Quick Answer: How To Drain A Sundance Spa

Table of Contents

Where is the drain on my Sundance spa?

Draining Your Sundance Hot Tub The drain is located at either the front of the side panel or behind the front panel. To operate, remove the drain cover, attach your garden hose and pull softly to open or simply attach your hose to the interior drain line to allow the water to flow out.

How do I get my hot tub to drain?

There are three methods for draining a hot tub: through the drain spigot (a.k.a. drain plug), using a submersible drain pump, or with the help of a wet/dry vacuum. Before you start draining the tub, however, cut off the power supply so the jets and pumps can’t accidentally be during this procedure.

How do you quick drain a hot tub?

How to Use It. All you need to do is put the devices wand into the water and shake it to prime. Then use the wand end to quickly vacuum sand from the bottom of your hot tub. Quick drain does not require electricity and no set up is required.

How do you get water out of the bottom of a hot tub?

Drop one end of a long vacuum hose into the spa, and connect the other end to the wet/dry vacuum. Turn it on for a few seconds – just long enough to let the hose prime and get the flow moving. Turn off the vacuum, and quickly disconnect the hose so the water can flow out onto the ground.

How do you drain a Sundance Spa 880?

Simply remove the front panel and attach your garden hose to the drain and your hot tub will begin to empty. 880 & 980 Series hot tubs come equipped with the built-in Quick Drain feature, which comes with a thicker hose for faster drainage. Just attach the hose and turn the gate valve to begin draining your water.

How do you start a Sundance spa?

Once the hot tub water level is above the top of the highest jet, switch the power on to the hot tub (switch the GFCI breaker on to power up your hot tub). Use the temperature up button to select your desired temperature, and the spa will begin to heat up.

How long does it take to drain a hot tub with a hose?

Drain your hot tub. Depending on the size of your spa, it should take around an hour to drain using the hot tub’s drainage spigot, or ten minutes to drain with a submersible pump.

Where can I drain my hot tub UK?

Draining your hot tub is very quick and easy, you will need to use a garden hose and attach it to the bottom of the tub where there is a drain spout. You will need to make sure that it is attached firmly and tight to the Spigot, the water will then start to drain out of your hot tub once you have opened the Spigot.

How do you use a quick drain?

Simply insert, shake, vacuum and drain. No need to towel out debris. Comes fully assembled. Works without pumps or motors.

Can I drain my hot tub into a storm drain?

Do not discharge chlorinated water from your pool or hot tub into a storm drain.

How often should you drain hot tub?

Draining and refilling your spa will be an important aspect of spa ownership. Many spas need to be drained and refilled every three to four months due to chemical build-up.

Do all hot tubs have a drain?

There are two different methods of draining a hot tub, depending on your hot tub unit. Some hot tub units don’t have an exterior drain because they are prone to cracking and leaking water. In this case, use a standard hose to siphon out the water or run a sump pump to empty the hot tub.

Can you drain hot tub water on grass?

Spa water makes fine lawn water, as long as you open the cover and allow the chlorine or bromine level to drop to around 1 ppm. Your spa water should also be relatively well balanced, or at least the pH level should be below 7.8, and even 7.0 to 7.2 if possible, as most lawn grasses prefer a slightly acidic pH level.

Can you drain a hot tub into the street?

Water from pools, hot tubs, and fountains is NOT just water. You may never drain your pool water in the street or storm drain system, even if the water is dechlorinated. Federal, State, and local regulations prohibit discharge of anything but rain water in the storm drain.

Do you need to turn off hot tub before draining?

Step #2: Turn Off The Power Not only is it dangerous to work with this amount of water while connected to a power source, it is also bad for your hot tub if the system powers on while its empty. Turn it off and completely disconnect anything electrical before you start to drain the tub.

What happens if you drain a hot tub without turning it off?

Alternately, don’t drain it and leave it empty for extended periods. Water left in the pipes and equipment can grow bacteria biofilm, which is difficult to eradicate. Plus, without water, seals and gaskets become dry and begin to leak. Therefore, make sure to not leave your hot tub sitting empty.

How do I reset my Sundance spa?

Solution: Try turning off the spa for 1-2 minutes, then reboot. This allows ample time for the board to get a full reboot. If problem persists move to next. Temperature overheat, a dirty filter or low flow conditions.

What does Flo mean on Sundance spa?

FLO. Stands for Flow Switch. Means that the flow switch is malfunctioning or the flow of water is being inhibited. The heater is deactivated and filter/circulation may be deactivated, also. Check for clogged filter and proper water levels in the hot tub.

What mode should I keep my hot tub on?

Economy mode differs from standard mode in the way that it heats the hot tub. Rather than heating the water consistently to maintain your set temperature, economy mode will only heat the water during your scheduled filtration times. Simply put, economy mode reduces your hot tub energy costs by running your heater less.

How many hours a day should my hot tub filter?

In order to properly filter the water in a hot tub, suction side filtration systems need to run a minimum of 8 hours per day, with most requiring 12-24 hours per day. The longer these systems run for, the higher your energy costs become.

Should I Shock hot tub after filling?

It is a good practice to shock with dichlor when you refill your spa. After that, regular maintenance can normally be accomplished with non-chlorine shock. Other times for shock treatment include before or after heavy use and when the spa has been neglected.

How do you drain water from a hot tub?

To let the water out, you can drain the tub through the valve on the bottom of your spa. If your spa isn’t hooked up to a drainpipe, you can use a hose to drain the water. You can also use a submersible pump to speed up the process. Once drained, wipe your spa down and apply a non-foaming cleaner to the entire tub.

How do you drain a Peyton Spa Sundance?

How do you change the water in a Sundance spa?

How to Drain, Clean & Re-Fill Your Sundance Hot Tub Remove your hot tub’s filters. Remove your hot tub’s head rests. While the water is still hot, add 250ML (half a bottle) of Whirlpool Rinse. Turn your hot tub’s waterfall on. If your hot tub has Diverter Valves, turn them to the centre position.

How do you maintain a Sundance spa?

Part of the cleaning process is hot tub filter maintenance. Rinse the filter weekly, spray with a cleaner monthly, and soak the filter in a chemical cleaner every three or four months. Sundance Spas of Edmonton does provide hot tub services that take care of cleaning, we have a gold service and a platinum service.

Can you drain a hot tub with a garden hose?

Draining Your Hot Tub with a Hose When you have confirmed that the hot tub is off and the water is cool enough to handle, you need to connect the hose to what is known as the water bib. When you have flow going into your hot tub, you will need to turn off the water back at the hose bib.

How do you drain a spa with a hose?

Attach the hose adapter to the lower water pipe on the outside of the spa. Then, attach your hose to it, with the other end in a drain-off area as the water’s chemicals can harm grass, plants and flowers. Remove the lower stop cap from inside the spa and allow the water to flow out.

Where do you drain the water in a hot tub?

How Do I Get The Water From My Hot Tub To Where It’s Needed? Most portable hot tubs drain by gravity from a valve at the bottom of the spa that can connect to a garden hose. Using the hose, you can apply the water where it’s needed directly, however, it only works if you’re level with the hot tub or downhill from it.

How do you drain a hot tub wave?

As Wave inflatable hot tubs are portable, you can definitely use your spa all year round. Remove the plug from the electrical mains. Make sure the Spa floor drainage plug is in place. Open the water outlet at the Spa’s outer wall. Pull out the plastic plug in the Spa floor from the outlet and the water will flow out.

How do I drain the bottom of my hot tub?

To drain using the spigot: Turn the power to the spa off at the circuit breaker. Next, find your drainage spigot. Attach the garden hose to the spigot, being careful not to cross-thread. Open the ball valve on your spigot so the water can drain.

What do you do when your hot tub won’t drain?

Place the pump inside the tub. If your pump’s outflow hose isn’t long enough to reach a drain, attach a garden hose at the end of it. Turn the pump on and allow the spa drain. Once the hot tub is empty, turn off the pump, detach the hose and remove from the hot tub.

How do you take care of a Sundance spa?

Quarterly Replace your MicroClean® filter. Replace your SunPurity™ cartridge. Every 3-6 months, depending on usage, drain and replace your water. Clean your hot tub cover. This is an often-overlooked part of spa maintenance, but it is essential in order to extend the cover’s life and keep it looking good as new.