Table of Contents
2 Cycle engine: The adjustment screw is on the side of the carburetor and is parallel to the ground. You can identify it by the lock nut at the base of the screw. Loosen this and turn the screw all the way into a soft seat, then back it out one and a half (1-1/2) turns.
Why does my ezgo backfire?
The Throttle May Not Be Closing Properly. A gas-powered golf cart utilizes a handful of different parts that help to keep the fuel flow smooth. When the fuel flow isn’t properly handled, there is a strong chance of a backfire affecting your cart.
Why does my golf cart only run with the choke on?
4 Answers. Dwight Coleman there are usually only a few possibilities if it only runs with the choke. One cause could be an air leak on the carb, head gasket, crankshaft seal. The other could be a clogged low speed and idle circuit.
How do I make my EZ Go gas golf cart go faster?
One way to increase the speed of EZ Go golf carts is to incorporate an octane booster when you fill the tank. The cart will have more pick-up, and it could gain as much as 5 mph. A different approach is to take out the throttle linkage governor on the carburetor.
How do I know if my golf cart solenoid is bad?
If your golf cart fails to turn on when you turn the key on, this is the most obvious sign of solenoid failure. The solenoid clicks a little with the ignition system in regular operation; in most cases, a failing solenoid will not snap.
What does an igniter do on a golf cart?
The ignitor boosts the signal and sends it to the ignition coil. The coil then creates the large spark that goes to the spark plug and fires the gas mixture in the cylinder. Ignitors can be the cause of a weak spark or they may fail completely and then the coil cannot create any spark at all.
How do you adjust the governor on a EZ Go TXT gas golf cart?
How to Adjust the Governor on a Gas E-Z-Go Golf Cart Locate the governor arm mounted on top of the rear axle case underneath the cart. Loosen the adjusting locknut on the end of the governor spring. Retighten the adjusting locknut.
How can I make my electric EZ Go go faster?
6 Ways You Can Make a Golf Cart Faster Add More Torque to Your Golf Cart. Upgrade Your Golf Cart’s Motor. Improve the High-Speed Controller of the Cart. Add Better Golf Cart Tires. Use a Higher Powered Golf Cart Battery. Watch the Weight in Your Golf Cart.
Why is my gas golf cart running slow?
Low Battery Usually, the most common reason golf carts slow down is when they don’t get enough power output from the battery. If the battery pack charge is very low and your cart is out of power, your cart will run slow.
How does a Yamaha golf cart fuel pump work?
The fuel pump has several nozzles on it to accept the vacuum line, and both the Fuel In and Fuel Out lines. Inside the pump, there are several diaphragms which use the pulsing action created by the vacuum of the crankcase pressure to draw fuel from the storage tank and push it onward to the carburetor of the golf cart.
How do you adjust the carburetor on a Yamaha golf cart?
Find the pilot adjustment screw on the edge of your carburetor. Pay attention to this screw – it should be a sharp point and not flat. Carefully remove this screw and then carefully screw it back. Turn this screw out one and one-half turns to adjust it properly.
How do I make my EZ Go TXT golf cart go faster?
Increasing the speed of your EZ Go golf cart can be done by reprograming your speed control at the dealer, upgrading your batteries, motor, or replacing your speed control. Upgrading these can increase your typical speed from 12 MPH to 19.5 mph or above depending on your modifications.
How do you remove the speed limiter on a EZ Go golf cart?
General Instructions Detach the cable from the carburetor. The cable is about the width of a straw. Follow the disconnected cable up to the governor. Disconnect the gas pedal cable from the governor and reroute it to the carburetor. Using your wrench, remove the bolt on the gas pedal shaft.
How can I make my 36v golf cart go faster?
How to Make a 36 Volt Golf Cart Faster Remove any unnecessary additions, racks or parts on your golf cart. Power-wash your cart. Check the shaft under the ignition pedal. Put larger tires on the cart. Replace any old or worn-out parts that are causing the cart to move slower than it should.
Where is the reset button on EZ Go golf cart?
Look in the area where several electrical wires enter the motor and locate a small red button. This is the reset button.
How do I troubleshoot my EZ Go golf cart?
Things to Keep in Mind Before Troubleshooting EZGO golf cart batteries aren’t perfect right away. Sticky accelerators are perfectly normal and can be fixed easily. Keep your cart stable. Make sure your charging wall socket isn’t faulty. Keep your tire pressure stable. Troubleshooting the speed controller.
How do I test a ezgo golf cart solenoid?
This can Also be tested by putting a test lead on each small terminal and pressing the gas pedal. The meter should read 36 V when the gas is pressed. If this voltage does exist when the gas pedal is pressed then the solenoid should click and engage.
