Table of Contents
Can I build a deck around my hot tub?
Yes. Many people build decks around their hot tubs. You will need to have access to the service side of the hot tub, which is usually the front. You can leave this area without decking or plan a service hatch that will allow for a service technician to easily access the equipment if needed.
Does a deck have to be reinforced for a hot tub?
Hot tubs, however, are very heavy, especially when filled with water, and chances are that your existing deck can’t safely support it without additional reinforcement. Fortunately, reinforcing your deck in preparation for a hot tub is a relatively easy task.
Will joist hangers support a hot tub?
Don’t use a ledger board or joist hangers when building a hot tub deck.
How much space do you need around a hot tub?
A good rule of thumb for a hot tub is to give yourself about a foot of space on each side of the tub. This leaves room for things like opening the cover. Most covers require at least 18 inches of space behind the tub as well as a few inches on the left and right side for the arm that helps you lift the cover.
How much weight can a 10×10 deck hold?
In short there’s no one right answer to “how much can my deck hold?” However, one rule of thumb to keep in mind while answering the question is that the answer commonly is that if a deck is properly designed, it’s built to hold 50 lbs. per square foot.
How heavy is a hot tub?
How much does a hot tub weigh? There is no single standard hot tub weight. In general, a small two- or three-person hot tub generally weighs around 500 pounds empty and 3,000 pounds when filled with water. A six-person model typically weighs approximately 1,000 pounds empty or 6,000 pounds full.
Can you put a hot tub on pavers?
Patio Pavers Are The Ideal Support For Hot Tubs But before you run out to the hot tub store, consider where you’re going to place it, and what you’re going to place it on. Once the pavers are in place, they will sweep hydrostatic sand into the joints, and you can set your hot tub up as they leave your driveway.
How much weight can a 12×12 deck hold?
A 12’x12′ (144sq’) deck properly supported can hold 5 760lbs on it. you build. All floating decks, in fact, all decks built to code, can support no less than 40 lbs per square foot of deck.
What is a floating deck?
A floating deck, also called a free standing deck, is simply a deck that’s not attached to any structure, including (of course) your house. Instead, you can put your deck’s structural members — posts, girders, and joists — on precast pier blocks set directly in the ground.
What is the best base to put a hot tub on?
Concrete Base This tends to be a common approach for hot tubs becuase it offers strong support for the weight and also keeps the area nice and clean. Concrete is solid, not overly expensive and is quite easy to lay.
Can 2×6 support a hot tub?
To use 2×6 you’ll probably need to be 8″ o.c. and the beams on 2′ centers, with piers @ 2′ centers… Hot tubs are no joke and 2×6’s should not be considered at ALL.
Does a hot tub have to sit on concrete?
A hot tub requires a stable surface — whether it’s a concrete slab, reinforced deck, or firmly compacted soil with crushed gravel. There’s also the option to have the hot tub installed in the ground but that still requires a concrete vault.
Do hot tubs need to be under cover?
A top quality spa, including every Hot Spring® spa, will come with a cover that should be used whenever the hot tub isn’t occupied. When your spa is left uncovered, heat escapes and its shell is exposed to the fading properties of the sun. So, it’s wise to invest in a hot tub cover lifter.
Can Neighbours complain about hot tub?
Ever been annoyed by an annoying constant sound? Bubbling hot tubs may not be for your neighbour and could be classed as a nuisance due to noise. Only cut back tree branches to the extent that they overhang your land. If you cut back into your neighbour’s property it is illegal.
Do you need access to all four sides of a hot tub?
Hot tubs need a minimum of 18 inches of access around all four sides so repair technicians can replace fuses, service the heating elements, and clean out debris from clogged jets. Some hot tub models are carefully designed so that only one or two sides require access for maintenance.
How do I know if my deck can hold a hot tub?
In general, most decks can withstand 100 lbs per square foot. So if a hot tub like the one in the example is under that weight, the average deck should be able to support it.
Can I use 2×6 for deck frame?
In general terms, joists spaced 16 inches on center can span 1.5 times in feet their depth in inches. A 2×8 up to 12 feet; 2×10 to 15 feet and 2×12 to 18 feet. 2×6 joists should only be used on ground-level decks that do not require, and will not provide for, any guards.
Can a deck hold 5000 lbs?
To determine the maximum load capacity of your deck, start by calculating its total area and multiply by 50 psf. So, a 100 sqft deck would be designed to support 5000 lbs.
Can a hot tub help you lose weight?
A daily soak in your hot tub can help you lose weight, even if it’s in an indirect way. If you weigh around 150 pounds, you can normally burn up to 17 calories or . However, you would need at least 125 days of 15-minute soaking sessions in the morning and evening to lose one pound of fat.
Can you put a hot tub on a wooden deck?
A hot tub on a deck is entirely possible, and it is possible your deck is already equipped to handle one. A deck designed to hold at least 100 pounds per square foot will support nearly any type of hot tub.
How long do hot tubs last?
The longevity of your hot tub is how long it will continue to work and last. The range of spas generally last anywhere from 5 to 20 years.
Does a hot tub need a ground rod?
No ground rod is required. Any electrical system should have one main ground point. If you ground your tub to a ground rod, then you will create a ground loop between your house groung and you ground rod.
How do I level my backyard for a hot tub?
Place a layer of gravel on the leveled spot. The thickness of the layer will depend on the size and weight of your hot tub, but a layer four to six inches thick should be adequate for most hot tubs. Extend the gravel out around the tub in all directions, to avoid having a muddy area around your hot tub.
Can I plug my hot tub into a regular outlet?
The 13AMP models often have plugs. These can be plugged directly into a standard household socket. Some of the higher end plug and play ranges operate at a slightly higher wattage and will require a 16AMP power supply. Most hot tubs require a 32AMP supply.
