QA

Quick Answer: How Much Does It Cost To Install An Outboard Engine

How much does it cost to install a boat motor?

So if you are one of these lucky ones, your engine replacement will cost around $5,000 if you either want something smaller or get a good deal. $10,000 is the top of the range estimate you will have to pay in case you are looking for more power, and/or fancy one of the bigger manufacturer brands.

How much does it cost to change an outboard motor?

A typical rebuilt midsize outboard motor from the 1980s to 2000 between 90 to 115 horsepower will cost at least $3,500 if purchased from a discount dealer; it will likely cost around $4,500 if purchased from a local full-service dealer. Rebuilding your engine will cost around $2,500.

How long does it take to install an outboard?

Could be 2-8 hours depending on snags and how good he is. Removing an engine can take less than an hour, instlling can be a biotch or real easy. Most installs are $250-400.

How hard is it to install an outboard motor?

As long as you have an engine hoist or a chain hoist and a place to hang it, and then get a lifting ring to mount on the motor, it is easy. Just be sure to get a lifting ring to bolt onto the top of the motor to be able to lift safely.

Is it worth putting a new motor on an old boat?

On an older boat, it’s just smart to replace these items. Old instrumentation may not work with a new motor. Old controls may not work with a new engine. If steering components are worn or just old, it’s smart to replace them with new parts.

How much does an outboard motor cost?

Outboard motors can range from $110 to nearly $90,000 depending on power, make, model, and other factors.

How much does a 200 horsepower outboard motor cost?

Expect today’s best 200-hp outboard motors to have some weight, especially 4-stroke models. After 2014, just about any maker’s 200-hp outboard V6 engine costs upward of $20,000 installed, depending on your gauge package, controls, installation, etc.

Is it easy to swap outboard motors?

Swapping out old outboards isn’t as simple as you may think, but it’s worth the effort and expense to upgrade to high-tech digital motors. Swap your middle-aged outboards while they’re still firing on all cylinders. You won’t be buying just new engines, you’ll get new technology, too.

How much does it cost to have a new engine put in?

On average, you can expect to spend as little as $1,000 in labor for a drop-in replacement of a complete engine by your corner garage, to more than $4,000 if you pay a specialist to disassemble your old engine, assemble your new engine from the short-block, and then install it.

How much does a 150 hp outboard cost?

$15,305.00. There’s a good reason why the legendary Yamaha F150 is the best-selling 150-horsepower four stroke of all time. Powerful, light, nimble and compact, boaters know that its proven reliability is unmatched for everything from pontoons to flats boats to deep-V hulls.

How much does a 60 hp outboard motor cost?

$8,999.00. In Stock – New Honda 60 HP outboard Motor. 4-stroke with Electronic Fuel Injection (EFI). Unmatched maneuverability and convenience.

How many years does a boat engine last?

The average marine gasoline engine runs for 1,500 hours before needing a major overhaul. The average marine diesel engine will run for more than three times that long and log an average 5,000 hours under the same conditions.

How far should an outboard sit in the water?

If you have a short shaft motor, the top most part of the transom and the lower most part of the boat should be about 15 to 16 inches. For a long shaft, I think 20 to 21 inches is correct.

What happens when outboard is mounted too high?

Too high usually results in low water pressure, prop letting go in turns, or lack of bow lift are usually the telltale signs. Sometimes porpoising is caused by too much bow lift and dropping the motor will give it more bite and make it worse.

Can you put an outboard motor on a jon boat?

If you really want a bargain, consider repowering a used jon boat with a new Mercury outboard motor. These boats rarely wear out, and a new FourStroke Mercury motor from 2.5hp to 40hp will deliver easy starting, great economy and clean, quiet operation, season after season.

Is there a horsepower limit for boats?

Finally, the Capacity Plate will also indicate the maximum engine power for your boat, given in horsepower.Boat Capacity. Length x Width Max Horsepower 35 feet or less 3 36 – 39 feet 5.5 40 – 42 feet 7.5 43 – 45 feet 10.

Why do ocean boats have outboards?

The inboard designs for many also prove to be a fuel-efficient alternative. On the flip side, the outboard motor design maximizes the benefits of a directional thrust at the back of the boat, according to Outdoor Troop. This translates to increased power control, making loading and docking the boat much easier.

What is repowering an outboard?

Repowering a boat gives you the opportunity to upgrade related systems such as steering, throttle control, instruments and fuel components.

Why are outboard motors so expensive?

The boat engine (outboard) is expensive because they need to withstand the marine environment well, so all the parts used in making one are expensive stuff. And they don’t sell numerous motors all the time, so to stay in business, they need to make a profit, so the price of an outboard (boat motor) is high.

How much does a 100 hp outboard motor cost?

$11,999.00. New Honda 100HP outboard Motor. 4-stroke with Electronic Fuel Injection (EFI). Starting with VTEC technology on the BF100.

Is 400 hours on a boat a lot?

In fact, a boat with normal hours (50-75 per year) will often time run better than a boat with low hours. 400 hours won’t harm the resale value on a 2010 boat, but if a boat is a 2018 that is a different story.