Table of Contents
Can I insulate my attic myself?
For DIY attic insulation, you’ve got two choices: loose fill or batt (the common term for blanket insulation). Both can be added to uninsulated attics or layered over existing material. Once you’ve decided which type is best for you, examine the material options and prices to home in on the right product.
What is the best way to insulate an attic?
Many people consider fiberglass batt to be the best attic insulation. It consists of plastic reinforced by small glass fibers. The batt version comes in blanket form — i.e., small, pre-cut sections that you can lay down wherever you need to.
When insulating an attic what should be insulated?
1. In unfinished attic spaces, insulate between and over the floor joists to seal off living spaces below. If the air distribution is in the attic space, then consider insulating the rafters to move the distribution into the conditioned space.
Is adding insulation to attic worth it?
According to the Department of Energy, properly insulating the attic can save 10 to 50 percent on a typical heating bill. For many homeowners, insulating the attic is the most effective method to save on energy costs.
Can you lay insulation over electrical wires in attic?
Yes, you absolutely can. You can lay insulation around the junction boxes as well. Making sure that the insulation is of a fiberglass material will not only ensure a fireproof setup but also reduce airflow from the home through the attic.
How thick should the insulation be in an attic?
R-Value is a measure of insulation’s ability to resist heat flow. The higher the R-Value, the better the thermal performance of the insulation. The recommended level for most attics is to insulate to R-38 or about 10 to 14 inches, depending on insulation type.
Is rolled insulation better than blown?
The Differences Between Blown-in and Rolled Insulation The lower the R-value is, the less effective it will be as insulation – although it will be cheaper as well. In such situations, blown-in insulation is much more effective since it allows you to easily insulate those hard to reach areas.
How do you insulate attic in hot climate?
There are two main types of insulation used in attics. In a hot climate zone like southern Arizona, for example, we typically recommend blown-in fiberglass and radiant barrier. Blown-in fiberglass insulation provides a dense, effective barrier against heat loss that is also among the greenest insulation options.
Should you remove old attic insulation before adding new?
Expert contractors that specialize in insulation advise that removing old fiberglass insulation is best before installing new cellulose insulation because of possible mildew, mold, or rodent excrement. So, by have attic insulation removal service, you are getting rid of those possible issues.
Is R 19 insulation Good for attic?
R19 is better than R0. So, if this is the best you can do, go for it. However, most code ask for R21 in Wall, so this is certainly a pretty low value. The reason they ask/recommand for so much in the Ceiling is because it is generally easy to do.
Can you put batt insulation over blown in?
A: There’s no problem with installing fiberglass batts over your existing blown-in insulation. The reason for this precaution is that the facing on the insulation batts is a vapor barrier, which is intended to prevent moisture vapor from penetrating into the insulation.
How long does attic insulation last?
Unless damaged, it can last 80 to 100 years in most houses before it needs to be replaced. However, insulation can start falling from fiberglass batts after 15 to 20 years, so if your insulation was installed in batts well over a decade ago, it might be time for an inspection or a home energy audit.
How often should you replace your attic insulation?
Even though attic insulation is said to last anywhere from 80 years to 100 years, it does lose effectiveness as its ages. Insulation experts recommend replacing after 15 years to assure it is doing the job you need it to.
Can I run Romex through insulation?
Yes, it’s OK for electrical cables to pass straight through the insulation, mainly because life would become very difficult if this wasn’t permitted.
Does wiring go in front of or behind insulation?
Wiring should be installed before any insulation. When building a home, everything needs to be done in the correct order. For instance, after the framing is complete and the exterior walls have been put up, you need to consider the inside of the wall cavities before you drywall the interior.
Is it safe to use extension cords in the attic?
DON’T use extension cords to connect wires in the attic or above suspended ceilings/ANYWHERE. These are just accidents waiting to happen. These locations must have a receptacle mounted flush with the ceiling with the unit’s power cord visible at all times.
Is Cardboard a better insulator than Styrofoam?
It is the air pockets that do the insulating more than anything else, reducing conduction and convection. It has an R value of 0.65-0.7 which is better than cardboard, wool, fiberglass, straw bales, wood, bricks and glass.
Should I spray foam my attic?
“Open-cell foam can only be put in dark areas such as an attic or behind walls,” Harris said. Closed-cell spray foam is a better choice for keeping subfloor moisture at optimal levels, while open-cell spray foam is a better choice for walls and attics, because it allows homes to “breathe.”Dec 4, 2019.
