Table of Contents
What Is Code For Deck Railing Height? The International Residential Council (IRC) requires guardrails to be at least 36 inches high, measured from the deck surface to the top of the rail. Commercial decks attached to multifamily buildings need 42 inch high guardrails.
What is the best height for deck railing?
Deck stair railing should measure at least 34 inches high. The IRC specifies that deck stair railing should measure between 34 and 38 inches high, so homeowners may wish to use railing that is even higher than 34 inches for their deck stairs.
What is standard railing height?
(a) A standard guardrail shall consist of top rail, midrail or equivalent protection, and posts, and shall have a vertical height within the range of 42 inches to 45 inches from the upper surface of the top rail to the floor, platform, runway, or ramp level.
How far apart should deck railing posts be?
The structural integrity of the railing depends heavily on the posts that support the rail structure. These posts should be no farther apart than six feet on the flat deck and no farther apart than 5 1/2 feet on stairs.
How do you measure a deck railing?
Measure the distance between the corner posts of your deck with a measuring tape. If you plan to install railings on multiple sides of the deck, measure the length of each section you wish to rail.
What is OSHA handrail height?
The top rail must be at least 42 inches in height (§1910.29(f)(1)(ii)(B)) and the handrail must be 30 to 38 inches in height (§1910.29(f)(1)(i)) (as measured at the leading edge of the stair tread to the top surface of the rail).
Does a deck need a railing?
If your deck is below 30 inches, a railing is not required. With that said, if you choose to build a deck, even if it is only 24 inches off the ground, that is still high enough that even an adult could injure themselves.
What is the height of balcony railings?
The national building code and Madhya Pradesh Bhoomi Vikas Adhiniyam specifies the height of a railing in a balcony, lobby or roof-top to be 1.05 metres (3.44 feet) from the floor-level.
Can deck railing posts be 8 feet apart?
U.S. building code requires support posts for the rail structure to be no further apart than 6 feet on a deck with 4×4′ deck rail posts and no more than 8 feet apart for decks with 6×6′ deck rail posts. Posts should be no further apart than 5.5 feet on stairs.
Can I use 4×6 for deck post?
Size of the deck Most professionals will encourage you to consider going with a 6×6 deck post form the outset of the project. Decks that are going to be built higher than just a few feet off the ground will likely need something more substantial than a simple 4×4.
How far apart should 4×4 posts be on a deck?
For Building a Deck Railing, Deck Frame, or Fence The maximum spacing of 4×4 deck posts should be 6 feet on center, while the maximum spacing of 6×6 deck posts should be 8 feet on center.
How far apart should deck railing spindles be?
Balusters are the vertical guards that support the handrail. They must be installed close enough that the space between them is less than 4 inches. Most city inspectors carry a 4-inch ball with them to test the spacing.
How far should posts be on a deck?
Layout and Footing Locations In general, posts should be spaced no more than 8 feet apart. Some builders position them every 4 feet for a completely rigid frame. The maximum distance between footings is determined by the size of your joist material.
What distance should spindles be apart?
U.S. building codes mandate that balusters have no more than a 4-inch gap between them. This relatively tight amount of spacing still allows for visibility between spindles, but also stands as a safety measure to prevent small children from becoming stuck between spindles or from slipping through the balusters.
What is the minimum height for a safety rail?
Under 1910.23(e)(1), OSHA says that a guardrail must have a vertical height of 42 inches nominal from the upper surface of the top rail to floor, platform, runway, or ramp level. “Nominal” simply means that 42 inches has been established as the de facto standard for guardrail height. OSHA allows for variance, however.
How high can a deck be without a railing NSW?
The Building Code of Australia (BCA) advises that a handrail is required where there is the possibility of falling over one metre or more from a floor or building. In other words, a deck less than one metre (1m) above ground is not required to have a handrail, though depending on the height it may still be recommended.
Do I need a handrail on both sides?
Handrails are required on both sides of stairs and ramps. They are placed between 34 inches and 38 inches above the leading edge of a stair tread, the ramp surface, or the walking surface. Where children are the primary users of a facility, the ADA recommends a second handrail for children.
How many steps until you need a railing?
The building code does not refer to the number of “steps” but it does require a handrail when there are two or more “risers”. For clarification, a “riser” is the vertical portion of a stair. The “tread” is the top of a step. A two riser minimum would translate to two steps.
What accounts for roughly 90% of all deck collapses?
About 90% of deck collapses occurred as a result of the separation of the deck ledger board from the house, allowing the deck to swing away from the house. It is very rare for deck floor joists to break mid-span. Many more injuries are the result of rail failure, rather than complete deck collapse.
How many posts do I need for a 12×16 deck?
A standard deck will need four footings parallel to the house, but they will need to be temporarily braced by 6 inch-by-6 inch posts.
