can be left empty for more extended periods, while other pools cannot be left drained for more than 15 minutes.