Table of Contents
Steps 1Sweep away dirt and leaves. Brush the deck down with a soft broom to remove any dirt or leaves. 2Use a high pressure cleaner. A high pressure cleaner will wash away any remaining dirt. 3Mix the deck clean with water. 4Scrub the deck. 5Give it a high pressure clean. 6Enjoy your clean deck.
What is the best way to clean decking?
To avoid damaging your decking, create a gentle cleaning solution with warm water and liquid dish soap. Alternatively, you can use a speciality wood deck cleaner. Saturate the surface and scrub the deck with a stiff-bristled brush or sponge until the cleaning solution starts to lather.
What is the best homemade deck cleaner?
Add 2 cups of the bleach to two gallons of water. Pour in 1/4 cup of dish detergent and mix well until it suds. Use a broom or another large brush and cover entire deck. Scrub where there is stubborn dirt and grime and then rinse off.Once a Year Cleaning Water. Powdered oxygen bleach. Liquid Dish Detergent.
How do you clean a dirty wooden deck?
Sprinkle baking soda on affected areas of deck. Mix vinegar, soap, and water in a bucket, apply to one section of mildew-infested decking, and scrub with a brush until you see results. This method may have to be repeated for a thorough job.
How do I clean my deck without a pressure washer?
The recipe is pretty straightforward: Add half a cup of baking soda to one gallon of water; Mix in 1/8 of dish-washing detergent; Spray on your concrete deck and allow it to sit for half an hour; Scrub thoroughly and rinse with a hose. Apply a coat of concrete sealer to protect your deck from future stains.
Is it OK to pressure wash decking?
Typically, we’ll only recommend pressure washing your deck as a last resort – once all other options have been exhausted. The reason is pressure washing a deck may damage it. If you pressure wash and then put a sealant on before the wood is dried it can seal in moisture which will lead to rot and other problems.
Is it OK to jet wash decking?
A pressure washer is a straightforward machine that can clean very well with only water. However, it can ruin your deck if it’s not used properly. If you use it with too much jet pressure or place the tip too close to the surface of your deck, you can deeply etch the wood and cause the fibers to splinter.
Will bleach damage wood deck?
Cleaners containing Chlorine Bleach are commonly used to clean decks but they are not recommended for cleaning treated wood. Excessive use of chlorine bleach containing cleaners (sodium hypochlorite or calcium hypochlorite) can damage treated wood leaving it with an unnatural whitewashed appearance.
How do I naturally clean my deck?
Wash your deck with vinegar and water Mix 2 cups of vinegar into a gallon of water. Pour the water/vinegar mixture over your entire deck and let is soak for 10 minutes. Use a scrub brush and work your way across the entire surface of your deck. Rinse well.
How do I get green algae off my wood deck?
White distilled vinegar: White vinegar is a popular natural cleaner that can be used both inside and outside. Simply combine one gallon of water with one cup of white vinegar and scrub the deck with the solution to remove algae, mold, and mildew.
What is the best product to clean a wood deck?
BEST OVERALL: STAR BRITE Non-Skid Deck Cleaner & Protectant. ECO PICK: Simple Green Oxy Solve Total Outdoor Cleaner. BEST FOR MOLD AND MILDEW: Wet & Forget Moss, Mold, Mildew & Algae Stain Remover. BEST FOR OIL AND GREASE: Oil Eater Original Cleaner/Degreaser. BEST ALGAE CONTROL: CITRA-SHIELD EXTERIOR ALGAE CONTROL SYSTEMS.
Does wet and forget work on wood decks?
Simply dilute Wet & Forget Outdoor 5 parts water and 1 part Wet & Forget in a pump-up garden spray. For a large deck, connect the Wet & Forget Xtreme Reach™ Hose End product to your garden hose and attach the fan tip to apply to the entire deck in minutes. Then spray the wood deck. That’s it!.
Why does my deck always look dirty?
Letting leaves and dirt sit on your deck for long periods of time can lead to discolouration and encourage mould and rotting of timber decks. Use a soft-bristled brush or broom, and a deck wash or cleaning solution to scrub your deck’s surface – it’s important to choose one that’s appropriate for your deck.
Can I use bleach to clean decking?
Contrary to popular belief, chlorine bleach is not a great cleaner for a wood deck. Luckily, you can use powdered oxygen bleach to scrub down and clean your deck without damaging the deck’s wood or any surrounding plantlife.
Why you shouldn’t power wash deck?
Beware Pressure Washing Damage If you have timber deck boards, a power washer’s pressure may cause splintering and damage to the timber fibers. Depending on the material, a power washer can also scar boards if the pressure is too high. If the power washing becomes too intense, it can even chip the material.
What to do after you power wash your deck?
After you’ve power-washed the entire deck, rinse all of the wood with plain water to dilute and neutralize the stripper. If there’s still debris trapped between deck boards, such as leaves or twigs, remove it now (Photo 3).
What to use to clean deck before staining?
Deck cleaners, such as the Wood Deck Cleaner and Brightener by DeckWise or the TimberTech Deck Cleaner, will lift and remove any stuck-on grime from your wood deck boards. These deck cleaning solutions will soak down into the dry wood.
Do I need to sand my deck after pressure washing?
DO sand your deck before sealing. At that point, lightly sand the surface to remove splintery or fuzzy patches caused by pressure-washing the deck. Then seal the deck to protect from cracking, cupping, and warping.
