Table of Contents
Ready-Mix Concrete Prices Item Average Cost Base Cost $119 – $147 per cubic yard Add For Delivery Over 20 Miles + $9.50 per mile Add For Less Than 10 CY Per Load + $53 per cubic yard Add For Saturday Delivery + $8 per cubic yard.
How much is a cement truck cost?
Concrete Delivery Cost by Type of Delivery Delivery Type Average Costs (Delivery Only) Truck Load $55 – $65 per truck Short Load $15 – $17 per cubic yard Tow-Behind $2 – $10 per cubic yard plus $150 – $200 hourly rate Mix On-Site $500 – $800 daily rate.
How much does it cost to pour a 24×24 slab of concrete?
A typical 24×24 garage slab costs between $3,057 and $5,944 with prices ranging from $5.31 to $8.31 per square foot for a 4” reinforced slab of concrete, and $6.83 to $10.32 per square foot for a 6” slab of reinforced concrete.
How many yards of concrete do I need for a 24×24 slab?
For example, for a concrete slab that is 24′ X 24′ X 4”, simply enter 4 in the Thickness/Depth field, 24 in the Width field, and 24 in the Length field. Click “Calculate”. Your answer should be 7.11 yards. Note: The Concrete Volume Calculator can also be used to determine yardage for aggregate products.
How much does it cost to pour a 20×30 concrete slab?
The average cost of a 20×30 concrete slab is between $2,400 and $4,800. The median price is about $3,600. However, the thickness of the slab and other features may increase or lower the cost.
How thick should a concrete driveway be?
As for thickness, non-reinforced pavement four inches thick is standard for passenger car driveways. For heavier vehicles, a thickness of five inches is recommended. To eliminate standing water, the driveway should be sloped towards the street a minimum of one percent, or 1/8 inch per foot, for proper drainage.
Why is concrete so expensive?
As more areas become industrialized—and as there grows a greater need for durable building materials to withstand severe weather and long-term wear—the demand for concrete has significantly increased. This alone has affected the price of concrete over the years.
How thick should a concrete slab be?
Standard concrete floor slab thickness in residential construction is 4 inches. Five to six inches is recommended if the concrete will receive occasional heavy loads, such as motor homes or garbage trucks. To prepare the base, cut the ground level to the proper depth to allow for the slab thickness.
How many yards of concrete do I need for a 10×10 slab?
The amount you will need for a 10 x 10 slab is 1.3 cubic yards, we always add an extra 10% to allow for any slab depth variations or spills that may occur.
How many 80lb bags of concrete make a yard?
One 80lbs bag of Quikrete Concrete Mix will yield approximately . 60 cu ft. So it will take 45 bag to equal one cubic yard of concrete.
How big is a yard of concrete 4 inches thick?
One Cubic Yard of Concrete: 4-inches thick – covers 81 square feet. 5-inches thick – covers 65 square feet. 6-inches thick – covers 54 square feet.
Is it cheaper to build on a slab or piers?
Concrete slabs can be constructed very easily and are cheaper than pier and beam foundations. However, you should know that repairing and maintaining a concrete slab can be more expensive in the long run than taking care of a pier and beam foundation.
How many sq ft does a yard of concrete cover?
How much concrete is in a yard? Concrete volume is measured in cubic yards. When poured on a perfectly level surface, one cubic yard will cover 27 square feet at one foot thick.
How much would it cost to pour a 30×40 concrete slab?
How much does a 30×40 concrete slab cost? The average cost is $4 to $8 per square foot. The median price is about $6 per square foot. Based on these averages, you may pay $4,800 to $9,600 with a median estimate of $7,200.
Do you need rebar for 4 inch slab?
The thickness of rebar should be no more than 1/8 that of the slab, so a 4” slab shouldn’t have steel greater than #4 or 1/2″ bar. It’s best to check with a Structural Engineer if your slab will bridge or cantilever. What is this? For 4” concrete slabs used for driveways and patios, #3 rebar is common.
Is 4 inches of concrete enough?
For a concrete patio, the ideal slab thickness is at least four inches. There are times where thicker slabs will make more sense, but, most of the time, 4 inches is the perfect thickness for a concrete slab. It is, however, wise to make the perimeter of the slab an inch or two thicker.
Do you need gravel under concrete driveway?
Whether you pour concrete for a walkway or patio, a strong gravel base is required to prevent the concrete from cracking and shifting. Gravel is especially important in clay soil because it doesn’t drain well, which results in water pooling under the concrete slab and slowly eroding the soil as it finally drains.
How many bags of concrete do I need for a 10×10 slab?
The thickness of your 10′ x 10′ slab will determine just how many bags you need. The average thickness of a 10′ x 10′ concrete slab for a shed is 4 inches thick. At 4″ thick, your 10 x 10 slab will take 56 bags of concrete that weigh 80 lbs.
Is it cheaper to use asphalt or concrete?
The cost of an asphalt driveway is typically cheaper than concrete, costing $2.00 – $4.00 per square foot. In contrast, a concrete driveway costs between $4.00 – $6.00 per square foot for a standard installation. Finishes, details and stains can increase the price tag to as much as $15.00 per square foot.
Is concrete cheaper than wood?
Because material costs for polished concrete floors are six to eight times lower than that of high-quality hardwood floors, polished concrete is significantly less expensive than wood in new residential construction. In 2022, a typical white oak floor install can range from $12 to over $22 a square foot.
HOW MUCH CAN 4 inches of concrete hold?
Typically we like to limit the weight to about 40 lb/sqft on an unknown 4″ slab. In most cases you can go to 80 lb/sqft in isolated spots, but unless you know roughly what the soil bearing and reinforcing is for that slab you might be looking at cracking.
How thick should concrete be for heavy trucks?
An 8-inch thick slab is almost always fine for a fully loaded concrete truck. A 7-inch slab can allow for around 60 to 80% of a full truck, whereas a 6-inch thick slab can only allow for 25 to 35% of a full truck.
How thick does concrete need to be to park a car on it?
The thickness for standard passenger car driveways is typically four inches of non-reinforced pavement. This allows for you to park your everyday family cars on it without fear of cracking due to weight.
