Table of Contents
Beginner’s Guide to Spa & Hot Tub Care Test and adjust your spa water balance 2-4 times per week. Clean the spa filter every 1-2 weeks, and replace annually. Keep the spa clean; drain and refill every 3-4 months. Air out the spa cover twice per week. Add water as needed to keep the spa full.
Is a hot tub hard to maintain?
Maintaining a hot tub isn’t difficult and it doesn’t require too much of your valuable time.
What do you put in a hot tub after every use?
Shock the spa using dichlor chlorine at a ratio of 1.5 tablespoons dichlor per 250 gallons. Test water with chlorine test strips, waiting until chlorine level has dropped below 5ppm before using the spa. After each use, add 1 tablespoon Oxy Spa per 250 gallons.
How often should you change hot tub water?
By draining and refilling with fresh water on a regular basis, you’ll ensure your hot tub is clean, clear and safe. But the question is: how often should you do it? With average use, your hot tub should be drained and refilled about once every three or four months.
How do you maintain a spa for beginners?
Clean the filter cartridges properly and regularly with chemical cleaners rather than just hosing them off. But take care with the chemicals; add them to the water rather than adding water to them. Let the filters cartridges dry before returning them to the spa.
Do hot tubs require a lot of maintenance?
In order to keep your hot tub in top-condition all throughout the year, you will need to maintain your tub properly. You will need to regularly balance your water, clean and replace filters, clean/drain/refill your tub, and make sure it stays protected in harsh winter months.
What chemicals are needed for a hot tub?
The basic chemicals for hot tub maintenance include a pH increaser, pH decreased, and sodium dichlor chlorine granules.
Is it OK to leave a hot tub empty in the winter?
In cold months, this water can freeze and do tons of damage. Water left in the pipes and equipment can grow bacteria biofilm, which is difficult to eradicate. Plus, without water, seals and gaskets become dry and begin to leak. Therefore, make sure to not leave your hot tub sitting empty.
How soon can you use hot tub after adding chemicals?
Do not use a hot tub right after you add chemicals. You should wait at least 2 hours before using the hot tub again. The chemicals need time to work their magic and sanitize the water. Also, a higher concentration of chlorine is best because you’ll need to add chemicals less often.
How do I keep my hot tub water crystal clear?
How to Keep Hot Tub Water Crystal Clear Get A Good Cover. Covering your hot tub when it isn’t in use is one of the best ways to keep dirt and other detritus out of the water. Shower Before Entering. Use A Skimmer. Keep Up with Your Water Testing. Add the Proper Chemicals. Empty, Clean and Refill. Clean and Change Filters.
What temperature should you keep your hot tub when not in use?
While it may sound like common sense to turn your hot tub down every time it is not in use, it’s actually better to maintain a constant soaking temperature, which is typically around 100° Fahrenheit for many people.
Can you put a chlorine tablet in a hot tub?
Chlorine tablets are a great way for you to keep your hot tub, pool, or inflatable spa clean throughout the year. They are a great choice because they have the ability to sanitize algae, bacteria, and other contaminants while also being affordable.
Why does my hot tub go slimy?
The most common cause of slimy water in your hot tub is a bacterial substance called biofilm. This is caused by bacteria that grow in the warm water of your hot tub. They can live in the piping of your hot tub, on interior surfaces, or in the filter.
Why is hot tub water cloudy?
Causes of cloudy hot tub water. When it comes to cloudy water, it’s likely one of a few culprits — high pH, high alkalinity, and low sanitizer. Dirty filters, body care products, and old water can also be responsible for cloudy water.
How long can I leave water in my hot tub?
If you do not want to put any chemicals in to your hot tub, no problem. But you must drain down and refill after each use and ensure that the water is never in the spa for more than 12 hours!.
How do I know if my hot tub has bacteria?
If your hot tub smells funky, there may be some bacteria lurking in the water—even if it looks clear and clean. Trust your nose and use your test strips to diagnose the problem. If your hot tub has a musty odor, this is a sign that there isn’t enough sanitizer in the water.
How do you shock a hot tub?
Measure 17g of non-chlorine shock per 1500 litres or 35g of chlorine shock per 1500 litres (consult the label instructions as this can vary based on chemical quality and brand). Carefully add the required shock to the hot tub. Leave the cover off for approximately 20 minutes.
