Table of Contents
Can I install recessed lighting myself?
If you have a nearby power source, you can easily install recessed lights by yourself. Bringing in a power source adds some time to the project, but this can be accomplished by wiring your own circuit or hiring an electrician.
How hard is it to put in recessed lighting?
It is more difficult to install recessed lights than traditional types. The process involves a lot of cutting out holes that are of the same size. The holes must be cut to precision, and on top of that they will have to be properly sealed to protect the lights.
Can you add recessed lighting to existing ceiling?
Thinking about adding recessed lights or pot lights but don’t want to tear out your whole ceiling to do it? Luckily you don’t have to. With a little ingenuity and special remodeling housings, you can install a roomful of recessed lights or canister lights with minimal drywall tear-out and patching.
How do I set up recessed lighting?
A good general rule for placement is to divide the height of the ceiling by two. The result is the amount of space to leave between each light. For example, recessed lighting spacing for an 8-foot-high ceiling would be 4 feet between each light. This will provide good spacing for general room lighting.
Do you need an electrician to install recessed lighting?
Yes, you need (sic) to hire a licensed electrican to install recessed lights in a ceiling. Yes, a person with good knowledge and experience in electrical work is able to preform the work.
How much does it cost to have recessed lighting installed?
Recessed Lighting Cost Expect to pay between $100 to $480 per fixture, or $360 on average, when having recessed lighting installed by a pro. At the average price, the project runs about $2,160 for six fixtures. The total varies depending on the type of housing, trim, and bulbs you select.
How many recessed lights can be on a circuit?
The main limitation to the number of recessed fixtures you can run at the same time is the rating of the circuit breaker that controls the circuit. Each fixture with a 60-watt incandescent or halogen bulb draws about 1/2 amp, so a 15-amp breaker for a standard lighting circuit would be able to handle 30 of them.
Should recessed lights be wired in series or parallel?
Parallel. White to white, black to black throughout. If you wire them in series, you will only get a dim glow based on the number of units you wire in.
Is recessed lighting outdated?
The one reason why recessed lighting is timeless because they offer the flexibility to change the finishes later. You have a can in your ceiling that stays forever. However, the finish may become outdated and can be purchased in different colors and styles to suit your needs. You can change them as often as you like.
Do you need a junction box for a ceiling light?
If you’re wondering how you install a light fixture without an electrical box, the short answer is that you don’t. You can’t install a light fixture without a junction box, but the fact that there’s no box at the spot where you want to install the light doesn’t mean you can’t install the light.
How many can lights for a 12×12 room?
The typical rule-of-thumb is 24″ from each wall, and then 3-5 feet between cans. So in a 12′ room you’d probably want two rows of lights. Considering it is a bedroom and you don’t need it as bright as a kitchen, you can probably get away with 2 rows of 4 lights for a total of 8.
How many can lights in a 20×20 room?
If you have a center light fixture, you should be able to use 4 inch line voltage cans or low voltage for supplemental lighting. I would go with at least 8 three inch cans for a 20 foot room.
How far away from the wall should recessed lighting be?
Keep your fixtures between 1.5 and 3 feet away from the wall. Space fixtures equidistant from each other. Place adjustable trim away from the wall.
Why is recessed lighting bad?
Used properly, recessed lights are sleek, unobtrusive fixtures that can be good problem-solvers. Used improperly, they can waste electricity, provide poor lighting and cause your heating and cooling bills to go up. Kitchens are common places where recessed lighting fixtures are used.
Does adding recessed lighting add value to a house?
Does recessed lighting add home value? Recessed lighting can absolutely add home value of you take the time to place them correctly and use the right light temperature for the room. There are also ways to make recessed lighting more energy efficient which is not a bad additional benefit.
Where should I put recessed lighting?
The common rule is that 4-inch fixtures should generally be placed at least 4 feet apart and 6-inch fixtures about 6 feet apart. Center recessed lighting fixtures in front of the objects you wish to light—a painting, bookshelf, or drapery panels, for example—and about 12 to 18 inches in front of that object.
How many recessed lights do I need?
A common rule of thumb is that you use one recessed light for every 4 to 6 square feet of ceiling space. Doing so provides even, overall illumination. This is an important rule to keep in mind when you are going to rely exclusively on recessed ceiling lights to illuminate your kitchen.
Can I daisy chain recessed lights?
Remember that you must run one ultra-thin extension cable (or run of low voltage wire) for each light. You can not daisy chain multiple lights together. Run your electrical wire from the switch/dimmer location to each driver.
Can you use 12 2 wire recessed lighting?
Yes, it is okay to use 12-2 cable to supply lighting fixtures. The other answer indicates that it even with 12-2 you have to use a 15A breaker for lighting circuits which is not strictly correct. If the entire circuit is 12AWG (other than fixture wires), then a 20A breaker may be used.
