Table of Contents
How much does a 12×12 concrete slab cost? The average cost to pour a 12×12 concrete slab that is 4” thick is between $888 and $1,584, with professional labor and materials included.
Is it cheaper to pour your own concrete?
One of the least expensive ways to get concrete is to mix your own. You can buy bags of the mix from a home improvement store. Typically, you only have to add water for it to be ready to pour. Otherwise, you risk getting a weaker concrete once it cures, which could lead to cracks or crumbles within a couple of years.
How do you estimate a concrete slab?
How to calculate concrete: Determine how thick you want the concrete. Measure the length and width that you’d like to cover. Multiply the length by the width to determine square footage. Convert the thickness from inches to feet. Multiply the thickness in feet by the square footage to determine cubic feet.
How much does a 10×20 concrete patio cost?
How Much Does a 10×20 Concrete Patio Cost? A concrete patio costs between $4 and $12 per square foot, including materials and labor. Based on those estimates, a 10-foot by 20-foot concrete patio would cost between $800 and $2,400.
How many bags of concrete do I need for a 10×10 slab?
Regarding this, “how many bags of concrete do I need for a 10×10 slab?”, at 4 inches thick, generally you will need approximately either 74 bags of 60lb or 56 bags of 80lb premixed concrete for a 10×10 slab, at 5 inches thick slab, either 93 bags of 60lb or 70 bags of 80lb premixed concrete are required, while at 6.
What is poor man’s concrete?
Soil-cement is a mixture of Portland cement, natural soil, and water used to form a hard, semi-rigid paving surface. It is most often used in highways or as a sub-base for asphalt or other forms of paving, but it can also be used as a cheap stand-alone paving surface for driveways, sidewalks, patios, or garage floors.
Can you pour concrete directly on dirt?
Long story short, yes you can pour concrete over dirt.
Is gravel needed under concrete?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.
How much area can one bag of cement cover?
How many square feet will a 60 lb bag of concrete do? @ 2″ thick a 60 lb bag of concrete will fill 2.7 sq. ft. @ 4″ thick a 60 lb bag of concrete will fill 1.35 sq.
How many 80lb bags of concrete make a yard?
One 80lbs bag of Quikrete Concrete Mix will yield approximately . 60 cu ft. So it will take 45 bag to equal one cubic yard of concrete. If you have a project over a 1/2 a cubic yard you should consider our Mix On-site Concrete especially if you are hand mixing.
Is it cheaper to lay concrete or pavers?
As far as installation costs and concrete costs go, poured concrete is technically the most affordable per square foot. However, even though the upfront cost of pavers is higher, concrete pavers offer greater value and durability than poured concrete and stamped concrete.
Do I need a permit to build a concrete patio?
Do I need a permit to build a concrete patio? The short answer is, ‘It depends’. If the concrete patio you’re building is on-grade (ground level floor) or less than 30 inches from the ground, you will most likely not need a permit.
Is it cheaper to pour concrete or build a deck?
Overall, a concrete patio will generally be cheaper to install compared to a deck. While your specific house and yard set-up may determine which is cheaper for your individual needs, a wood deck is likely to have a better return on investment compared to a concrete patio.
What is a cheaper alternative to concrete?
There are a few different types you can find in the home improvement store that can replace concrete cement used for driveways and walkways. These include pea gravel, crushed stone, and quarry process. Cheaper than other surface materials and low-cost to install.
How thick should a concrete slab be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.
How many square feet does a 50 lb bag of cement cover?
One 50-pound bag of Quikrete Fast Setting Concrete Mix yields about . 375 cubic feet. For example, if you need to cover 33.333 cubic feet, using 60-pound bags of concrete, divide 33.333 cubic feet by .
What are the alternatives to concrete?
19 Concrete Alternatives Bamboo. Maybe you didn’t see this coming or maybe you did, depending on which part of the world you live in. Steel. For starters, steel can be separated and has raw materials that are great for recycling. Wood. We all know this one. Straw Bale. Hempcrete. Timbercrete. Papercrete. Mycelium.
What is a good substitute for concrete?
Concrete: Cement Substitutes Pulverised Fuel Ash (PFA), aka ‘Fly ash’ as a cement substitute. PFA is a by-product of coal-burning power stations. Ground Granulated Blast-furnace Slag (GGBS) as a cement substitute. GGBS is a by-product of the iron and steel industry. Silica fume. Limestone fines. Alternative fuels.
How long do you leave forms on concrete?
The forms or “molding” that holds the concrete in place until it dries should be left alone for at least two days to ensure that the concrete is completely dry. If the forms are removed too soon, the concrete can begin to sag, crack and collapse, especially if conditions like temperature affected its strength.
