Table of Contents
How to Clean Vinyl Records Wipe gently. Remove all dust and static using a microfiber cloth, using very little pressure to avoid driving any particles further into the grooves in the vinyl. Rinse. Apply Simple Green solution. Damp-wipe clean. Dry. Spin and store properly.
What household items can you use to clean vinyl records?
Here’s what you’ll need: Warm water. Some people say you should use hot water, but there’s no real benefit to that. Dish soap (or record cleaning solution) Dish soap is the cheapest option, but it will leave a bit of residue on your records. Carbon Fiber Brush. Soft, Lint-Free Cloth.
How do you deep clean a vinyl record?
Keeping Vinyl Records Clean Remove dust and static regularly with a record-cleaning brush. Use anti-static sleeves to store your records. Examine your records to check for damage. Keep stylus clean. Remove dust and debris. Use a deep-groove record washer system. Use a liquid cleaning solution and brush.
Is it OK to clean vinyl records with alcohol?
Wash The Record In particular, we recommend avoiding any that contain isopropyl alcohol. While it will clean the muck off your record, many people report that over time it’ll also damage the protective coating on your vinyl. If you are going to use a solution with isopropyl alcohol – use is sparingly.
Is it OK to clean vinyl records with water?
Ideally, you want to use distilled water to avoid impurities from your tap getting into the grooves of the record. Try to avoid the label when cleaning with water. The brush helps remove dirt and impurities from the grooves of the record when you move it in a concentric motion, or along the same axis as the record.
Can you clean vinyl records with vinegar?
Sum everything up, the best way to clean the record is cleaning vinyl records with vinegar. It is very good for cleaning. I use white vinegar and distilled water 50-50 for many years, it gives an excellent result. I highly recommend this to all vinyl lovers.
How do you make your own record cleaning solution?
The exact mixture is one part isopropyl alcohol, one part distilled water, and one to two drops of dishwashing soap. This combination of fluids is widely recommended as an efficient mixture to clean records using what are household materials. The three ingredients were easy to measure and easy to mix.
How do professionals clean vinyl records?
How to Clean Vinyl Records Wipe gently. Remove all dust and static using a microfiber cloth, using very little pressure to avoid driving any particles further into the grooves in the vinyl. Rinse. Apply Simple Green solution. Damp-wipe clean. Dry. Spin and store properly.
Can you use wd40 on vinyl records?
WD-40 is a great vinyl record cleaning product. It does not contain any ammonia or alcohol, and it is a volatile solvent. After use, it will remove the dirt or dust, evaporate and leave behind a non-volatile lubricant. All you require is a lint-free cloth, the WD-40, and time.
Can you use glasses cleaner on records?
By all means laugh and deride but I have found Spectacle Lens cleaner (Specsavers Lens Bright) does an excellent job of wetting the disc surface and removing any trace of surface dirt. Judging from the playing after it also digs into those grooves too.
Can you clean vinyl records with Windex?
You can now proceed to use Windex. Remember, as it’s harsher than just water and soap, so only spray a little on the records. A few sprays will do as you’re going to spread the solution by using your microfiber cloth anyway. Wipe the records gently until the Windex dries up and polishes the records.
How do you restore old vinyl records?
Repairing a Scratched Record Gently wash your vinyl with water to remove any obvious debris. Grab a piece of 1500 grit sandpaper and wet it. Wet your vinyl as well and place it on a hard, flat surface. Lightly sand each side of the vinyl where there are scratches.
How do you get fingerprints off vinyl?
Follow these guidelines on how to clean vinyl records and you won’t have to worry about dust or fingerprints. Remove dust and static with a record brush. Inspect the record for visible blemishes. Spray cleaning solution on problem areas. Wipe clean using circular movements. Store vinyl records properly.
Will vinegar damage vinyl records?
It contains only acetic acid (about 5%) and water, with no additions that can be harmful to vinyl records. Dilute it with distilled water in the proportion of 50 / 50. Apply vinegar on the microfiber cloth, not on the disk surface. Wipe it with the cloth thoroughly.
How do you remove scuff marks from vinyl records?
Apply a thin line of epoxy or wood glue to the scratched area. Use a toothpick to ease into the crack and allow time for it to seep in thoroughly. If there are multiple scratches, apply glue to the entire record as it spins on your turntable.
How do you clean a moldy record?
Disaster recovery services recommend a mixture of one part isopropyl alcohol (rubbing alcohol) to three parts water. Spray this combination on a soft cloth, and carefully work it into the grooves of the record. Always work in the direction of the grooves.
Can you use dish soap on vinyl records?
3. Prepare a Cleaning Solution Using Dish Soap and Water. The ideal cleaning solution consists of one part distilled water, one part isopropyl alcohol, and a couple of drops of dish soap. This exact mixture is a tried and tested mixture to clean vinyl records with a DIY mixture that’s pretty easy to put together.
